Geotechnical Solutions Equipment For Soil And Groundwater In New Jersey
-
PremiumManufactured by AMS, Inc.based in USA
Pask Permeameter Kit; The field saturated hydraulic conductivity (Kfs) or permeability of natural soil and built up beds of fill can be quickly and easily measured in place using the ETC Pask Constant Head Permeameter Kit manufactured by Dynamic Monitors, a business unit of Engineering Technologies Canada Ltd. ...
-
PremiumManufactured by CETCObased in USA
CETCO COATED TABLETS are coated using an aqueous carrier to apply the coating. These untreated organic tablets are compressed into 1/4” (0.64 cm) and 3/8” (0.95 cm) sizes. CETCO COATED TABLETS are certified to NSF/ANSI Standard 60, Drinking Water Treatment Chemicals - Health ...
-
PremiumManufactured by AMS, Inc.based in USA
The Munsell Soil Color Chart Binder allows for color classification of soils using 250 mounted chips. The Munsell Color Chart enables color classification of soils using 250 mounted color chips. Developed with the U.S. Soil Conservation Service, this guide is the industry standard. The McCollough Geo Guide Card and Geotechnical Gauge provide easy to use geotechnical information. The Geo Guide ...
-
PremiumManufactured by AMS, Inc.based in USA
Developed by the Army Corps of Engineers, Dynamic Cone Penetrometers (DCPs) provide a low-cost, efficient test method for quickly determining in-situ CBR values of pavement base, subbase and subgrades. They can readily be used for depths up to 30" and up to 6' with optional drive rods and extensions. This model complies with ASTM D6951 specifications and comes with a chart to compute CBR values, ...
-
Manufactured by Geonor ASbased in NORWAY
M-603 is a special version of M-600 which is open to the atmosphere and equipped with a rubber membrane above the pressure membrane. Compressed air assistance provides a back pressure in order to relieve the pressure membrane. This will balance the back pressure during push-in penetration and the piezometer will be pressed down more quickly. Back pressure can also be used to relieve the membrane ...
-
Manufactured by Geonor ASbased in NORWAY
The piezometer can be pressed down without pre-drilling, normally until approximately 30 m depth. Intended for Ø32 mm extension tube. Adapters to 1' water pipe can be ...
-
Manufactured by Aardvark Packerbased in USA
Tigre Tierra Inflatable Packers, designed and manufactured by Aardvark Packers, range from simple fixed-head balloon packers to steel-reinforced sliding-head Viton® and stainless steel monitoring systems with multiple transducers and pumps. In addition to our line of inflatable packers, we offer our patented Tigre Tierra Wireline Packer Systems for permeability testing during core drilling. ...
-
based in USA
Pneumatic Fracturing (PF) can best be described as a process whereby a gas is injected into the subsurface at pressures exceeding the natural in situ pressures in the soil/rock interface (i.e. overburden pressure, cohesive stresses, etc.) and at flow volumes exceeding the natural permeability of the ...
-
Manufactured by Geonor ASbased in NORWAY
Geonor T-200B series of all-weather precipitation gauges are used by leading meteorological services and climatic networks worldwide. Other users are typically airport authorities, agricultural institutes and hydroelectric ...
-
by ConeTecbased in CANADA
ConeTec CPT rigs are capable of accessing urban centers, remote sites, mine tailings, and active construction areas. Built between 18 and 35 tons, on tracks and on trucks, these are the hardest pushing rigs in the industry. Advanced hydraulic systems ensure penetration rates and CPT quality are maintained, while safety and efficiency are ...
-
Manufactured by Geonor ASbased in NORWAY
P-430 is a steel reinforced 2-pair cable. It is specially designed to withstand high loads in terms of tension and compression and is protected against water ingress, in case of damaged ...
-
Manufactured by Provectus Environmental Products, Inc.based in USA
Developed in collaboration with AquaBlok, LTD subaqueous caps can be constructed more effectively by minimizing gas ebullition and contaminant ...
-
Manufactured by Geonor ASbased in NORWAY
The Geonor M-610 scries arc vibrating wire piezometers used for direct burial in embankments and earth/rockfill dams, for placement in boreholes, and for water level monitoring in open wells, tanks, and open bodies of ...
-
Manufactured by Aardvark Packerbased in USA
At Aardvark Packers, we design and manufacture a variety of inflatable packers used in Environmental applications. As an example, we have looked at our manufacturing processes and developed a 1.70” OD fixed end packer that houses (3) 3/8” stainless steel pass thru tubes which can now be used for (four) injection or sampling zones independent from each other. This allows the ...
-
Manufactured by Geonor ASbased in NORWAY
The P-520N frequency counter is the read-out instrument for all GEONOR vibrating-wire transducers. The counter is designed for use in situ and is enclosed in a rigid aluminium housing. The display shows the frequency of vibration in 0.1 Hz. which has to be calculated to physical units using a calibration table. It is powered by a rechargeable 12 V NiCd ...
-
Manufactured by Geonor ASbased in NORWAY
A new model of the Geonor G-200 Fall Cone Penetration Test including a robust special purpose transport box and a flexible magnifier is now available. Application The Fall Cone Penetration, first introduced in 1915, provides a rapid, simple and accurate method for determining empirically the undrained shear strength, the shear strength of remolded samples and thus the sensitivity of clays. The ...
-
Manufactured by Geonor ASbased in NORWAY
The field vane shear test (FVST) is the most commonly used method for measuring the undrained shear strength of soft to stiff clays. For this reason, a preliminary investigation of soft clays with a hand-held vane tester is both economic and fully relevant. It also has good repeatability and is quick in providing valuable information for the planning of more detailed ...
-
by ConeTecbased in CANADA
All ConeTec cones and data acquisition systems are built seismic ready. The addition of geophones in the CPTu body enables the collection of seismic wave data, and the calculation of shear (Vs) and compressional (Vp) wave velocities during the cone penetration ...
-
Manufactured by Geonor ASbased in NORWAY
The Geonor M-600 series piezometers are vibrating wire sensors which are installed by pushing into soft and loose soils without having to drill a borehole. As with all other Geonor vibrating wire piezometers, the M-600 series offer the maximum reliability available for continuous pore water pressure or ground water level measurements. Geonor *s unique design combined with continued technical ...
-
PremiumManufactured by AMS, Inc.based in USA
The most widely accepted, portable method for evaluating strength and density of soil, in situ. The dynamic cone penetrometer uses a 15 lb. (6.8 kg) drive mass falling 20 in. (50.8 cm) that strikes the anvil to cause penetration of 1.5 in (3.8 cm) diameter cone (45 degree vertex angle) that has been seated in the bottom of a pre-augered hole. The blows required to drive the embedded cone a depth ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you