Drilling Waste Services For Soil And Groundwater Near Netherlands Antilles
-
Manufactured by Lamor Corporation Abbased in FINLAND
Drilling cuts: Lamor has designed water treatment technology for drilling cuts with its Finnish partners. As an oil response company Lamor has gathered oil removal know-how for decades and now applies this expertise to water treatment applications. Oil will be removed from drilling cuts with a unique two-phase flotation technology and the collected oil can usually be used in incinerators. The ...
-
Manufactured by Griffin Dewatering Corporationbased in USA
Griffin employs the slurry trench technique to prevent the underground seepage of liquid wastes or to isolate solid waste leachate in order to prevent the migration of ...
-
based in USA
In most environmentally impacted sites, HCR recommends and utilizes cutting edge drilling technologies acceptable to regulatory agencies for deploying the appropriate technical environmental application for significant improvements in site characterization and ...
-
based in USA
Pits and sumps present unique challenges when it comes to dewatering, sludge removal, or solids removal. That’s where SR&R Environmental’s fleet of Wet/Dry Vacuum Trucks excel where others can’t. These powerful high capacity units can provide the greatest recovery capacity at the deepest pumping depths to get your pits or sumps emptied out and back in ...
-
based in USA
ARM has extensive engineering experience relative to shale play development including well pads, impoundments, intakes, pipelines, compressor and tap sites, and associated infrastructure. The following includes a summary of our ...
-
based in USA
Phase I Environmental Site Assessments (ESA): Phase I Environmental Site Assessment (ESA) are conducted in order to learn about a property's past use, the environmental conditions at the site and adjoining sites, and the likely presence of hazardous substances. A Phase I ESA does not involve sampling or laboratory ...
-
Distributed by Atlas Geo-Sampling Companybased in USA
Atlas Geo-Sampling has completed over 100 projects that involve the installation of remediation / injection wells or the direct injection(thru the DPT rods) of various remediation ...
-
based in USA
SURFAC is EcoVac Services’ patented process combining the elements of dual/multi phase extraction (DPE/MPE) with surfactant injection. Nick Athens, co-owner of EcoVac Services, building upon the Enhanced Fluid Recovery (EFR) technology invented and developed by co-owner David M. Goodrich, developed a patent relating surfactant enhanced aquifer remediation with DPE/MPE. This patent was ...
-
based in USA
Building materials that may be disturbed as part of a planned renovation must be inspected for the presence of asbestos prior to the renovation. ALIS can perform building inspections and full surveys to determine the presence, location and quantity of asbestos in building materials. Once the asbestos hazards are located and their condition assessed, we can offer assistance with remediation ...
-
based in USA
CETCO Oilfield Services wastewater treatment experience has culminated in the design and implementation of a multi-stage treatment package. FlexTreat is a system which combines conventional water treatment technologies and proprietary media to effectively process wastewater of wide ranging and uncertain composition. Wastewater from a variety of different sources which contains solids, crude oil, ...
-
based in USA
This adsorption media is based on resin, polymer, and clay technologies. CrudeSorb is extremely efficient at removing oil, grease, and soluble organics from water ...
-
based in USA
Oil and gas pipelines often cross the paths of rivers and streams. If a new pipeline is to be installed below the riverbed, or an existing pipe has to be inspected or repaired, the work area along the alignment of the pipe must be isolated, to support dewatering efforts. Depending on the scope of work, a “U-shaped” AquaDam cofferdam may be used to isolate a work area along one bank, ...
-
based in USA
Finishing capabilities at PEG are important because they allow virtually unlimited design options. In fact, they are a decisive aspect of any custom glass job and one that we take very seriously here. For that reason, there are many reasons to consider PEG when it comes to finishing work. Because of our design flexibility and experience, many new clients bring a single project to PEG initially. ...
-
Manufactured by Andrews Glassbased in USA
The grinding department performs an array of functions. Precision cutting with diamond blades, cutting angles, drilling, beveling, countersinking, concentric grinding, centerless grinding, plunge grinding, outside diameter polishing, grinding flat, lapping flat, and polishing flat are some of our capabilities. Tubes of 120 mm diameter can be cut. Being able to grind and cut in a variety of ways ...
-
Manufactured by Cadorathbased in CANADA
Our state-of-the-art, technologically advanced facilities allow us to stand above the rest and offer an assortment of valuable added services to our ...
-
based in USA
Stratagraph offers multiple onsite monitoring packages as well as offsite monitoring options to suit your needs and budget. Well logging systems come with all the essential equipment to monitor, record and generate standard or customized computer logs. Remote monitoring is available to allow company representatives or drillers to see logged data in real time using the latest satellite ...
-
based in USA
For nearly 60 years, Stratagraph has provided complete mud logging and pressure detection services to the oil and gas industry. Having accurate, up-to-date information available helps ensure optimal operation decisions can be made while protecting the wellbore and preserving a safe working environment. Targeting the specific needs for each site, we can create a detailed record of a borehole and ...
-
based in USA
Count on R360’s transportation services for the collection and removal of all of your drill cuttings and site waste. When pits aren’t possible and oil-based mud cuttings make an appearance, R360 offers the on-site transportation services you need to haul all of your drilling ...
-
based in USA
From produced saltwater to drilling mud and cuttings, R360’s land waste disposal systems offer all-around solutions for your sustainable disposal needs. At our dedicated land waste disposal facilities, R360 specializes in treating and recycling all non-hazardous materials from your oilfield operations. Though the majority of the products we treat are oil and water-based mud and cuttings, we ...
-
by Ecoserv, LLCbased in USA
We offer turnkey, integrated solutions to manage the complete life cycle of waste produced in offshore drilling, industrial downstream, upstream production, and marine dockside industries. Ecoserv offers traditional, robotic and automated cleaning to handle every job safely and ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you