Codel International Ltd

- Model 102 - Cold Smoke Monitor (CSM)

From

0

The TunnelTech 102 Cold Smoke Monitor (CSM), is an essential part of any road (or rail) tunnel safety system, the CODEL CSM detects smoke from a fire to rapidly warn the operator of the hazard. Secondly, used in combination with other TunnelTech 101 VIS monitors, the operator can quickly detect the focus of the fire if it is also equipped with the optional PT 101 temperature sensor to accurately measure ambient air temperature in a range of -15 to 1050C.

Fully configurable analogue and alarm outputs are exportable to the tunnel data acquisition system to provide real-time cold smoke data. This data is also exported via the RS485 serial port along with the temperature data. This link delivers MODBUS RTU encoded data to a SCADA system located in the tunnel control centre and/or a local display module. In addition, the IP65 rated enclosure is constructed of a stainless steel and titanium alloy to resist attack from aggressive gases and road salt and to resist the effects of extreme heat.

In areas where extremely low temperatures may be experienced, optional transmitter and receiver insulation jackets are available to reduce the effect. Another option is a local display, driven from the RS485 output which enables operators to view output data, diagnostics and alarm setpoints.

  • Cold smoke detector for early detection of fires in road and rail tunnels
  • Optional, integral ambient temperature measurement for locating fires
  • Stainless steel enclosures to resist attack from aggressive atmosphere
  • Accurate optical attenuation technology
  • Optional Modbus RTU serial outputs

  • Gas Species Options: Visibility
  • Measuring units: K factor(M-1) or metres
  • Measurement Range: 0.020 – 0.070m-1
  • Ambient Temperature: -20°C to +50°C
  • Power supply: 24V DC
  • Construction: Aluminium enclosures
  • Analogue outputs: 1 x 4-20mA isolated current output, 500Ω maximum load, fully configurable
  • through TunnelMaster software.
  • Relay Outputs: 1 x volt-free SPCO contacts, 50V, 1A maximum load, configurable as alarm contacts
  • Serial Data: RS485 – Modbus RTU

Image

unnelTech Software

  • Easy installation and set-up Will operate on any Windows based operating system
  • User friendly Alignment Mode to aid initial set-up and optical alignment
  • Allows sensor configuration settings to be adjusted
  • Fault diagnostic logging for sensor troubleshooting

TunnelTech Software is supplied with all CODEL Tunnel Sensor’s as standard for the purpose of commissioning and maintenance of the sensors. With simple installation and set-up routine to any Windows based laptop PC, the program takes only minutes to load and configure and comes with a comprehensive on-board help feature.

The software enables the sensor’s complete data and control functions to be accessed via a PC using either an RS232 or optional RS485 communications box, also supplied with the sensor.

A built-in alignment feature aids the initial set-up and commissioning routine by giving a display of the detector signals to the engineer to ensure that optical alignment is maximised and the sensor operates to its optimal performance

Zero calibrations and span checking using a CODEL Check filter can be initiated via the software after commissioning or a maintenance period. Should it be necessary to alter the initial factory-set current and relay output configuration then this can also be carried out with ease.

For maintenance the software includes short-term logging and trending of diagnostic data for fault analysis.

Customer reviews

No reviews were found for TunnelTech - Model 102 - Cold Smoke Monitor (CSM). Be the first to review!