Cooling Tower Services Available In Virgin Islands
-
Manufactured by Holland Water BVbased in NETHERLANDS
Cooling towers with heat exchangers or fill are subject to the formation of biofilm. This biofilm is the breeding ground for Legionella bacteria. The water temperature supports rapid growth. When the water mist escapes from the cooling tower, the Legionella bacteria are carried into the air and pose a respiratory risk. Not only ...
-
Manufactured by Composite Cooling Solutions (CCS)based in USA
When service requirements on your tower go beyond the simple replacement of off-the-shelf components, contact CCS. In partnership with our CCS representatives, we deliver services from equipment and thermal upgrades to partial or full cooling tower reconstruction, including improvements that can restore and improve thermal ...
-
Manufactured by Tandex Pty Ltdbased in AUSTRALIA
Improve the Lifespan & Operational Efficiency of Cooling Towers. Tandex technicians are trained to identify and help you: Minimise areas of waste. Improve operational efficiency. Address safety and non-compliance issues. Extend the operating life of your ...
-
Manufactured by The Metro Groupbased in USA
Metro Group is the only company in New York City that can perform all of your required services to comply with NYCDOH mandates under Local Law 77. Our team can provide coverage anywhere in New York State and handle all of your NYS cooling Tower Compliance requirements. Choosing any other vendor will leave you caught in the middle. ...
-
based in USA
If you’re searching for “cooling tower coatings“, “cooling tower epoxy paint” or “cooling tower lining” in Phoenix, Arizona, All Kote Lining Inc can help! We provide the highest quality coatings and cooling ...
-
Manufactured by Aqualyng ICESbased in AUSTRALIA
Aqualyng ICES offer a complete service including chemical product support ensuring your system operates at its optimal efficiency with minimal water and chemical losses. The rising cost of water has generated the need to find alternative water supply sources, our team are experienced in using reclaimed and storm water as makeup and along with complete blow down recovery systems and tailored ...
-
Manufactured by SPX Cooling Technologies, Inc. - a division of SPX Corporationbased in USA
If you need emergency or supplemental cooling, or simply a contingency plan, SPX Cooling Technology’s extensive fleet of rental towers can get you out of hot water. We respond quickly during emergency outages to get your system up and running fast so you avoid costly down time. We use only Marley cooling ...
-
Manufactured by Feedwater Ltdbased in UNITED KINGDOM
In order to minimise the risk of Legionnaires’ disease and comply with the requirements of ACoP L8 a cooling tower chemical treatment should be performed in order to clean and disinfect the system regularly to remove fouling that can provide a growth environment for Legionella bacteria. The normal process involves Cooling ...
-
Manufactured by IDE Technologiesbased in ISRAEL
Cooling towers need a reliable, economical and sustainable source of high quality water to reduce the threat of build up of scale, organic compounds and zinc oxide. The removal of scale each year is one of the largest costs of cooling tower maintenance and clean water extends the life of the cooling equipment and ...
-
Manufactured by Midwest Towers, Inc.based in USA
When your cooling tower is off line because of some kind of damage, the most important thing is getting it back up and running. Midwest Towers has the people and power to get your repair completed fast and right. Our emergency response team can move quickly and efficiently to assess your situation and marshal the effort to bring about a remedy. ...
-
Manufactured by Aqua Clear Water Treatment Specialistsbased in USA
Aqua Clear Water Treatment Specialists has over 20 years of cooling tower treatment experience. Our custom chemical formulations are designed for low doses allowing for maximized economical value and minimal ecological footprint. Our formulated cooling tower chemicals contain optimized blends of dispersants and scale inhibitors ...
-
Manufactured by SAMI Technologies Int. S.L.based in SPAIN
In cooling tower circuits, there is a high concentration of different types of salts (calcium carbonate and magnesium), produced by the evaporation of water, which causes considerable economic costs for maintenance of the tower, and overspending water treatment chemicals and electricity. All these factors, taken together, reduce the ...
-
based in USA
Cooling towers can be a critical process in many industrial production facilities. An industrial cooling tower can be the perfect media for biological growth if not properly treated. Typical pH is 7-9 and temperatures may have a wide range. In a cooling tower, the water trickles down a large ...
-
based in USA
ALL KOTE LINING, INC. provides the Phoenix Valley’s premier restoration and cleaning services for cooling towers, chiller tubes, steel and fiberglass storage tanks as well as end bell coatings. We also offer industrial cooling tower repair and fill replacement to restore your cooling ...
-
Manufactured by The Metro Groupbased in USA
WE AT METRO are leaders in controlling water-borne infections in building environments. Metro delivers comprehensive programs that promote safer building environments and responsible working conditions for the benefit of building engineers, hospital and healthcare managers, and the general population. All programs and services are tailored to meet the specific and varied needs of diverse ...
-
Distributed by Clean Air Engineering, Inc.based in USA
Plume-abated cooling towers are designed to minimize the amount and density of the visible plume that condenses at the cooling tower exhaust. These towers may be required by local authorities when the visible plume is a safety hazard or nuisance. Common settings include airports, locations adjacent to highways ...
-
Distributed by Clean Air Engineering, Inc.based in USA
One of the most common workplace injuries is hearing loss, and cooling towers can be a significant source of noise emissions. Like our clients, we are continuously working to eliminate hazards and use engineering controls to reduce our employees’ exposure to dangerous environments. CleanAir can perform sound testing in accordance with ...
-
Distributed by Clean Air Engineering, Inc.based in USA
The size of the particles generated by the evaporation of the drift from a cooling tower is a function of the size distribution of the drift as well as the water chemistry. We can also measure the size of the droplets exiting the tower (7 to 4000 microns) and determine PM size fractions (PM10 and PM2.5). To do this, CleanAir has adapted a ...
-
Distributed by Clean Air Engineering, Inc.based in USA
Large field-erected cooling towers are a substantial investment and impactful to the performance of associated equipment. In order to ensure that you “got-what-you-paid-for”, many cooling tower contracts include a final milestone payment tied to demonstration of guaranteed performance through independent testing. ...
-
Distributed by Clean Air Engineering, Inc.based in USA
Cooling towers emit drift – which is a small fraction of their circulating water. The evaporation of cooling tower drift leads to PM emissions that cause downwind corrosion, icing, transmit legionella, and present other safety concerns. The US EPA considers cooling towers to be a source of ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you