Only show results available in Texas? Ok

gas scrubber testing equipment

  • Premium

    Inciner8 - Venturi Scrubber - Gas Cleaning System

    For a less demanding, lower throughput gas cleaning system, the venturi scrubber is a well tested and respected design used by many industrial processes. It uses a combination of vortex technology and high pressure water misting to remove harmful elements from the exhaust gases.

    By Inciner8 Limited based in Southport, UNITED KINGDOM. from Pollution Control Systems Product line

  • Someflu - Model HV Series - Horizontal Plastic Vortex Pump

    The centrifugal pumps of the HV range are designed for pumping corrosive and erosive fluids. They are equipped with mechanical seal specially created for the highest industrial and technological requirements.

    By Someflu based in BAGNOLET, FRANCE. from Plastic Process Pumps Product line

  • Euromesh - Inlet Cyclones

    EUROMESH® Inlet Cyclones applies centrifugal forces to the fluid mixture, to achieve optimal degassing of the liquid. The incoming fluid mixture flows smoothly from the inlet pipe into the highly optimised tangential inlet zone, before entering the separation zone of the cyclone. This lessens the potential for droplet shatter and gently ...

    By Euromesh BV based in Sliedrecht, NETHERLANDS. from Separation Technologies Product line

  • Euromesh - Mesh Type Demisting Devices

    EUROMESH Mesh Type Demisting Devices typically consist of a spiral wound or layered construction of knitted wire mesh, which commonly is supported by either support screens (weldmesh) or a framework of support grating. They function as mist eliminators due to impingement of the liquid droplets onto the wire surface, as such to allow the droplets ...

    By Euromesh BV based in Sliedrecht, NETHERLANDS. from Separation Technologies Product line

  • Euromesh - Vane Type Demisting Devices

    EUROMESH Vane Type Demisting Devices are designed primarily for use in vertical and or horizontal vessels, and our wide range of vane profiles includes configurations for both horizontal and vertical flows. Vane Type Demisting Devices function as mist eliminator, as the agglomerated sheet of liquids flows into the trough type vanes and creates a ...

    By Euromesh BV based in Sliedrecht, NETHERLANDS. from Separation Technologies Product line

  • Euromesh - Mesh Coalescer

    EUROMESH Mesh Coalescer is used for liquid/liquid separation, when a mixture of two liquids are immiscible or non-soluble in one another. The Mesh Coalescer often consist of a combination of wires and fibers in order to create a maximum surface area for droplets to coalesce. In many cases the wires  are made of different material grades, ...

    By Euromesh BV based in Sliedrecht, NETHERLANDS. from Separation Technologies Product line

  • Euromesh - Mesh Agglomerators

    EUROMESH® Mesh Agglomerators are used in front of a Vane Type Demisting Device. It provides coalescence of the liquid droplets prior to engagement on the Demisting Device and substantially increases the separation efficiency by ensuring a high turn-down ratio of ≥ 10:1. Vane-type demisters are operating under much higher gas velocities than ...

    By Euromesh BV based in Sliedrecht, NETHERLANDS. from Separation Technologies Product line

  • Euromesh - Vane-Type Inlet Device

    EUROMESH® Vane-type Inlet Device is used in an oil/gas separator to direct the flow and absorb the flow momentum of incoming stream. The Inlet-device distributes the fluids evenly across the separator, minimise mal-distribution effects and avoid any chance on droplet shatter. Mal-distribution can be caused by a combination of localised ...

    By Euromesh BV based in Sliedrecht, NETHERLANDS. from Separation Technologies Product line

  • Euromesh - Plate-Pack Coalescer

    EUROMESH Plate-pack Coalescer is used for liquid/liquid separation, and it’s process is gravity driven. Additional separation aids are often required to  increase the separation efficiency, throughput and or reduce the size of the vessel. Many 3-phase (gas/liquid/liquid) or 2-phase (liquid/liquid) separators do incorporate a Plate Pack ...

    By Euromesh BV based in Sliedrecht, NETHERLANDS. from Separation Technologies Product line

  • GeneSys Evolution - Evolution Mass Spectrometer Systems

    Now in its eighth “incarnation” the GeneSys Evolution mass spectrometer systems offer full laboratory specification instrumentation with unrivalled flexibility, giving outstanding performance. All GeneSys systems are equipped with Enclosed Ion Source (EIS) technology, which offers significant improvements over other systems in terms of ...

    By European Spectrometry Services (ESS) Limited based in Northwich, UNITED KINGDOM.

  • Delatech - Model 858/859 - Exhaust Gas Scrubber

    The Delatech CDO 858/859 Exhaust Gas Scrubber has long been considered the standard for Advanced Chemical Vapor Deposition (CVD) Process gas abatement, and has been effectively used with all PECVD, LPCVD & MOCVD process gases.   Delatech scrubbers are also widely used in Thin Film processes. This versatile gas scrubber utilizes a ...

    By Critical Systems, Inc. based in Boise, IDAHO (USA). from Gas Scrubbers Product line

  • Purafil - Model Aluminum - Emergency Gas Scrubber

    The Purafil ESD Emergency Gas Scrubber (EGS) prevents toxic chlorine (Cl2), sulfur dioxide (SO2) or ammonia (NH3) gas releases due to a failure in the storage cylinder or system by providing immediate on-line removal of leaking gas from a room or building.

    By Purafil, Inc. - Filtration Group based in Doraville, GEORGIA (US) (USA). from Equipment Product line

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you