multigas analyzer Equipment available in Turkmenistan

Available in Turkmenistan| Near Turkmenistan
75 Results found

We couldn't find any multigas analyzer equipment in Turkmenistan

Here is a list of results available in Turkmenistan

Current filtering criteria

You can remove a filter by clicking on the x
  • Keyword: multigas analyzer ×

  • Available in: Asia & Middle East ×

  • Available in: Turkmenistan ×

Cerex - Model UV 3000 F - Multigas Process Analyzers

by Cerex Monitoring Solutions, LLC.     based in Atlanta, GEORGIA (US) (USA)

Cerex UV 3000 F model analyzers are in use worldwide in process monitoring, indoor air quality, and mobile air quality laboratory applications. The UV3000 F features outstanding flexibility and is available with a range of fiber coupled cells, custom cross process adapters, and insitu mono-static probes. It is ideal for laboratory setups as well ...

Multigas IR Analyzers

by AppliTek NV - Environmental Analysis Division     based in Nazareth, BELGIUM

Our portfolio for CEM applications consists of compact analyzers designed for monitoring specific parameters in stacks, either extractive or directly on the stack. The universal system as desribed in this section is an extractive type of analyzer that can measure up to 10 gases simultaneously by IR gas filter correlation. The interface can ...

Multigas FTIR Analyzers

by AppliTek NV - Environmental Analysis Division     based in Nazareth, BELGIUM

When a large library of emission gases need to be monitored continuously, with high selectivity and low LOD, then AppliTek has the right solution. The Multigas FTIR analyzer system can be used to monitor either hot, wet or corrosive gases. Low cost of ownership and installation cost is guaranteed through multigas measurement with only one sampling ...

Multigas IR Analyzers (Ex Situ)

by AppliTek NV - Environmental Analysis Division     based in Nazareth, BELGIUM

Designed for CEM applications, this type of multigas IR analyzer shall be installed directly on the stack close to the sampling point (ex situ, in situ). Up to 11 gases can be monitored simultaneously with a short response time. The infrared gasfilter correlation principle eliminates cross-sensitivity from other gases, providing highly accurate ...

INCA - Model 3011 - Multigas Analyzers

by Union Instruments GmbH     based in Karlsruhe, GERMANY

The Multigas-Analyzers of the INCA3011 series are designed for indoor installation and the analysis of condensate-free sample gas with or without pre-pressure. The device can be equipped with up to 6 sample gas inlets and 1 calibration gas inlet.

INCA - Model 1021 - Multigas Analyzers

by Union Instruments GmbH     based in Karlsruhe, GERMANY

The Multigas-Analyzers of the INCA1021 series are designed for indoor installation and the analysis of condensate-free sample gas with or without pre-pressure. The device can be equipped with 1 sample gas inlet and 2 calibration gas inlets.

Model 4100 - Four-Stream Multigas Analyzer

by Servomex Co., Inc.     based in Sugar Land, TEXAS (USA)

The SERVOPRO 4100 is a high performing multigas analyzer designed to provide up to four simultaneous gas stream measurements of oxygen (control and purity), carbon dioxide, carbon monoxide, nitrous oxide, methane and trace moisture.  Specifically designed to address the needs of industrial and medical gas manufacturers, the 4100 can be fitted ...

SpectraExact - Model 2500 - Photometric Multigas Gas Analyzer

by Servomex Co., Inc.     based in Sugar Land, TEXAS (USA)

A highly flexible analytical solution adaptable to many applications, the SpectraExact (2500) range delivers a winning combination of proven performance and flexible operation in a resilient and reliable design.  The SpectraExact adapts to your process effortlessly to deliver a real-time online monitoring solution capable of single and ...

TAPI - Model 702 - Precision Gas Calibrator

by Teledyne Advanced Pollution Instrumentation (TAPI)     based in San Diego, CALIFORNIA (USA)

The Model 702 Precision Calibrator provides an ideal means of calibrating ambient air analyzers, in an economical, high-value manner.

TAPI - Model T703 - Ozone Photometer Calibrator

by Teledyne Advanced Pollution Instrumentation (TAPI)     based in San Diego, CALIFORNIA (USA)

The Model T703 is a microprocessor controlled ozone calibrator for precision gas analyzers. The Model T703 can deliver concentrations from 50 ppb to 5 ppm at flows from 1 LPM to 5 LPM.

