A two-part prefabricated sheet drain composite consisting of a 3-dimensional polypropylene formed dimple core covered with a non-woven polypropylene filter fabric on one side. The formed dimple core provides compressive strength and collects water for flow to drainage discharge pipes.
A two-part prefabricated drainage composite consists of a high strength HDPE geonet core with a non-woven polypropylene filter fabric bonded to both sides. AQUADRAIN G20 is designed for horizontal and vertical applications requiring very high compressive strength with low to moderate flow properties.
A three-part prefabricated drainage and protection composite consisting of a high strength HDPE geonet core with nonwoven polypropylene filter fabrics bonded to both sides. AQUADRAIN G25 is designed for horizontal and vertical applications requiring very high compressive strength properties with low to moderate flow properties.
VOLTEX DSCR is a highly effective waterproofing composite of high strength geotextiles,1.10 pounds of contaminant resistant sodium bentonite per square foot, and a integrally bonded polyethylene liner. The high swelling, low permeable, contaminant resistant sodium bentonite is encapsulated between the two geotextiles.
A Drainage Composite consists of a polypropylene drainage core of fused, entangled filaments and a non-woven polypropylene filter fabric bonded to the top side. The entangled filaments are molded into a square waffle pattern that maintains this flexible design.
A stormwater retention and drainage composite product consisting of a 3-dimensional polystyrene formed dimple core providing compressive strength to support subsequent layers. The formed dimple core retains stormwater but allows excessive stormwater to drain through drainage holes in the top of the drain board.
The next generation of waterstop that expands upon contact with water to form a positive seal to stop water ingress through cast-in-place concrete construction joints and around pipe penetrations. Through the use of the patented XP technology, WATERSTOP XP is proven effective in a wide range of contaminated environments.
A flexible, self-sealing, hot-applied, rubberized asphalt waterproofing system. STRATASEAL HR combines decades of membrane polymer experience and advanced mineral enhancement technology into a 100% solids thermoplastic product that is flexible as well as self-sealing. In the unlikely event of damage to the membrane, the advanced adhesion ...
A single-component, trowel-grade moisture cured polyurethane mastic, M-2000 LIQUID FLASHING is used with CETCO Waterproofing Systems to detail primarily at membrane terminations, around horizontal deck penetrations and transitions, over grouted concrete form-tie holes, and provide fillets to inside wall corners. Available in 18.9 Liter (5-gallon) ...
A single component, moisture cure modified polyurethane waterproofing membrane. LDC 60 is cold fluid applied and cures to form a seamless, elastomeric membrane that is positively bonded to the substrate. LDC 60 provides a quick and easy means of installing a cold fluid applied waterproofing membrane on both horizontal and vertical surfaces to ...
A elastomeric waterproof membrane, LDC 60 cures to form a seamless barrier that forms tenacious bond to concrete to prevent lateral water migration. The inherent toughness and elasticity of LDC 60 enables it to bridge small structural or shrinkage cracks which may develop in the substrate.
A polyurethane-based caulk grade swelling paste, AKWASWELL is used primarily to seal rough surfaces in concrete construction joints. Swelling up to 500% of its initial volume when hydrated by water, it creates a positive seal and stops the flow of water through the joint and is suitable for low to moderate hydostatic pressure conditions.
A two-part prefabricated sheet drain composite consisting of a 3-dimensional polypropylene formed dimple core covered with a woven polypropylene filter fabric bonded to oneside. The formed-dimple core provides compressive strength and collects water for flow to drainage discharge pipes.
HYDROBAR TUBES are a detailing accessory product for CETCO Waterproofing Systems used at the footing/wall junction to provide additional waterproofing protection. HYDROBAR TUBES consist of a thin, watersoluble tubing filled with granular sodium bentonite. When wetted, the tubing dissolves, allowing the bentonite to hydrate and form into a dense, ...
A trowel-grade bentonite-based mastic that is used to detail at membrane terminations, around penetrations, over grouted concrete form-tie holes, and provide fillets to inside wall corners. Unlike most mastics, this premium mastic is capable of swelling and self-sealing upon hydration and is VOC compliant. Bentoseal can be covered with a ...
ENVIROSHEET membrane is supplied in 200 square foot rolls, 36” (914 mm) wide by 66.7’ (20.3 m) long. The rubberized asphalt is covered with release paper which is removed prior to installation. The membrane is cold-applied and self-adheres to a properly prepared and primed substrate. A cold-weather version.
A non-woven geotextile allowing drainage of stormwater from the growing media to the water management layer. In addition to retaining the fines of the growing media, it provides excellent laminar flow.
CORETEX is a unique low permeable, hydrophilic waterproofing product that utilizes an Active Polymer Core (APC) technology that is less permeable and more chemically resistant than traditional active waterproofing membranes.