We couldn't find any catalytic oxidizer services suppliers or service providers located in Micronesia

Here is a list of services results with suppliers serving Micronesia

catalytic oxidizer Services available in Micronesia

  • Catalytic Oxidation Services

    The oxidation of the pollutants takes place using a catalyst, which greatly reduces the activation energy required for the completion of the reaction. The plant can be equipped with a conventional heat recovery section (recuperative catalytic oxidation) or regenerative type (with the use of ceramic materials), optimizing in this way the energy ...

    By BROFIND SPA based in Milano, ITALY.

  • Premium

    Fluid Catalytic Cracking (FCC) Processes

    In Fluid Catalytic Cracking (FCC) processes, widely used in oil refineries, the separation and recovery of powder catalysts is a major concern. Particularly, the concentration of catalyst after the FCC regenerator is usually over 150 mg/Nm3. Since these levels of emissions didn’t represent any environmental harm in the past, they were not ...

    By Advanced Cyclone Systems, S. A. based in Porto, PORTUGAL. from Powder Recovery Service line

  • Premium

    Structured Media Care Program Services

    Structured media beds can often be plugged by inorganics or particulate that is difficult to remove with a bake-out, vacuuming, or basic flush. To help maintain the peak performance of regenerative thermal oxidizers and regenerative catalytic oxidizers, B&W MEGTEC offers a high-volume chemical cleaning system solution that can help restore ...

    By Babcock & Wilcox MEGTEC LLC based in De Pere, WISCONSIN (USA).

  • Premium

    Catalyst and Carbon Testing Services

    Your entire operation can depend on the performance of your pollution control system. It pays to be sure your catalytic oxidizer or carbon adsorption system is ready to do its job. When your catalyst or carbon needs replacement, we work with your staff to determine the best solution for your specific application.

    By Babcock & Wilcox MEGTEC LLC based in De Pere, WISCONSIN (USA).

  • Selective Non-Catalytic Reduction

    Selective Non-Catalytic Reduction (SNCR) offers a lower-cost method of reducing nitrogen oxides than Selective Catalytic Reduction. For smaller or older power plants, SNCR is the NOx control installation of choice. It can also sometimes be an interim technology before an SCR can be installed. Although the removal efficiency is between 25 and 35%, ...

    By STEAG Energy Services LLC based in Kings Mountain, NORTH CAROLINA (USA).

  • Catalytic Converter Recycling Services

    Autocatalyst is a part of the vehicle used for both decreasing the fuel consumption and the amount of hazardous chemical gases produced during the burning process.  Autocatalysts basically provide a cleaner exhaust gas release and also include valuable metals such as platinum, palladium and rhodium in different amounts; which change as per ...

    By Evciler based in Altındağ - Ankara, TURKEY.

  • Increasing Capacity of Thermal Oxidizers

    Many companies experience growth and often outgrow their existing Thermal Oxidizers. Looking towards the future, often companies want pollution control equipment that would be capable of managing future expansion. Gulf Coast Environmental Systems engineering team can design equipment to utilize your existing equipment that you are familiar with.

    By Gulf Coast Environmental Systems, LLC based in Conroe, TEXAS (USA). from Onsite & Remote Service Service line

  • Media Change-Outs Services

    Regenerative Thermal and Catalytic Oxidizers (RTOs & RCOs) will experience over years of operation reduced air flow capacity, channeling or voids in the media bed, thermal imbalances in the chambers, non-efficient energy use, and extended startup times. These are all signs of a Thermal Oxidizer that should be evaluated for media replacement.

    By Gulf Coast Environmental Systems, LLC based in Conroe, TEXAS (USA). from Onsite & Remote Service Service line

  • Inspections/Maintenance Service

    Inspections and Maintenance operations on RTOs, Concentrators, and Catalytic Oxidizers RHZ provides both online and offline inspections. We work to ensure the proper operation of the equipment, and to identify any maintenance issues that could potentially lead to down-time in the future.

