Moisture Sensor Equipment Near San Marino
-
Manufactured by Winet Srlbased in ITALY
Soil is a naturally heterogeneous system, which means small soil moisture sensors may not provide good enough answers to your soil moisture questions. The larger 10HS soil moisture sensor is better at averaging varying soil moisture and characterizing spatial variability because it averages soil ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
The Thetaprobe is also available in the form of a profile probe for use in thin-walled tubes that are installed in the soil. The profile probe is fitted with 6 measuring elements with a measuring range of 100 cm so that the soil moisture content can be measured at different depths within a vertical soil profile. The probe ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
The resistance to penetration is a means of determining the ground load-bearing capacity, and the ease with which roots will grow through the ground (important when agricultural, rural- and civil engineering techniques are involved). The resistance to penetration is a mechanical characteristic that, given a certain texture, depends on changing parameters such as degree of humidity, density and ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Soil moisture sensor SM150, measuring range 0...70% volume soil moisture. Accuracy +/- 3%. Measuring range temperature 0...-60 °C, accuracy 0.5 °C. With 2 measuring pins, length 51 mm. Output signal 0-1 Vdc. M12 connection, exclusive cable. Warranty 5 years. ...
-
Manufactured by Soilmoisture Equipment Corp.based in USA
The Model 5500 Salinity Bridge provides a means of measuring salinity values in the soil solution without continuous disturbance to the soil profile. The efficiency of measurement, both in the field and in laboratory setups, makes it possible to substantially increase the pace of scientific investigation and to observe dynamic changes in salinity values. Reads out directly in mmho/cm corrected to ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Soil moisture meter to read out the Thetaprobe, the W.E.T. sensor, the profile probe and the SM300 soil moisture sensor. With 25-way D socket. Inclusive operating instructions, PC software and RS 232 cable. ...
-
Manufactured by Soilmoisture Equipment Corp.based in USA
G-Blocks are the most cost effective method of tracking your water and subsurface moisture by electronic means. The blocks have been designed to provide the largest resistance range possible at the moist end of use, where sensitive plants need monitoring. The large gypsum content of the block provides months of buffering soil solutions to ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
The Eijkelkamp penetrologger CBR measures by a static penetration test directly CBR values using the standard CBR cone. The standard California bearing ratio (CBR) is a penetration test for evaluation of the mechanical strength of road subgrades and basecourses. The CBR is the basis for determining the thickness of soil and aggregate layers used in the design of roads and airfields. A ...
-
Manufactured by Soilmoisture Equipment Corp.based in USA
The Model 5910A Soilmoisture Meter is simple, relative scale designed for portable use in making rapid readings of Model 5201F1 Gypsum Blocks. Make measurements in a matter of seconds. Fits in a pocket and the standard batteries keep it going for years. A real easy solution for keeping track of soil moisture conditions in a vertical ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
The Thetaprobe is also available in the form of a profile probe for use in thin-walled tubes that are installed in the soil. The profile probe is fitted with 4 measuring elements with a measuring range of 40 cm, so that the soil moisture content can be measured at different depths within a vertical soil profile. The probe measures with an ...
-
Manufactured by NESA Srlbased in ITALY
Sensor for measuring air humidity at low consumption (Very fast response(combined version Temperature and Humidity(model ...
-
Manufactured by METER Group, Inc.based in USA
TEROS 11 soil moisture and temperature ...
-
Manufactured by METER Group, Inc.based in USA
Small-scale lysimeter with big possibilities: Measuring every parameter needed for a complete and accurate water balance can leave you making a lot of assumptions. Eddy covariance gives you evapotranspiration (ET) but leaves you guessing as to the fate of soil water. Traditional lysimeters measure water flux in the soil but have no connection to the groundwater, which means the soil column ...
-
Manufactured by METER Group, Inc.based in USA
Characterize variability without stressing your budget. The only accurate way to understand the amount of nutrients or chemicals leaching into the groundwater is to directly measure deep drainage. Large, controlled-tension weighing lysimeters are the most accurate way to make this measurement, but the considerable power and funding requirements of a weighing lysimeter plus the complexity of setup ...
-
Manufactured by METER Group, Inc.based in USA
When it comes to measuring thermal properties, there’s never been an instrument that gives accurate measurements under all conditions. Small sensors are fragile and face contact resistance. Large sensors and high-priced, steady-state methods, such as the guarded hot plate, require extremely long heat times, which drive moisture away ...
-
PremiumManufactured by Delta-T Devices Ltd.based in UNITED KINGDOM
The Moisture Meter type HH2 is a versatile readout unit for use with Delta-T Devices soil moisture sensors: the Profile Probe, ThetaProbe, SM300, SM150 and WET Sensor. The HH2 readout unit offers impressive functionality in a compact, hand-held unit, designed for field use. Readings are displayed on the LCD and can be stored to ...
-
PremiumManufactured by Delta-T Devices Ltd.based in UNITED KINGDOM
The PR2 SDI-12 Profile Probe builds on the reputation and field proven technology of the analogue PR2. By adopting the widely used SDI-12 interface (v1.3) the PR2 SDI-12 can be integrated with an even wider range of data loggers, sensors and equipment. SDI-12 is an established communication standard adopted by many manufacturers of ...
-
PremiumManufactured by Delta-T Devices Ltd.based in UNITED KINGDOM
Highly accurate yet easy to use: With the ML3 ThetaProbe Soil Moisture Sensor it’s easy to make reliable, accurate soil moisture measurements. Simply insert the soil moisture probe into the soil, connect to your data logger or readout unit, provide 5-14 V DC at 18 mA, and within seconds you can be logging soil ...
-
PremiumManufactured by Delta-T Devices Ltd.based in UNITED KINGDOM
No other soil moisture probe system enables you to monitor your soil water profiles with such ease and flexibility. Install an access tube into the soil, insert the PR2 Profile Probe and press the HH2 [Read] button to display an instantaneous reading, or connect the PR2 to a data logger (GP2 or DL6) and leave the system to record soil ...
-
PremiumManufactured by Delta-T Devices Ltd.based in UNITED KINGDOM
The GP1 Data Logger is a complete logging solution housed in a waterproof IP67 enclosure with battery power. The internal memory can hold >600,000 readings - more than enough for one year's operation ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you