coalescer Equipment

570 Results found
Only show results in Virginia?
OK
  • Keyword: coalescer ×

Hilliard HILCO Hilcosep - Coalescer Separator

by The Hilliard Corporation - Star Systems Filtration Division     based in Elmira, NEW YORK (USA)

The Hilcosep was designed to remove moisture and particulate contamination from steam and gas turbine lube oils. Self-sufficient stand-alone models with reservoir capacity ranging from 2,000 gallons to 12,000+ gallons and portable models as well as custom designs are available.

Micro-LOKTM - Model JOS Series - Pleated Coalescing Filter Elements

by Jonell Inc.     based in Breckenridge, TEXAS (USA)

Micro-LOK JOS Series air/oil separator coalescing pleated elements are designed to coalesce extremely fine liquid particles down to 0.3 microns from a gas stream. Most commonly used to remove lubricating oil aerosols in a compressor discharge.

HQI - Model HD Q-PAC - Revolutionary Coalescing Media

by Hydro Quip, Inc. (HQI)     based in Seekonk, MASSACHUSETTS (USA)

HD Q-PAC is different from traditional corrugated type and inclined plate type coalescing media, and has the highest effective coalescing surface of any media on the market.

HQI - Model UNIPACK - Cross-Fluted Coalescing Media

by Hydro Quip, Inc. (HQI)     based in Seekonk, MASSACHUSETTS (USA)

Hydro Quip’s UNIPACK coalescing media is a cross-fluted type media, which is specially designed to provide highly efficient liquid/liquid and liquid/solid separation due to its high surface area to volume ratio.

Coalescer

by FAUDI GmbH     based in Stadtallendorf, GERMANY

Advantages: Large filtration area; high filtration capacity; long life-cycle. Area of application: For the filtration of aviation fuel as well as dehydration of oil and diesel. Flow rate: Various filter sizes and the modular design enable any required flow rate.

Coalescers

by Cadex     based in Kenmore, NEW YORK (USA)

An Oil/Water Coalescer is an effective solution for removing tramp oils and other non-emulsified oils from a waste stream. Coalescing is often an effective technology when used to improve an existing waste treatment system. Another effective use of a coalescer is to have it run continuosly on a rinse tank, cleaner tank, or coolant sump removing ...

AWAS - Model Galaxie Tower - Oil-Sludge-Separator/Coalescence Separator

by AWAS International GmbH     based in Wilnsdorf, GERMANY

The 3 stage separator for industrial use. The vortex separator AWAS Galaxie Tower combines the classic oil separator, coalescence separator and sludge trap. This solution is for maximum efficiency, safety and saving space – all in one component. Attention: oils will be automatically unloaded, as well as sludge. The compact design provides ...

Coalescing

by Water Energy SRL     based in San Pietro in Casale BO, ITALY

The REMOVAL Water Energy are used for the separation of mineral oils.The REMOVAL Water Energy are used for the separation of mineral oils, also in emulsion, present in water treatment. These systems exploit the system to coalescence (merging of two or more particles to form a larger one), are modular and manufactured completely in stainless steel ...

Model 795 - NX

by Perstorp     based in Perstorp, SWEDEN

NX 795 is an ester alcohol. It is a liquid. NX 795 is used as a coalescing agent for aqueous dispersions.

Fume Coalescer - Fiber Bed Equipment

by Beltran Technologies, Inc.     based in Brooklyn, NEW YORK (USA)

Performance: Submicron particulates are emitted at various points in many industrial and chemical process. Conventional scrubbers and other mechanical collectors depend on kinetic forces, requiring high-energy inputs to collect particles smaller than about 2 microns.

Model LOR Series - Coalescers

by Wastewater Engineers, Inc.     based in Oxford, MICHIGAN (USA)

Wastewater Engineers, Inc. is pleased to announce a breakthrough in Oil Removal technology. Our LOR and OR series of oil coalescers will remove up to 97% of free oil on a single pass. Engineering and design breakthroughs have provided outstanding performance and dramatic improvements in fluid management.

Coalescing Cartridges

by Darrell Hanna and Associates, Inc. (DHA)     based in Doctors Inlet, FLORIDA (USA)

Tiny droplets of water contact and adhere to strands of fiberglass. Flow pushes the droplets along the strand until they reach an intersection of strands where they combine with other droplets and (coalesce) into larger drops. These large drops are then carried to the outside surface of the cartridge. Having a higher specific gravity than the ...

contec - Borosilicate Microglass Fiber for Particle and Coalescence Filtration

by contec GmbH Industrieausrüstungen     based in Bad Honnef, GERMANY

Application: To separate dirt and aerosols such as oil and condensate from the gas flow From simple pressure loss to corrosive gases and hot gas application Filtration of solvents and other liquids.

Oil & Solids Separators - Small Packaged Units

by Baldwin Industrial Systems Pty Ltd. (BIS)     based in Cardiff, AUSTRALIA

Efficient Removal of “Free” Oil & Grease, Suspended Solids, Dust etc. Tough and compact. Modular plate pack. Specific design to prevent blocking. Various sizes and configurations. ‘Approved’ by most Australian Authorities. First Flush, storm by-pass configurations. Complete package systems, including Pumps, Level ...

Coalescence Separator / Coalescer

by Leiblein GmbH     based in Hardheim, GERMANY

The inclined lamella coalescer is used to separate tramp oil and solid particles from liquids. The coalescence separator can be made of steel (e.g. for cooling lubricants) or stainless steel (e.g. for decreasing baths).

Coalescing Systems

by Serfilco International Ltd     based in Irlam, UNITED KINGDOM

Liquid / liquid separation. Performance: 300-1500 gph

Oil Filtration And Reconditioning Systems

by Serfilco International Ltd     based in Irlam, UNITED KINGDOM

For renewal of: Hydraulic fluids / Lubricating oils. Cutting fluids / Oil & water based coolants. EDM - dielectric fluids / Synthetic oils. Performance: 180-600 gph.

Oil & Solids Separators - Large Designed Systems

by Baldwin Industrial Systems Pty Ltd. (BIS)     based in Cardiff, AUSTRALIA

System performance is simulated through the use of a proprietary computer program. This enables the effluent quality to be accurately predicted which means that we can meet discharge limits 100% of the time – GUARANTEED!

Coalescing Cartridges

by O I Filtration Ltd     based in Barlaston, UNITED KINGDOM

Our Coalescing cartridges can eliminate mists and particulates from Air / Gas applications. Several filter media options available up to 98% efficient down to 0.1 microns. We also offer media and core options that are compatible in equivalents with more aggressive chemistry.

Model CLS Series - Coalescer & Separator

by Nuen Process Technologies Inc.     based in Oakville, ONTARIO (CANADA)

CLS series housing has set the standard for reliability and performance on today’s liquid and gas process application. Our CLS series elements have continued to demonstrate and exceed all expectations in regards to liquid/gas coalescing and separation technologies.

Need help finding the right suppliers?

Let the XPRTs do the work for you