The IH091 grinder pump station consists of a pump and tank. The grinder pump, motor controls and level-sensing are integrated into a compact unit, easily removable for service.
Solids are ground into fine particles that pass easily through the pump, check valve and small-diameter pipe lines — even objects that should not be in sewage, such as plastic, rubber, fiber, wood, etc. The 1-1/4' discharge connection can be adapted to any piping materials that meet local code requirements.
The tank is made from tough, corrosion-resistant HDPE and offers 91 gallons of capacity. The IH091 was designed for use in one, average single-family home.
The grinder pump is automatically activated and runs for very short periods. Electrical consumption of the grinder pump is low -- a household that uses 250 gallons of water per day should use less than 10 kwhr per month to run the pump. (Actual water and power usage will vary.)
E/One grinder pumps do not require preventive maintenance and boast an average of eight to 10 years between service calls. If service is required, the unique, one-piece core eliminates the need for in-field troubleshooting and servicing — the pump core can be quickly pulled out and replaced, meaning minimal maintenance costs and inconvenience for the homeowner.
1 HP, 1725 rpm, high torque, capacitor start, thermally protected, 240 or 120 volt, 60 hertz, 1 phase
4' inlet grommet standard for DWV pipe. Other inlet configurations available from factory.
Pump discharge terminates in 1-1/4' NPT female thread. Can easily be adapted to 1-1/4' PVC pipe or any other material required by local codes.
- 15 gpm at 0 psig
- 11 gpm at 40 psig
- 7.8 gpm at 80 psig
US and foreign patents issued and pending.