Fouling services available in Nicaragua

  • Avoiding Pump Failures for Non-Fouling Solution

    False Measurements Due to Equipment Malfunction: In Newport News, Virginia, several restaurants were built in an area serviced by the same municipal wastewater lift stations. The introduction of heavy grease content to the wastewater caused the existing level measurement equipment to foul, and fail.

    By KELLER AG für Druckmesstechnik based in Winterthur, SWITZERLAND.

  • Premium

    Troubleshooting Services

    Reverse Osmosis. Membrane fouling. Ion exchange. Calcium scaling. Filtration.

    By Lenntech Water Treatment based in Delft, NETHERLANDS.

  • Premium

    Biofouling Expert Service

    With our team of some of the most experienced biologists in the world having implemented hundreds of Biofouling control systems across the globe we can offer an expert review of the fouling as observed on the fouling coupons. The service is provided based on photo images of the fouling coupons of the biovision monitors and data interpretation from ...

    By H2O Biofouling Solutions B.V. based in Bemmel, NETHERLANDS.

  • Premium

    Pre-Treatment for Desalination

    For desalination plants it is of great importance of the operation of the entire plant that good pre-treatment of water takes place before the salt is removed. For reverse osmosis (RO) desalination plants, satisfactory pre-treatment is essential for avoiding membrane fouling. Membrane fouling may result in reduced water ...

    By Filtralite - Leca Norge As based in Alnabru, NORWAY.

  • Premium

    Feed Water and Pre-Treatment Tests for Laboratory Service

    In order to optimise the operation of a membrane plant it's essential to fully understand the chemical nature of the feed water. From statistical analysis of the results of membrane autopsies we've carried out over the past ten years, we have concluded that more than 50% of membrane fouling and failure events result from inadequate pre-treatment. ...

    By Genesys International Limited based in Middlewich, UNITED KINGDOM.

  • Increase Diffuser Lifetime

    Proper preventive maintenance and cleaning can increase the diffuser lifetime up to 50%. Before choosing one of these techniques it is necessary to check the material resistance of the diffuser membrane and to verify the type of fouling. Every wastewater is special and may effect its own type of fouling.

    By Jäger Umwelt-Technik GmbH based in Hannover, GERMANY. from Operation & Maintenance Service line

  • Cooling Water Treatment Service

    The water treatment of cooling towers is an integral part of process and building operations in many industries, with the possibility of productivity and product quality being adversely affected by scale, corrosion, fouling and microbiological contamination.

    By Ecolab Inc. based in St. Paul, MINNESOTA (USA). from Water Treatment Service line

  • On-site Customer Support Services

    AMSA, Inc. provides direct customer support and on-site visits on a shared-cost basis. We provide metabolic activity and fouling survey in industrial water systems using ATP analysis.

    By AMSA, Inc. / Antimicrobial Specialists & Associates, Inc. based in Auburn, MICHIGAN (USA).

  • Cleaning The Membranes

    To prevent the membranes from fouling it is strongly recommended to clean the membranes periodically. The most common techniques are: Running the diffusers with the maximum overload airflow (air bumping) for a short period of time. Inject formic acid into the airflow. Flush the whole system with acid or alkaline solution. Dewater the tank and blow ...

    By Jäger Umwelt-Technik GmbH based in Hannover, GERMANY. from Operation & Maintenance Service line

  • Service and Maintenance

    Annual service prolongs the life of your instruments and ensures accuracy. We recommend you send instruments in for service and maintenance every 12-18 months. This small yearly investment can have a substantial impact on the lifespan of your equipment and protects your data readings from instrument drift and fouling.

    By In-Situ, Inc. based in Fort Collins, COLORADO (USA).