TAPI - Model T700 - Multigas Dilution Calibrator

by Teledyne Advanced Pollution Instrumentation (TAPI)     based in San Diego, CALIFORNIA (USA)

The Model T700 is a microprocessor based calibrator for precision gas analyzers. Using highly accurate mass flow controllers combined with compressed sources of standard gases, calibration standards are provided for multipoint span and zero calibrations using up to 4 gas sources.

TAPI - Model T700U - Dynamic Dilution Calibrator

by Teledyne Advanced Pollution Instrumentation (TAPI)     based in San Diego, CALIFORNIA (USA)

The Model T700U is a microprocessor based calibrator for precision gas analyzers. Using highly accurate mass flow controllers combined with compressed sources of standard gases, calibration standards are provided for multipoint span and zero checks using up to 4 gas sources.

TAPI - Model T703U - Ozone Photometer Calibrator

by Teledyne Advanced Pollution Instrumentation (TAPI)     based in San Diego, CALIFORNIA (USA)

The Model T703U is a microprocessor controlled ozone calibrator for precision gas analyzers. Expanded ozone audit levels have created a need for precise ozone calibration well below the capabilities of standard calibrators. The Model T703U is designed to meet the requirements of ultra-low ozone production.

TAPI - Model T701H - High Performance Zero Air Generator with TCP/IP MODBUS

by Teledyne Advanced Pollution Instrumentation (TAPI)     based in San Diego, CALIFORNIA (USA)

The T701H adds Modbus TCP/IP connectivity to the proven reliability and performance of our high purity zero air system. This allows remote monitoring of key instrument functions including dewpoint status, scrubber temperature, box temperature and output pressure. Additionally, this digital access provides the ability to remotely disable the ...

TAPI - Model T701 - Zero Air System

by Teledyne Advanced Pollution Instrumentation (TAPI)     based in San Diego, CALIFORNIA (USA)

The T701 adds Modbus TCP/IP connectivity to the proven reliability and performance of our zero air systems. This allows remote monitoring of key instrument functions including dewpoint status, scrubber temperature, box temperature, and output pressure. Additionally, this digital access provides the ability to remotely disable the internal pump, ...

HORIBA - Model APMC-370 - Air Pollution Multigas Calibrator

by HORIBA Europe GmbH     based in Leichlingen, GERMANY

APMC-370 is designed to calibrate gas analyzers manually, remotely controlled or automatically. It is installed in air pollution monitoring stations, in laboratories for quality assurance and also in the production of gas analyzers.

TAPI - Model T700H - Source Gas Blending and Dilution Calibrator

by Teledyne Advanced Pollution Instrumentation (TAPI)     based in San Diego, CALIFORNIA (USA)

The Model T700H is a microprocessor controlled dilution system for calibration of continuous emissions monitoring gas analyzers. It enables significantly reduced cylinder use and cost while improving on-site flexibility for gas concentrations and converter efficiency checks. The instrument is designed to meet or exceed the performance requirements ...

Environnement S.A. - Model MIR 9000 CLD - New Compact Multi-gas Analyzer

by Environnement S.A     based in Poissy, FRANCE

Multi-gas Infra-Red GFC Analyzer (CLD-Chemiluminescence option). A unique analyzer for: NO, NO2, NOx, N2O, CO, CO2, SO2, HCl, HF, CH4, TOC and O2. Optional measurement of NOX by chemiluminescence.

Environnement S.A. - Model GRAPHITE 52M - Heated FID Total Hydrocarbon (THC, COV, CH4) Analyzer

by Environnement S.A     based in Poissy, FRANCE

Heated FID Total Hydrocarbon (HC) Analyzer. -MCERTs and TÜV certified -Complies with EN 12619 & 13 526 standards (with He/H2 fuel) -Fitted with FID for continuous and simultaneous measurement of Total Hydrocarbons (THC), Non-methanic Hydrocarbons (NmHC) and Methane (CH4) in compliance with EN 12619

Environnement S.A. - Model MIR FT - Multi-Gas Infra Red Fourier Transform (FTIR)

by Environnement S.A     based in Poissy, FRANCE

Multi-gas Infra Red Fourier Transform (FTIR). A single analyzer for the measurement of multiple gases: NO, NO2, NOx, N2O, CO, CO2, SO2, HCl, HF, CH4, TOC, NH3, H2O, O2.

Need help finding the right suppliers?

Let the XPRTs do the work for you