    By RHZ Environmental Controls, LLC based in Alliance, OHIO (USA).

  • Premium

    After-sales Services

    A dedicated team offering numerous after-sale services to help keep you compliant and profitable.

    By Catalytic Products International (CPI) based in Lake Zurich, ILLINOIS (USA).

  • Support / Services

    Our internal division SERVICE specializes in personal assistance services: from the remote control of the system operating state to the activities maintenance ordinary and extraordinary. Among our services also we signal the sieving active carbon and catalysts, respectively for solvent recovery and catalytic oxidizers, to maintain the efficiency ...

    By BROFIND SPA based in Milano, ITALY.

  • Bake-Outs and Wash Downs Service

    When the ceramic media plugs on a regenerative thermal oxidizer, or a catalytic oxidizer, face velocities increase, differential pressure across the beds go up, thermal efficiency drops, and this leads to an increase in gas consumption. This can increase your utility consumption by more than 150%. Bake-outs and wash downs are two ways to clean the ...

    By RHZ Environmental Controls, LLC based in Alliance, OHIO (USA).

  • Denitrification and Catalysts

    In dependence of the temperature profile thermal processes may cause the formation of nitrogen oxides from nitrogen contents in the combustion air. Apart from other substances, nitrogen oxides are responsible for acid rain which is a fair reason to take appropriate measures to reduce their content within flue gas flows. In this context, ...

    By Envirotherm GmbH based in Essen, GERMANY.

  • Premium

    Services

    We offer maintenance, upgrade and operating services for our customers.

    By Genano Solutions based in Kello, FINLAND.

  • BAUER - Soil Vapour Extraction / Air Sparging Services

    For the remediation of unsaturated soil, soil vapour extraction, sometimes in combination with air sparging and bio-venting is used. For treatment of the exhaust-air, we use activated carbon filter, catalytic oxidation and bio filters of our own production. Soil Vapour Extraction (SVE) technique is particularly suitable for the remediation of ...

    By BAUER Resources GmbH based in Schrobenhausen, GERMANY. from Remediation Technology Service line

  • Premium

    RTO Servicing and Maintenance Services

    AirProtekt employs a very experienced maintenance engineering team that is equipped to respond quickly and efficiently to client demands. AirProtekt always aims to enable a customer to be back on line within a matter of hours even if that requires working weekends or through the night.

    By AirProtekt Limited based in Newton, UNITED KINGDOM.

  • Rental Equipment Services

    Epcon carries a full range of Thermal Oxidizers, Industrial Ovens, Industrial Furnaces & Afterburners available as rental units to fit your needs.

    By Epcon Industrial Systems, LP based in The Woodlands, TEXAS (USA).

  • Site Remediation

    GEA Engineering P.C. (GEA) offers clients complete investigation, design, feasibility testing, permitting, installation, and operation of in-situ and ex-situ site remediation systems. Previous design and full-scale implementation has included: Groundwater collection and treatment including physical, chemical & biological advanced treatment ...

    By GEA ENGINEERING based in Nanuet, NEW YORK (USA).

  • Catalyst Washing & Regeneration Services

    A combustion exhaust stream is not a pristine environment.  Normal and abnormal engine operation exposes the catalyst to chemical compounds and temperatures that affect the catalyst’s surface and its active ingredients.  These compounds hinder catalyst performance through a number of mechanisms and cause catalyst performance to ...

    By EmeraChem based in Knoxville, TENNESSEE (USA).

  • Energy Audits

    Gulf Coast Environmental Systems LLC (GCES) provides Energy Audits to assess the energy consumption and recommend ways to improve energy efficiency. The GCES Industrial Energy Audit Program applies to equipment such as Thermal Oxidizers, Furnaces, Ovens, Heat Exchangers, Boilers, and Building Air Handling Systems.

    By Gulf Coast Environmental Systems, LLC based in Conroe, TEXAS (USA). from Engineering Services Service line

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you