Only show results available in Massachusetts? Ok

bag air filter services

  • Dental Labs

    Dental laboratories generate a significant amount of scrap when they manufacture precious metal bearing items such as bridges, crowns, implants, and other dental products. This scrap that comes in the form of precious metal shavings, shreds, and dust will accumulate over time. When labs clean their equipment and facility they could be throwing out ...

    By Arch Enterprises, Inc based in Mexico, MISSOURI (USA).

  • Air Dispersion Modelling Services

    Air emissions from stacks, bag filters and other air emission points can cause health and nuisance problems not only in the locality but sometimes 10's of km away.  Air Dispersion Modelling can predict whether there will be problems with emissions from your site and help explore the effect of various solutions.  Environmental Efficiency ...

    By Environmental Efficiency based in Bray, IRELAND. from Monitoring & Testing Service line

  • Stainless Steel Fabrication Services

    ACO SiccaDania is one of the most experienced stainless-steel fabrication workshop for dryers and evaporators worldwide. This experience has been very much focused on spray dryers, flash dryers, Zeta Dryers, fluid beds, tubular evaporators, process air supply units, heat exchangers, cyclones and bag filters. In addition to these, other ...

    By SiccaDania A/S based in Birkerød, DENMARK.

  • Installations Services

    ACO SiccaDania is one of the most experienced provider of installation services for dryers and evaporators worldwide. The expertise has been very much focused on spray dryers, flash dryers, zeta dryers, fluid beds, tubular evaporators, process air supply units, heat exchangers, cyclones and bag filters. Our team, however, has installed many other ...

    By SiccaDania A/S based in Birkerød, DENMARK.

  • Primary (Continuous) Dusting

    A continuous flow of dust out of the exhaust of the clean air plenum is considered a primary dusting problem. Other causes of this condition are as follows: Holes in the Filter Bags or Bags Incorrectly Installed – inspect the filter bag assemblies for holes, rips, tears, or excessive wear. Make sure that the filter bags were installed ...

    By Destex Inc based in Albany, NEW YORK (USA). from Troubleshooting Service line

  • Spray Drying Services

    Spray drying is one of the most effective ways to dry foods and other products that are typically heat sensitive. It is a complex process that requires skill and attention to detail, which is why PacMoore is regarded as a leading spray dryer manufacturer and service provider. Below, learn more about spray drying and what PacMoore can do for you.

    By PacMoore Products based in Hammond, INDIANA (USA).

  • Extremely Low Pressure Drop

    In addition to inspecting the filter bags for proper installation or holes or tears, the following items should also be considered: Pressure Gauge Working - check the differential pressure gauge and the tubing leading to the dust collector. Ductwork, Dampers – inspect the ductwork to and from the dust collector for air leaks or blockage. ...

    By Destex Inc based in Albany, NEW YORK (USA). from Troubleshooting Service line

  • Secondary (Intermittent) Dusting

    Puffs of dust that are noted in the exhaust of the clean air plenum after each cleaning pulse is a secondary dusting problem. This condition is normal with new filter bags, and should stop after the first several hours of operation.

    By Destex Inc based in Albany, NEW YORK (USA). from Troubleshooting Service line

  • Field Services

    Performance testing, review, and analysis. System control and instrumentation start-up, check-out, and troubleshooting. Air pollution control system testing, balancing, and evaluation. Filter bag inspection, testing, and analysis. Operation and maintenance training. Installation supervision.

    By Amerair Industries, LLC based in Woodstock, GEORGIA (US) (USA).

  • Planned Maintenance Service

    In large capacity plants, which are on continuous operations, downtime of the plant and the down time cost are very critical due to the Air pollution equipments like ESP, Bag filters, Material handling Systems etc. The proven method for reducing downtime is systematic and planned maintenance to avoid unexpected breakdowns. Planned maintenance ...

    By Unicon Engineers based in Singapore, SINGAPORE.

  • Pollution Control Systems

    Flue gases from furnaces and air from exhaust ventilation systems are thoroughly cleaned in a state of the art pollution control system. Flue gases pass through settling chamber, cyclone, cooling tower, bag house by induced draft and after that through scrubber to stack with forced draft. All equipments in the dust collection system have to be ...

    By Magnabiz Corporation based in Gurgaon, INDIA.

  • Fitting and Installation Services

    Fitting filters is a dirty job, ideally you need someone who is experienced at this and can work quickly and cleanly. We are experienced in the fitting of all types of filters, from filter bags & sleeves in dust extraction systems, replacing air filters in air intake systems and replacing paint filters in spray-booths. We also re-fit filter ...

    By Scottex Precision Textiles Ltd based in Bury, UNITED KINGDOM.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you