Site Remediation Articles

  • Key Elements of a Successful Horizontal Remediation System

    Environmental remediation professionals around the country (and internationally) are rapidly learning that Horizontal Remediation Systems are an essential “tool in their remediation toolbox”. When designed and executed by experienced horizontal environmental drilling experts, Horizontal Remediation Systems can be extremely effective at achieving rapid site closure compared to vertical ...

  • Multipurpose Horizontal Remediation Wells Treat Impacts from Former DOD Operations

    The site, a former DOD plant previously used for the manufacture of aircraft and missile systems had TCE impacts that posed a threat to the current occupants at the site.    The site had been recently redeveloped into an industrial complex for several companies. For the new occupants, a disruptive indoor construction to install a vertical remediation system was out of the question. In ...

  • Ground Water Remediation Case Study

    The Pine Street Barge Canal Superfund Site is located along the coast of Lake Champlain. Sediments in the canal were contaminated by historic dumping of various materials including coal tar, solvents and petroleum products. Terra Contracting Services, LLC (Terra) was retained to implement the remedial design. Terra subcontracted with Global Environmental Engineering Inc. (Global) to provide ...

  • Soil and Ground Water Remediation Case Study

    On this State Funded Clean-Up project, Global was the project engineer and was responsible for the design of an air sparging/soil vapor extraction remediation system. The system included five soil vapor extraction wells and twelve sparging wells that operated on a rotating schedule. One of the soil vapor extraction wells and nine of the sparging wells were installed as horizontal wells beneath ...

  • PeCOD® Pulp and Paper Applications - Case Study

    The pulp and paper industry utilizes wood as raw material to produce pulp, paper, card board, and other cellulose based products. Pulp and paper mills produce large volumes of wastewater and residual sludge which presents a number of challenges with regards to treatment and discharge. Contaminants in pulp and paper waste streams often include effluent solids, sediments, absorbable organic halides ...


    By MANTECH INC.

  • Measurement of NAPL–water interfacial areas and mass transfer rates in two-dimensional flow cell

    The nonaqueous-phase liquid (NAPL)–water interfacial area and the mass transfer rate across the NAPL and water interface are often key factors in in situ groundwater pollution treatment. In this study, the NAPL–water interfacial area and residual NAPL saturation were measured using interfacial and partitioning tracer tests in a two-dimensional flow cell. The results were compared with ...


    By IWA Publishing

  • Enhanced Vapor Intrusion Mitigation via Horizontal Remediation Wells

    Vapor Intrusion (VI) is a potential concern at any building - existing or planned, located near soil or groundwater contaminated with volatile organic compounds (VOCs). Conventional installation technologies (vertical wells) can fall short, especially when large structures such as factories, hangars, and offices buildings are involved because they typically involve expensive and lengthy ...

  • Wastewater containing Cr(VI) treatment using solar tubular reactor

    The hexavalent chromium, Cr(VI), which is generated in the electroplating process, is toxic to most organisms and potentially harmful to human health. The method generally used for remediation of wastewater containing Cr(VI) employs chemicals with high toxicity. This work proposes an alternative technology for the treatment of these wastewaters, based on photochemical reduction of Cr(VI) by ...


    By IWA Publishing

  • EPA’s Discretion on Whether to Require Inert Ingredients Disclosure Upheld

    On June 29, 2016, the U.S. District Court for the Northern District of California (Court) issued an opinion dismissing the complaint and denying the motion for summary judgment of the Center for Environmental Health, Beyond Pesticides, and Physicians for Social Responsibility (CEH, et al.), and granting the U.S. Environmental Protection Agency’s (EPA) motion for summary judgment. ...


    By Bergeson & Campbell, P.C.

  • Case study - Veolia MPPE Technology - Coatings/Printing Ink/Resin production - USA

    Resin production waste water Akzo Nobel (Coatings) TOTAL – Cook Resins (Houston) DuPont (Printing Inks) Operational since 1998 Challenge Waste water form Coating/Printing Ink/Resin Production like alkylds, acrylics and polyester resins Frequent fouling of exisiting steamstripper from heat ...

