OTT HydroMet - Model ADCON Pro10/2 - Wind Speed and Direction Sensors
From ADCON - Sensors
The ADCON Wind Sensor Set Professional is not only an extremely accurate set of sensors, it is also extremely robust, fully made of anodized aluminum, with no plastic parts. Both sensors have a very low onset speed, but can withstand wind gusts of up to 75m/s even at extremely low temperatures. Built to last, these sensors are fit even for marine applications.
Product Details
Wind Speed Sensor
The Wind Speed Sensor has a very low starting threshold of less than 0.4m/s, thanks to its superbly engineered low-friction bearings and its generously dimensioned aluminum cups. The rotating 3-cup unit can be replaced in the field. The sensor will measure speeds of up to 270 km/h.
Wind Direction Sensor
The Wind Direction sensor employs an accurate magnetic hall element. The vane is precision engineered, extremely robust yet light weight, and fully made of a combination of aluminum and stainless steel. Like the wind cups it is also easily field replaceable.
Both sensors require very little maintenance and will remain within their specifications for many years.
To properly mount the sensors according to WMO requirements the set comprises of an 80cm wide mast mounting arm, complete with mounting brackets. Each cable comes with its own Binder cable plus a separate Y-cable. This allows individual replacement of sensors in case of maintenance or repair, but still occupies only one connector on your ADCON RTU.
Both sensors are also available as individual units. If ordered separately they will be delivered with individual mounting arms and a 2m Binder cable.
Applications Areas
- Professional Weather Stations
- Agricultural Weather Stations
- Wind Power Stations
Technical Specifications
Wind Speed:
- Measuring principle: magnetic
- Measuring element: 3-arm cup anemometer, aluminum
- Measuring range: <0.4 ... 75m/s (1.44 ... 270km/h)
- Linearity: < ± 0.5m/s
- Starting value: < 0.4m/s (1.44 km/h)
- Output signal: 0 ... 2.5V DC
- Case: sea water resistant aluminum
- Temperature range: -40°C ... +70°C (non-icing)
- Mounting: Bores with diameter of 30mm at max. 10mm wall strength
- Weight: approx. 700g.
- Standards: VDI 3786, sheet 2 / WMO No.8
- Cable: Binder Germany, 1m, shielded, PUR
- Connector: Binder M9 male 7-pin
Wind Direction:
- Measuring principle: magnetic
- Measuring element: aluminum/stainless steel wind vane
- Measuring range: 0° - 360°
- Linearity: < ± 2.5°
- Starting value: < 0.4m/s (1.44 km/h)
- Output signal: 0 ... 2.5V DC
- Dead angle: 5° ± 1°
- Switching point: North
- Case: sea water resistant aluminum
- Temperature range: -40°C ... +70°C (non-icing)
- Mounting: Bores with diameter of 30mm at max. 10mm wall strength
- Weight: approx. 720g.
- Standards: VDI 3786, sheet 2 / WMO No.8
- Cable: Binder Germany, 1m, shielded, PUR
- Connector: Binder M9 male 7-pin
Customer reviews
No reviews were found for OTT HydroMet - Model ADCON Pro10/2 - Wind Speed and Direction Sensors. Be the first to review!