Morbark - Model 1600 - Tub Grinder
From Recycling Equipment
The largest tub grinder on the market, the Morbark 1600 Tub Grinder is able to power through and reduce materials from large land clearing or organic/wood waste programs. With an 11’2″ tub diameter, 15′ tub opening and a capacity of 20 cubic yards. With horsepower ranging from 1,050 to 1,200, this machine can power through tons of raw materials from large land clearing projects and organic/wood waste processing. The Morbark Integrated Control System (MICS) monitors key systems while maximizing performance. The remote control allows you to quickly adjust feed systems for top production rates and fuel efficiency. With laser-cut, factory-balanced hammermills and three 16″ diameter hydraulic augers to quickly move product, this tub grinder gives you optimum production.
Features
Allows the operator to quickly adjust feed systems to obtain maximum production rates while keeping engine load constant and fuel consumption to a minimum.
Hydraulic Augers
Hydraulic Augers
Durable, hard surfaced steel augers quickly remove product from beneath the mill. Pressure sensors on the auger system automatically slow tub rotation to prevent plugging.
Hammermill
Hammermill
Laser cut, factory balanced mill with forged hammers provides optimum grinding power.
Morbark Integrated Control Systems (MICS)
The ultimate diagnostic system; monitors hydraulic pressures, temperatures, clutch systems, tub rotation and engine efficiency while automatically adjusting to maximize performance.
General
- Length (transport): 49’8″
- Length (operating): 68’10″
- Height: 13’6″
- Width: 12′
- Gross weight: 101,080lbs.
- Axle weight: 59,920 lbs.
- Tongue weight: 41,160 lbs.
- Engine: CAT or Cummins
- Horsepower: 1,050 HP to 1,200 HP
- Fuel capacity (tank): 530 gallons
- Hydraulic oil capacity: 328 gallons
Discharge System
Three 16″ diameter augers discharging onto a 60″ x 34″ heavy-duty conveyor. Discharge height is 18″.
Tub
Tub has 11’2″ diameter at inside base, 60″ deep walls constructed of 3/8″ reinforced steel plate, and floor constructed of 1/2″ thick T-1 wear-resistant steel, supported by (16) roller guides carried on (8) 1-1/2″ diameter chrome shafts and (8) 2″ shafts.
90-degree full tilt tub for easy access to hammermill with hydraulically powered variable RPM forward and reverse tub control; Morbark Integrated Control System tub controlled with automatic reversing tub, sensor system.
Tub cover for debris containment
Engine gauge panel and emergency shut-down system.
Heavy-duty 12″ tube frame with hydraulic stabilizer legs
15′ diameter opening across the top
Hammermill and Screens
43″ x 69″ hammermill opening with heavy-duty 28″ diameter rotors, (16) 1-3/8″ thick 2-piece rotor plates keyed on an 8-1/4″ diameter rotor shaft with 5-3/16″ bearings, (8) 2-1/2″ hammer retaining rods.
Hydraulic Rod Pusher
Set of two 1″ thick steel heavy-duty screens
Discharging System
Three 16″ diameter augers discharging onto a 60″ x 34′ heavy-duty belt conveyor
Discharge height of 18′
Options
- Magnetized end pulley with collecting slide tray for ferrous metal removal
- Morbark automatic reversing fan system
- 11 HP auxiliary air compressor
- Air compressor guard
Customer reviews
No reviews were found for Morbark - Model 1600 - Tub Grinder. Be the first to review!