Slope Stabilization Equipment For Soil And Groundwater Available In Hawaii
-
PremiumManufactured by Gouda Geo-Equipment B.V.based in NETHERLANDS
The inclinometer casing tubes are designed to accommodate all commercially available inclinometers. They provide access and precise orientation for both wheel-mounted and fixed inclinometers. They are primarily used to monitor the stability of embankments, dikes slopes, rock cuts, foundations, excavation walls, piles, coffer dams, slope areas, ...
-
PremiumManufactured by CETCObased in USA
The Global Standard for GCLs: Sodium bentonite-based GCLs provide an excellent hydraulic barrier in applications where leachate in direct contact with the GCL is relatively non-aggressive, or in composite lining applications where the GCL is overlain by a thermally welded geomembrane and hydrates from uptake of innocuous moisture from the subgrade. ...
-
PremiumManufactured by Solexperts AGbased in SWITZERLAND
With the Reverse Head Extensometer, deformations can be continuously observed during excavation in front of the tunnel face or during the removal of slopes or the excavation of excavation pits. The modular design based on a chain of single extensometers provides a large number of measuring points in small diameter boreholes. The big advantage compared to other extrusion measuring systems is the ...
-
Manufactured by BAUER Foundation Corp. (BFC)based in USA
In general, undisturbed ground has sufficiently high compression strength, but only low tensile and shear strength. Soil nailing is a construction technique which is applied to increase and/or maintain the stability of soil mass by installing reinforcing bars or soil ...
-
Manufactured by Shivoham Fabtech Pvt Ltdbased in INDIA
We have a wide range of tensile strengths in length and width as per designed application. ...
-
Manufactured by ACE Instrument Co., Ltd.based in SOUTH KOREA
As shown in the figure on the right, model 1500 VW multipoint piezometer is installed as several VW piezometer in one hole by layer. Even if it is perfectly shielded from bentonite, the piezometer on the top encounters with several signal cables, causing inevitable leakage due to the narrow shield ...
-
Manufactured by Shandong Dongkai Engineering Materials Co.,Ltdbased in CHINA
DKM Nano Polymeric Alloy Geocell (Heavy Duty Type) is a lightweight and flexible three- dimensional,expandable panels made of NPA(Nano Polymeric Alloy)materials sheets which are ultrasonically bonded together to make to be an extremely strong ...
-
Manufactured by Sisgeo S.r.l.based in ITALY
Vibrating wire piezometers are used to monitor pore-water pressure in soils. They are typically sealed in boreholes but can also be embedded in fills, or suspended in a well. Typical applications include evaluating slope stability, dewatering and drainage schemes, overpressure in silt and clay soils, permeability and hydraulic gradients in dams, and also ground water levels. They can also be used ...
-
Manufactured by Anping Yingtaier Metal products CO LTDbased in CHINA
3D geomat also know as erosion control mat, debris flows control mat, Landslide control mat. 3D geomat’s mechanism of action is used both of plant and the three-dimensional reticular structure to construct a protective system with plants own growth ...
-
Manufactured by ACE Geosyntheticsbased in USA
It’s made of high molecular polymer (HDPE or PP) through extrusion, forming and punching before longitudinal and lateral stretching. Stiff geogrid has considerable tensile strength in bi-directions. This chain structure can effectively bear and diffuse forces on soil and is applicable to large area permanent load bearing ...
-
Manufactured by Metisbased in CHINA
R32 anchor bolt is is extensive applied in all kinds of constructions, such as railway system, metro project and infrastructure development. As an efficient anchoring method, it’s also widely applied to pre-support project, radial support project, slope stabilization, foundation support project, soil nail wall, back pull anchor rod retaining wall and other rock supporting ...
-
Manufactured by Drill Tech Drilling & Shoring, Inc.based in USA
Drill Tech has been an innovator in soil nail design and construction for geotechnical construction in the western United States for over 20 years. Our custom-built drill rigs consistently outperform our competition, allowing for faster and more cost-efficient design and construction of permanent and temporary soil nail walls. On average, Drill Tech constructs approximately 1,000,000 SF of soil ...
-
Manufactured by Filtrexx Canada Inc.based in CANADA
Filtrexx Living Walls can be made on site using Filtrexx FilterSoxx and custom filling with a backfill Growthmedia and seed of your choice. The Living Wall is not recommended for load bearing situations. However, it is a excellent choice for stream banks, road sides, parking lot abutments, headwalls for culverts and other areas that offer challenging ...
-
Manufactured by TMP Geosynthetics - Taian Modern Plastic Co., Ltd.based in CHINA
Provide slope stablization for Retaining Wall ...
-
Manufactured by HD Engineeringbased in CHINA
The HD90MKIV group of machines are very versatile medium range drills that have good articulated kinematics for the boom and undercarriage. This makes it a highly flexible machine when holes have to be drilled at various angles and different positions. They feature oscillating tracks, a bearing turntable, and a choice of drill heads or hydraulic drifters for any type of job. They are especially ...
-
Manufactured by Industrial Fabrics, Inc.based in USA
GreenSolutions® Erosion Control Blankets are superior to hydroseeding. Uses include: When the growing season is short and plants cannot stabilize the slope quickly, High altitudes, Where major storms are a frequent ...
-
Manufactured by Propex Operating Company, LLCbased in USA
ArmorMax Anchored Reinforced Vegetation System is the most advanced flexible armoring technology available for severe erosion challenges. Consisting of our woven three-dimensional High Performance Turf Reinforcement Mat (HPTRM) with X3® fiber technology and earth percussion anchors, you can count on the ArmorMax system to hold its ...
-
Manufactured by Metisbased in CHINA
T30 anchor bolt is one of the T-thread self-drilling hollow injection anchor bolt. As an efficient anchoring method, our self rock bolt is used in complicated, loose and broken geological condition. It’s widely applied to pre-support project, radial support project, slope stabilization, foundation support project, roadway support project, soil nail wall, back pull anchor rod retaining wall ...
-
Manufactured by Global Synthetics Pty Ltdbased in AUSTRALIA
In applications of soil reinforcement and the use of geogrids in engineering structures such as slope stabilisation and segmental block retaining wall construction the geogrid to be used will be subject to constant load over long periods of time. The load will be exerted in one direction only i.e. at a normal direction to the structure face direction. Global Synthetics are able to offer ...
-
Manufactured by Williams Form Engineering Corporationbased in USA
Williams has added strand anchor systems to an already fine line of ground engineering products. Williams has made a commitment to the ground engineering industry to supply well engineered, quality products and back those products with technical support and timely material delivery. The same commitment has been made with the Williams strand anchor line. Williams Strand Anchors utilize a high ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you