ENVEA

Version WEX –QAL3 - Automatic Calibration of the Measuring Devices

From

0

The SPC module provides statistical tools and graphs which allow rapid detection of eventual anomalies in the measurement chain. This module is integrated into the WEX software and relies on a wide range of charts strongly recommended by the regulations.

  • Management of calibrations: planning, configuration of profiles and phases
  • Integration and management of automatic and manual calibration results: invalidation, deletion, input, import/export of data
  • Large range of choice of control chart: SHEWHART, SHEWHART, EWMA, CUSUM,…
  • Simultaneous application of different control charts for each measure
  • Automatic calculation of control limits or manual input
  • Automatic detection and notification of anomalies during data acquisition
  • Adjustment of the qualification of the data in case of detection of an anomaly in the measurement chain
  • Graphical and tabular display of calibration results and historical data
  • Traceability of events: incidents, modification of the chart, modification of the target
  • All information, data, messages are saved in the database to allow reporting on the data
  • Graphics: customizable, zoom and scrolling
  • Complete integration with the iséo DAS range and XR software

  • Additional module available for WEX software

  • EN 14181
  • ISO 7870-1:2014, ISO 7870-2:2013
  • NF X06-031-1, NF X06-031-3, NF X06-031-4

Customer reviews

No reviews were found for Version WEX –QAL3 - Automatic Calibration of the Measuring Devices. Be the first to review!