Only show results in Texas? Ok

emissions limit services

  • Premium

    Design and Project Management Services

    Our in-house design expertise covers process, mechanical, structural, electrical, controls, material selection and sourcing. Working to the specified processes we work with clients to seamlessly integrate our equipment to deliver cost effect solutions while meeting the most stringent emission ...

    By Process Combustion Ltd based in Harrogate, UNITED KINGDOM. from Design & Engineering Service line

  • Emissions.

    Emission (lit. sending out) is the term used to describe the discharge of pollutants to the air, ground and water. In order to reduce environmental pollution by emissions, stringent limits have been prescribed in the Technical Instructions on Air Quality Control (TA Luft) by the German Federal Immission Control ...

    By EEW Energy from Waste GmbH based in GERMANY.

  • Premium

    ENTA - Fertarex Wastewater Treatment & An Recovery Plant Services

    The discharge of N-NH4 and N-NO3 into the environment is harmful the fertilizers enhance growth of algae and bacteria in natural water bodies. Input of nutrients into the water above a natural balanced level causes so called, eutrophication of the water body and can result in fish kill and a loss of ...

    By ENTA Treatment Systems Engineering Contracting Corporation based in Seyrantepe-Sarıyer, TURKEY.

  • Auditing, BAT & Engineering

    EHS Techniques has specialits in Best Available Techniques (BAT), who can help you determine the most cost effective and practicable alternatives based on the applicable Emission Limit Values (ELV) associated with each process or abatement technology. Environmental engineering conceptual solutions are also ...

    By EHS TECHNIQUES S.L. based in Barcelona, SPAIN.

  • Emission Measurements Services

    Emission measurements are most often carried out as emission limit value compliance assessments (test) but there are several other objectives for measuring emissions or to carry out measurements involving the same ...

    By Metlab Miljö AB based in Enköping, SWEDEN. from Environmental Consultant Services Service line

  • EU Emissions Trading

    If an organisation has a combustion plant with in excess of 20 MW, there are mandatory CO2 emissions limits as part of the EU Emissions Trading Scheme. If affected by the EU ETS, then a permit is required to ...

    By STC Energy based in Kent, UNITED KINGDOM. from Carbon Services Service line

  • FlowVision - SNCR Performance & Optimization Trials Consultancy Services

    Meeting stringent new emissions limits and selecting the correct NOx reduction technology to achieve the required limits can be challenging. To be able to obtain more reliable data that the SNCR process can achieve the desired NOx reduction, FlowVision is able to conduct performance trials with portable test ...

    By FlowVision A/S based in Odense N, DENMARK.

  • Compliance Air Emission Testing

    Western Environmental continually works in conjunction with industry as well as federal, state, and local officials throughout the world to ensure that emission limits set forth are successfully adhered to. We strive to provide the most experienced personnel and the most technologically advanced testing ...

    By Western Environmental Services and Testing, Inc. based in Casper, WYOMING (USA).

  • Odour Removal from Food Production

    When developing cities and habitated areas suddenly come closer to industrial zones. Often, these manaufacturing plants are forced to reduce emissions and odors from even existing production lines. New, tougher emission limits are being introduced and agreed, for example 5 OU/m³ (odor units) for habitated ...

    By Lesni A/S based in Billund, DENMARK. from Solutions Service line

  • Proventia Test Units and Testing Services

    Measuring and testing are a must in the engine, machine and vehicle manufacturing industry. As an emission control company research and testing has been a central part of our business from the beginning. Each emission standard determines not only the emission limits, but also how an engine, vehicle or ...

    By Proventia based in Oulunsalo, FINLAND.

  • Flat-Bag Testing Laboratory

    The availability of a plant mainly depends on the satisfying condition of the installed flat-bags with regard to; the gas flow rate to ensure the complete gas and particle collection at the extraction point and the residual particle content in the clean gas for the observance of the requested emission limit ...

    By Luehr Filter GmbH based in Stadthagen, GERMANY.

  • Solvent Management Plans

    health and the environment in general. The facilities covered by Decree-Law no. 127/2013 are required to submit an annual Solvent Management Plan which is intended to demonstrate compliance with the emission limit values for industrial gases, to identify measures for emissions reductions and to ensure public ...

    By AmbiPrime - Consultoria e Gestão Ambiental, Lda. based in Lisboa, PORTUGAL. from Waste Management Plans Service line

  • Environmental Learning And Development

    quality and emission limits and environmental permitting and performance reporting. We also recommend a number of free courses offered by the UK Open ...

  • Air Emissions Testing Services

    Federal and state rules require stationary industrial sources to obtain air permits and install emission control equipment sufficient to meet or maintain regional air quality standards, equipment performance standards, and/or categorical industry emission limits. Emissions testing — which is also known as ...

    By Environmental Quality Management Inc based in Cincinnati, OHIO (USA). from Environmental Services Service line

  • Wastewater Treatment Services

    Proper treatment and disposal of used water from any activity is essential to prevent adverse environmental impact and to ensure compliance with specified emission limit values. Our expertise in wastewater treatment is well recognized and nesa can: Provide advice on process design and operation of wastewater ...

    By NESA (Environmental Consultants) based in Ashbourne, IRELAND. from Water Services Service line

  • CEMS Support

    Industrial facilities subject to air permits and regulatory emissions limits must frequently implement sophisticated Continuous Emissions Monitoring Systems (CEMS) to demonstrate compliance. Without a solid understanding of the federal regulatory requirements under 40 CFR Parts 60 and 75 (as well as state and ...

    By Trinity Consultants based in Dallas, TEXAS (USA). from Compliance Assistance Service line

  • Pollutant Decrease

    Thanks to the latest filtering and firing technology, waste incineration plants fulfil higher environmental standards than other industrial plants. The amendment of the 17th Directive of Germany's Federal Immission Control Act (17th BImSchV) resulted in the definition of the most stringent emission limit ...

    By EEW Energy from Waste GmbH based in GERMANY.

  • Designing and Maintaining Continuous Emission Monitoring Systems

    Public and private industrial operations from mining to landfills are under increasing pressure to control, monitor, and mitigate stack air pollution. The EPA’s Clean Air Regulations set in-stack emissions limits for pollutant concentrations at the point of release, and facility operating licences ...

    By Norditech Pty Ltd based in Arndell Park, AUSTRALIA.

  • Emissions Measurement Division

    The Emissions Measurement Division's work overlaps all ICAC divisions as accurate measurements of pollutants lies at the heart of the nation's air pollution control success story. Many air pollutants have numerical emission limitations which are measured by sophisticated equipment due to the low ...

    By Institute of Clean Air Companies (ICAC) based in Arlington, VIRGINIA (USA).

  • Stack Monitoring

    Limit) as detailed within the process guidance note. Both as part of the acceptance testing and also annual monitoring, the emissions of VOC (Volatile Organic Compounds), CO and NOx must be monitored over a minimum 5 hour period. The initial task is to establish a S.S.P. (Site Specific Protocol) to be ...

    By EPM - Environmental Project Management (Contracts) Ltd based in Bardsey, UNITED KINGDOM.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you