GW Environmental Industry Equipment In Europe
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
The durability and operational reliability of any automatic sprinkler system is highly dependent on its design for purpose and continued external and internal maintenance & testing. The real thread and “silent killer” of a pressurized wet sprinkler system is normally invisible to the eye, as it is located inside the pipe work. It is the highly complex interaction between ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
Water Pressure: 6 - 16 bar / Ceiling height: up to 5m / Nominal temp. rating: 68°C (155F) / Enclosure area: unrestricted / Spacing: max. 3,5m / Application density: min. 3mm/m2 / Non-storage occupancies: residential, offices, meeting rooms, hotels, museums, restaurant seating areas, schools / For additional information see: Products - Sprinklers Heads - LoFlow ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
This valve is the simplest type in the GW C-300 range of deluge valves. It is fitted with a manifold block with strainer and restrictors facilitating customized setting of opening and closing speeds. This valve will work as an on/off valve only. Actuation of the valve can be obtained by fitting an actuator (manual, pneumatic, hydraulic or electric) to control the water release from the sleeve ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
This valve is used where excessive uncontrolled pressure surges from the kick-in of fire pumps shall be avoided. The C-300 Pump Control valve is installed near the fire pump outlet, and is open in the stand-by position. When the fire pump starts, the full flow capacity of the C-300 Pump Control valve is discharged to drain. Immediately at pump start the C-300 valve pilot will monitor the pumped ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
This valve is both electrically & pneumatically actuated and provides pressure control. This valve is used where a constant downstream pressure and a controlled smooth opening and closing of the deluge water supply is called for. The valve's adjustable restrictors can be set to provide the opening- and closing speed desired, to prevent the damaging effects of reaction forces and water hammer. ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
The Metron Actuator allows the MJC to be activated by a electrical input as well as by heat. Metron Actuators (Type DR2003/C3) are designed to produce a high mechanical work output by ignition of a very small quantity of explosive which produces a high pressure gas forcing a piston to extend from the body of the device. They are electrically actuated and will operate within milliseconds of ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
The GW M2 Nozzles are water mist nozzles for protection of local applications such as in duct systems and engine bilges. The nozzles are suitable for spraying water mist, as well as water mist with foam enhancement. GW Sprinkler recommends the use of Angus Tridol AFFF foam when enhancement is necessary. Nozzles may be installed in the horizontal and pendent vertical ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
This valve is used where a controlled and smooth opening and closing of the deluge water supply is called for. The valve's adjustable restrictors can be set to provide the opening- and closing speed desired, to prevent the damaging effects of reaction forces and water hammer. The valve is fitted with an external pneumatic actuator to facilitate activation from e.g. pilot line air pressure drop. ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
In order to maintain the full extinguishing efficiency of the GW MisteryHood unit, the foam agent (AFFF) must be renewed after 5 years in service. The expiry year is marked / labeled on the canister outlet flanges (see page 2). For easy and seamless renewal of the foam agent, GW Sprinkler offers a complete Canister Replace-ment Kit, consisting of 2 fully fitted Canisters, including nozzles and ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
The DR2003/C35 Metron Actuator has the same high-end pyro-electric performance as the DR2003/C3. The difference is the cable. DR2003/C35 is fitted with Raychem Spec 44 round braid shielded & white jacketed, twisted pair cable. It has a dual wall construction which combines the outstanding physical and electrical characteristics of radiation crosslinked polyalkene with the excellent mechanical ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
This valve is designed to supply water at constant pressure to a wet automatic sprinkler system. It is typically used where zones with automatic sprinkles shall operate at a lower pressure than provided by the fire pump. The C-300 sprinkler valve has a built in non-return facility which prevents backflow if the valve inlet pressure suddenly drops. When the C-300 valve opens as caused by activated ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
This valve is used where a controlled and smooth opening and closing of the deluge water supply is called for. The valve's adjustable restrictors can be set to provide the opening- and closing speed desired, to prevent the damaging effects of reaction forces and water hammer. The valve is fitted with a compact integral pneumatic actuator to facilitate activation from e.g. pilot line air pressure ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
This valve is electrically actuated and provides pressure control. This valve is used where a constant downstream pressure and a controlled smooth opening and closing of the deluge water supply is called for. The valve's adjustable restrictors can be set to provide the opening- and closing speed desired, to prevent the damaging effects of reaction forces and water hammer. The valve is fitted with ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
This valve is used where a controlled and smooth opening and closing of the deluge water supply is called for. The valve's adjustable restrictors can be set to provide the opening- and closing speed desired, to prevent the damaging effects of reaction forces and water hammer. The valve is fitted with a compact integral pneumatic actuator to facilitate activation from e.g. pilot line air pressure ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
The GW Window Drencher is developed for wetting and cooling of vertical surfaces. It is fitted with a specially developed deflector which provides a vertical down and 15° reverse, wide spray that generates an evenly distributed water run-down on the vertical surface behind ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
This valve is used where a constant downstream pressure is required, irrespective of the fire pump pressure. The deluge valve is fitted with a pressure control pilot that constantly monitors the downstream pressure and modulates the C-300 valve elastomeric orifice to open and close and maintain the pre-set downstream ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
Low Pressure Water Mist Fire protection nozzle. FM tested with Bureau Veritas MED approval, CCS, Lloyds's Register, ClassNK, US Coast Guard and RINA. The GW M5 is a compact low pressure water mist nozzle specifically developed for use in total and local protection water mist fire extinguishing systems – both for marine and land based ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
This valve is used where a controlled and smooth opening and closing of the deluge water supply is called for. The valve's adjustable restrictors can be set to provide the opening- and closing speed desired, to prevent the damaging effects of reaction forces and water hammer. The valve is fitted with an external heavy duty solenoid valve to facilitate reliable electrical activation. The solenoid ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
The GW Mistery Hood Twin Nozzle System is a water-based foam enhanced extinguishing system for automatic fire protection of Commercial Deep Fat Fryers. The system is unique in its simple and reliable construction, its ease and low cost of installation and maintenance - and its extremely efficient extinguishing performance (typical extinguishing time is less than 30 ...
-
Manufactured by GW Sprinkler A/Sbased in DENMARK
This valve is used where a controlled constant pressure is required for a downstream wet system - e.g. water supply to fire hydrants. The valve provides an alarm signal via TP5 port when activated. The valve has no actuator. During set-up (commissioning) the downstream pressure is pumped slightly higher than the pilot set-pressure setting, which will lock the deluge valve closed. In case of a ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you