air filter bag Services | Environmental XPRT

Dental Labs

and facility they could be throwing out valuable precious metal scrap from the following items: Vacuum Bags,Air Filters,Rugs,Carpets,Sweeps,Casting Spruces and Buttons,Polishing Residue,Casting Spruce and Buttons,Towels / ...

By Arch Enterprises, Inc based in Mexico, MISSOURI (USA).

Primary (Continuous) Dusting

A continuous flow of dust out of the exhaust of the clean air plenum is considered a primary dusting problem. Other causes of this condition are as follows: Holes in the Filter Bags or Bags Incorrectly Installed – inspect the filter bag assemblies for holes, rips, tears, or excessive wear. ...

By Destex Inc based in Albany, NEW YORK (USA). from Troubleshooting Service line

Field Services

Performance testing, review, and analysis. System control and instrumentation start-up, check-out, and troubleshooting. Air pollution control system testing, balancing, and evaluation. Filter bag inspection, testing, and analysis. Operation and maintenance training. Installation ...

By Amerair Industries, LLC based in Woodstock, GEORGIA (US) (USA).

Secondary (Intermittent) Dusting

Puffs of dust that are noted in the exhaust of the clean air plenum after each cleaning pulse is a secondary dusting problem. This condition is normal with new filter bags, and should stop after the first several hours of ...

By Destex Inc based in Albany, NEW YORK (USA). from Troubleshooting Service line

Extremely Low Pressure Drop

for air leaks or blockage. Make sure that any dampers in the system are correctly positioned to allow air to flow through the dust collector. Leaks in the Housing – check the tubesheet and the dust collector housing for holes, cracks or loose gasketing that would permit air to bypass the dust collector or filter ...

By Destex Inc based in Albany, NEW YORK (USA). from Troubleshooting Service line

Planned Maintenance Service

In large capacity plants, which are on continuous operations, downtime of the plant and the down time cost are very critical due to the Air pollution equipments like ESP, Bag filters, Material handling Systems etc. The proven method for reducing downtime is systematic and planned maintenance to avoid ...

By Unicon Engineers based in Singapore, SINGAPORE.

Spray Drying Services

Spray drying is one of the most effective ways to dry foods and other products that are typically heat sensitive. It is a complex process that requires skill and attention to detail, which is why PacMoore is regarded as a leading spray dryer manufacturer and service provider. Below, learn more about spray drying and what PacMoore can do for ...

By PacMoore Products based in Hammond, INDIANA (USA).

Pollution Control Systems

Flue gases from furnaces and air from exhaust ventilation systems are thoroughly cleaned in a state of the art pollution control system. Flue gases pass through settling chamber, cyclone, cooling tower, bag house by induced draft and after that through scrubber to stack with forced draft. All equipments in the ...

By Magnabiz Corporation based in Gurgaon, INDIA.

Air Dispersion Modelling Services

Air emissions from stacks, bag filters and other air emission points can cause health and nuisance problems not only in the locality but sometimes 10's of km away. Air Dispersion Modelling can predict whether there will be problems with emissions from your site and help explore the effect of various ...

By Environmental Efficiency based in Bray, IRELAND. from Monitoring & Testing Service line

Subscribe to our eBulletins