  • Municipal Odor Control Services

    Monroe Environmental offers a variety of odor control equipment for municipal water and wastewater treatment facilities. Monroe can design and implement an odor control system that targets and eliminates foul odors such as H2S, NH3, VOCs, groundwater contaminants, and any organic gases resulting from:

    By Monroe Environmental Corporation based in Monroe, MICHIGAN (USA). from Municipal Pollution Control Service line

  • Cooling Water Chemicals Solutions

    ChemTreat takes the time to understand the exact needs of your cooling water system before recommending a cooling water chemical program. A full system audit, which includes operational history and inefficiencies, allows your field engineer to determine the potential for corrosion, fouling and scaling within your cooling system.

    By ChemTreat, Inc. - a subsidiary of Danaher Corporation based in Glen Allen, VIRGINIA (USA). from Chemical Treatment Programs Service line

  • DDT Process Services

    A schematic of the DDT Process is shown below. The process begins after the completion of “steaming out” of the residue feedstock in the assigned heater. Pigg launchers are then installed on both the inlet and outlet pipes of the assigned fired heater. These launchers provide the connection points for the pressurized waterlines and ...

    By Decoking Descaling Technology Inc. (DDT) based in Lacombe, ALBERTA (CANADA).

  • Biological Simulation Services

    SSI has significant experience in process including empirical and lab data on alpha factors, oxygen transfer efficiency and fouling factors. This data can be applied to a variety of processes, such as extended aeration, BNR, SBR, MBR, MBBR as well as conventional activated sludge, in plug flow or complete mix tanks, and with or without channel ...

    By SSI Aeration, Inc. based in Poughkeepsie, NEW YORK (USA). from Design Services Service line

  • Naturally making existing STPs and ETPs more efficient

    We have formulated a system of making existing ETPs and STPs more efficient. This results in reducing the cost of carrying out wastewater treatment, meeting pollution norms stringently, ability to recycle water without any fear of contamination and suppression of foul odour. We take over the complete treatment of your plant and deliver these ...

    By Clover Organic Pvt. Ltd. based in Dehradun, INDIA.

  • Chemical Cleaning Services

    When faced with a highly technical and potentially hazardous fouling problem, there is simply no substitute for specialized expertise, proven experience and advanced chemical-based solutions. At Veolia North America, we are problem-solvers dedicated to providing technically advanced chemical cleaning services in a safe, efficient, and professional ...

    By Veolia Energy based in Cambridge, MASSACHUSETTS (USA). from Cleaning Services Service line

  • Tank Farm

    The fermenting block or cold block is a strategic step of the brewing process. During the fermentation organic and inorganic deposits are formed and can alter the quality of your products. If not completely removed by the cleaning process, these foulings will leave an unsanitary surface that can harbour microorganisms. Sopura has developed for ...

    By Sopura based in Crawley, UNITED KINGDOM. from Breweries Service line

  • Resin Condition Monitoring Services

    The MIEX Resin can tell a story about what is going on in the ion exchange process. Let our lab diagnose the activity. With this service, a sample of loaded and fresh resin from the plant will be sent in to enable the resin condition to be analyzed in the Ixom laboratory. The objective of these tests is to monitor the resin condition for decline ...

    By IXOM Watercare based in East Melbourne, AUSTRALIA. from Operational Support and Service Service line

  • General Microbiology Service

    ASI provides a wide range of testing and consulting services to address issues regarding the microbiological quality of water, wastewater, sediments, soil, etc. Representative projects have included samples of biofilms/fouling, distribution system positive coliform samples / regrowth, reclaimed water, microbial induced corrosion (MIC), cutting ...

    By Analytical Services, Inc based in Williston, VERMONT (USA). from Water Services Service line

  • Thermal Processing Research and Piloting Facilities

    Our expertise ranges from pilot scale thermal testing to commercial scale thermal processing. We specialise in the thermal treatment of niche, novel, new and and waste products with indirect fired rotary kiln technology. Whether you are developing a new product, producing energy from waste or recycling fouled materials thermally, we can provide ...

    By Heat Systems based in Claremorris, IRELAND.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you