  • Case study - Veolia MPPE Technology - Synthexim Calais -France

    Specialty Chemicals and Pharmaceutical raw material producer Treatment of Waste- and Groundwater Operational since 2004 Challenge Inpredictable (toxic) inlet composition Fluctuating compositions DRIRE regulations including BoD < 300 ppm for discharge to sea Limited space to combine MPPE with ...

  • Efficiency and toxicity: comparison between the Fenton and electrochemical processes

    This study aimed to determine the best method to treat a textile effluent containing the dye basic blue 99 (BB). Treatments by the electrochemical and the Fenton processes were compared by means of a 23 experimental design, and the interaction of experimental conditions for BB oxidation were determined. The electrochemical treatment gave better results in the presence of NaCl as ...


    By IWA Publishing

  • Case Study - The Oluz Mound Archaeological Site Investigation

    Amasya, Turkey The Oluz Mound is a very important ancient Turkish settlement with a history stretching back 4,500 years BC. Objective To help an on going arcaeological excavations and to show possible structural extensions or new remains on the side by using the Geophysical Electrical Resistivity Tomography (ERT) imaging method. ...


    By Advanced Geosciences, Inc.

  • Characteristics and kinetics simulation of controlled-release KMnO4 for phenol remediation

    Controlled-release KMnO4 (CRP) technology has been recently developed as an improved, highly efficient technique in wastewater treatment. In this study, batch-style experiments were conducted to evaluate this technology. The release characteristics of CRP in distilled water and the reaction between CRP and phenol were studied and fitted using MATLAB software. Results indicated that in ...


    By IWA Publishing

  • White Paper: Soil Data Quality Control

    Why it is essential during a contaminated soil study? Before starting an evaluation of the contamination leading to decision-making tools for site clean-up, it is essential to ensure data quality. Thus, based on solid and reliable foundations, uncertainties occurring during the different steps of the decision process will be better controlled and the final quality of the project ...


    By Geovariances

  • Use of bauxite residue (red mud) as a low cost sorbent for sulfide removal in polluted water remediation

    Sulfide is an important pollutant in aqueous systems. Sulfide removal from polluted waters is required prior to discharge. Red mud (RM) is a solid waste of bauxite processing that is rich in reactive iron oxides and consequently has the potential to be used to remove sulfide from aqueous systems. A series of experiments was undertaken using raw and sintered RM to remove sulfide from waters. RM ...


    By IWA Publishing

  • Case study - EDRO in soil at wharf remediation site

    Sitelab Calibration Kit CAL-042 is used for EDRO analysis. The UVF-3100 detects hydrocarbons in the C10-C36 range. A Licensed Site Professional (LSP) used Sitelab to investigate a commercial waterfront property, contaminated with a plume of LNAPL resulting from fuel tanks which once stored heating oil, diesel and gasoline dating back to the 1950s. The site is in Massachusetts, where laboratories ...


    By Sitelab Corporation

  • Case study - Texas crude oil in soil sites

    Sunset Well Service, Inc. is an environmental contractor located in the Midland/Odessa area of Texas. They use their UVF-3100D analyzer to help excavate and remediate soils contaminated by produced water and crude oil. Laboratories in Texas test TPH using the TX 1005 GC-FID Method. This method is similar to U.S. EPA Method 8015M, but reports the GRO, DRO and ORO fractions separately. Soils from ...


    By Sitelab Corporation

  • What’s the Temperature? Thermal Modeling and its Importance in Thermal Remediation

    What is a model? A beautiful person who struts down a run way, a scaled down sculpture of the Empire State Building, or a series of equations that describe some phenomenon? Did you guess all of the above? Gold star! Models come in many different shapes and sizes. In the environmental consulting and remediation industry, the word “model” often refers to a numerical model. Numerical ...


    By TerraTherm, Inc.

  • Case Study - Source Area Remediation of PCE in Soil - Fair Lawn, New Jersey

    TRS Group, Inc. (TRS) was retained by Anderson Mulholland and Associates, Inc. (AMAI) to perform an Electrical Resistance Heating (ERH) remediation of DNAPL in soil at the former Topps Dry Cleaners property in Fair Lawn, NJ. The remedial goal of this project was a reduction of tetrachloroethene (PCE) in soil to less than 1 milligram per kilogram (mg/kg) in every soil sample. Final confirmatory ...


    By TRS Group, Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you