ToughSonic - Model 30 - Ultrasonic Sensors
The ToughSonic 30 ultrasonic sensor has a maximum range of 30 feet (9.1 meters). Like all ToughSonic sensors, it’s built for durability and ease of use in tough industrial environments. It’s fully immersible, corrosion resistant, shock resistant and all around tough. The 1.5 inch (38.1 mm) housing has 1.5 inch NPT threading on each end and a smooth middle section for a variety of mounting options. This sensor has a 9-wire cable that allows up to six simultaneous serial, analog and/or switch outputs. These workhorse sensors are used around the world in remote monitoring and demanding factory environments.
ToughSonic 30 Options
The ToughSonic 30 is available with one of the following Modbus serial data interfaces.
RS-232 Modbus RS-232 serial data interface
RS-485 Modbus RS-485 serial data interface
- Custom SenixVIEW configurations can be pre-loaded.
- Alternative cable type, length and connections are available
ToughSonic ultrasonic sensors are built Tough with:
- 1.88 inch (48 millimeter) type 316 stainless steel housing.
- Sealed epoxy potting for wet and dirty applications.
- Ruggedized piezoelectric ultrasonic transducer, potted in place.
- Hardened ToughSonic internal electronics.
- UV resistant, potted-in, 9-wire cable.
- Short and overload protected input / output.
Maximum Range 30 feet (9.1 meters)
Optimum Range 10 inches - 20 feet (25.4 cm- 6.1m)
Temperature -40° to 158° F (-40° to 70° C)
Humidity 0 to 100% operating
Protection NEMA-4X, NEMA 6P, IP68
Transducer Ruggedized piezoelectric
Compensation Temperature compensated
Resolution Digital: 0.0068 in. (0.172 mm); Analog:4099 steps (0-10 VDC), 3279 steps (4-20 mA)
Repeatability Nominal 0.2% of range @ constant temp. Affected by target, distance, environment
Update Rate 10 Hz (100 ms), SenixVIEW adjustable; affected by SenixVIEW filter selections
Voltage Output 0-10, 0-5 VDC or SenixVIEW customized; 10mA max
Current Loop #1 Current sourcing 4-20 mA or PC customized, max. loop 450Ω
Current Loop #2 Current sinking 4-20 mA or PC customized, max. loop 450Ω
Sinking Switch 150 mA max. @ 40 VDC max., teachable set point & polarity, fault indication
Sourcing Switch 150 mA max. @ input voltage, teachable set point & polarity, fault indication
RS-232, RS-485 Modbus protocol, 9600-115200 baud (selectable), 8 data bits, 1 stop, no parity
SYNC feature Permits up to 32 sensors to operate in close proximity without interference
Mounting 1.5 inch NPT thread, top or bottom
Attached Cable 6.5 feet (2 meters)
Total Weight 22.6 oz. (0.64 kg)