emissions limit Services in Europe

Emissions.

Emission (lit. sending out) is the term used to describe the discharge of pollutants to the air, ground and water. In order to reduce environmental pollution by emissions, stringent limits have been prescribed in the Technical Instructions on Air Quality Control (TA Luft) by the German Federal Immission Control ...

By EEW Energy from Waste GmbH based in GERMANY.

Design and Project Management Services

Our in-house design expertise covers process, mechanical, structural, electrical, controls, material selection and sourcing. Working to the specified processes we work with clients to seamlessly integrate our equipment to deliver cost effect solutions while meeting the most stringent emission ...

By Process Combustion Ltd. based in Harrogate, UNITED KINGDOM. from Design & Engineering Service line

Auditing, BAT & Engineering

EHS Techniques has specialits in Best Available Techniques (BAT), who can help you determine the most cost effective and practicable alternatives based on the applicable Emission Limit Values (ELV) associated with each process or abatement technology. Environmental engineering conceptual solutions are also ...

By EHS TECHNIQUES S.L. based in Barcelona, SPAIN.

EU Emissions Trading

If an organisation has a combustion plant with in excess of 20 MW, there are mandatory CO2 emissions limits as part of the EU Emissions Trading Scheme. If affected by the EU ETS, then a permit is required to ...

By STC Energy based in Kent, UNITED KINGDOM. from Carbon Services Service line

Emissions Measurements Services

Emission measurements are most often carried out as emission limit value compliance assessments (test) but there are several other objectives for measuring emissions or to carry out measurements involving the same ...

By Metlab Miljö AB based in Enköping, SWEDEN. from Environmental Consultant Services Service line

Ceramic Hot Gas Filtration

A ceramic hot gas filter – designed and installed by Renewable Engineering can reduce your Particulate Emission Limit Value to below 1 mg/Nm3. The filter is installed between the boiler or combustion process and the chimney, the flow through the filter is aided either by the existing induced draft ...

By Renewable Engineering Ltd based in Selby, UNITED KINGDOM.

Proventia Test Units and Testing Services

Measuring and testing are a must in the engine, machine and vehicle manufacturing industry. As an emission control company research and testing has been a central part of our business from the beginning. Each emission standard determines not only the emission limits, but also how an engine, vehicle or ...

By Proventia based in Oulunsalo, FINLAND.

FlowVision - SNCR Performance & Optimization Trials Consultancy Services

Meeting stringent new emissions limits and selecting the correct NOx reduction technology to achieve the required limits can be challenging. To be able to obtain more reliable data that the SNCR process can achieve the desired NOx reduction, FlowVision is able to conduct performance trials with portable test ...

By FlowVision A/S based in Odense N, DENMARK.

Odour Removal from Food Production

When developing cities and habitated areas suddenly come closer to industrial zones. Often, these manaufacturing plants are forced to reduce emissions and odors from even existing production lines. New, tougher emission limits are being introduced and agreed, for example 5 OU/m³ (odor units) for habitated ...

By Lesni A/S Office in Sutton Coldfield, UNITED KINGDOM. from Solutions Service line

Solvent Management Plans

health and the environment in general. The facilities covered by Decree-Law no. 127/2013 are required to submit an annual Solvent Management Plan which is intended to demonstrate compliance with the emission limit values for industrial gases, to identify measures for emissions reductions and to ensure public ...

By AmbiPrime - Consultoria e Gestão Ambiental, Lda. based in Lisboa, PORTUGAL. from Waste Management Plans Service line

Flat-Bag Testing Laboratory

The availability of a plant mainly depends on the satisfying condition of the installed flat-bags with regard to; the gas flow rate to ensure the complete gas and particle collection at the extraction point and the residual particle content in the clean gas for the observance of the requested emission limit ...

By Luehr Filter GmbH based in Stadthagen, GERMANY.

Environmental Learning And Development

quality and emission limits and environmental permitting and performance reporting. We also recommend a number of free courses offered by the UK Open ...

By Frogs International - Environmental Management and Consultancy based in The Hague, NETHERLANDS.

Pollutant Decrease

Thanks to the latest filtering and firing technology, waste incineration plants fulfil higher environmental standards than other industrial plants. The amendment of the 17th Directive of Germany's Federal Immission Control Act (17th BImSchV) resulted in the definition of the most stringent emission limit ...

By EEW Energy from Waste GmbH based in GERMANY.

CEMS Support

Industrial facilities subject to air permits and regulatory emissions limits must frequently implement sophisticated Continuous Emissions Monitoring Systems (CEMS) to demonstrate compliance. Without a solid understanding of the federal regulatory requirements under 40 CFR Parts 60 and 75 (as well as state and ...

By Trinity Consultants Office in Dublin, IRELAND. from Compliance Assistances Service line

Wastewater Treatment Services

Proper treatment and disposal of used water from any activity is essential to prevent adverse environmental impact and to ensure compliance with specified emission limit values. Our expertise in wastewater treatment is well recognized and nesa can: Provide advice on process design and operation of wastewater ...

By NESA (Environmental Consultants) based in Ashbourne, IRELAND. from Water Services Service line

Flue Gas Treatment

benchmark for Best Available Techniques (BAT). All of them guarantee emissions limits much below the levels requested by the EU directives. ...

By CNIM - Constructions industrielles de la Méditerranée based in Paris, FRANCE. from Emissions Control Service line

Stack Monitoring

Limit) as detailed within the process guidance note. Both as part of the acceptance testing and also annual monitoring, the emissions of VOC (Volatile Organic Compounds), CO and NOx must be monitored over a minimum 5 hour period. The initial task is to establish a S.S.P. (Site Specific Protocol) to be ...

By EPM - Environmental Project Management (Contracts) Ltd based in Bardsey, UNITED KINGDOM.

Air Emissions

Businesses that generate, use or release highly volatile organic solvents (VOC) are required to submit an annual emission balance sheets. The balance sheet compares the solvents used and disposed of with the ventilated solvents to ensure that limiting emission values are kept to. INTERGEO prepares your solvent ...

By INTERGEO Umwelttechnologie und Abfallwirtschaft GmbH based in Salzburg, AUSTRIA. from Environmental Health and Safety Service line

EU-ETS Service

, around 45% of total EU emissions are limited by the EU ETS. From 2018 shipping will also come under the auspices of the EU ETS. This will apply to ships of all nationalities from their last non-EU port of call, through EU waters and on to their first non-EU port of call. It is estimated that this will account for circa ...

By Sustainable Environmental Systems Ltd based in Rochester, UNITED KINGDOM. from EMS Service line

Emissions Compiler Service

on an ongoing basis. Used in conjunction with the PI Forecasting tool, which provides accurate and realistic scenario-based forward projections, the Emissions Compiler gives a ready graphical viewpoint as to whether operations are likely to exceed expected emissions, relating values to NAP limit as ...

By Ingen based in Aberdeen, UNITED KINGDOM.