Only show results available in Virginia? Ok

Waste Compliance & Regulations Applications

  • Premium

    Coating and Laminating

    MEGTEC’s experience and application know-how are at your command for tough drying and web handling applications such as slow-drying coatings and materials or thin film coating and laminating. Dryers can be equipped with a wide variety of nozzle configurations ranging from simple slot nozzles to sophisticated Coanda-style air bars and patented air foil systems. A full range of heat sources are available including steam, direct and indirect gas-fired, thermal oil, electric, hot water and IR. In addition, the air handling systems can be integrated into the dryer enclosure or stand-alone for remote installation. When the process requires pollution control systems for solvent-based applications, MEGTEC also offers regenerative thermal oxidizers, solvent recovery, distillation and purification systems. MEGTEC also offers waste heat recovery packages to “close the energy loop” between pollution controls and the process, in order to reduce production costs and increase customer profits

    By Babcock & Wilcox MEGTEC based in De Pere, WISCONSIN (USA).

  • Premium

    Recycling equipments for electronic waste recycling (WEEE)

    The content of WEEE (electrical and electronic waste) gives recyclers various initiatives for recycling. It contains hazardous substances, such as lead, mercury or certain flame retardants, as well as precious metals like gold and silver. In 2012 approx. 64,900.000 ton electronic goods where produced and 49.000.000 ton electrical and electronic waste (WEEE) was generated. As the amount of sold electronic goods rise, the amount of WEEE rises. It is vital that this waste is taken care of properly.

    By Eldan Recycling A/S based in Faaborg, DENMARK.

  • Premium

    Very large waste gas volumes with low contaminant concentration

    The CTP desorption allows for an especially high concentration factor which, in turn, reduces the cost of ownership and permits an auto-thermal operation (additional burner switched off) even when the contaminant concentration is low.

  • Premium

    Metal Sorting - End of Life Vehicles Scrap Sorting

    Using modern TOMRA sorting technology you can generate clean non-ferrous metal fractions in your daily shredder operation. The processing of valuable scrap metal gains more and more importance worldwide. The aim is to generate clean, mono-fraction products from this very complex stream of End of Life Vehicles scrap metal material using suitable separation procedures. And that is worthwhile; End of Life Vehicles scrap processing does not only preserve natural resources of raw material, but it is also considerably cheaper. Compared to the aluminium production from primary raw material, using secondary material from End of Life Vehicles saves around 90% of the energy demand.

    By TOMRA Sorting GmbH. based in Mülheim-Kärlich, GERMANY.

  • Premium

    Electronic scrap shredding for the electronic waste management industry

    One of the greatest challenges facing our society is the reclamation of valuable raw materials from electrical and electronic scrap. A global scrap volume exceeding 40 million tonnes a year – a figure forecast to double by 2025 – presents both a challenge and an opportunity. Since even in Germany only some 40% of scrap is currently fed into a waste management process, we may assume that the global rate of waste management is still substantially lower. With additional support from WEEE Directive legislation, this represents enormous growth potential for recycling companies in all consumer-oriented markets.

    By Erdwich Zerkleinerungssysteme GmbH based in Igling, GERMANY.

  • Premium

    Metal Sorting - Electronic Scrap Sorting

    The recycling of disused and obsolete electrical and electronic equipment is gaining more and more importance world-wide. Waste electrical equipment is an incredibly rewarding source of raw materials. In Waste electrical equipment, up to hundreds of times more precious metals can be found per ton of material than in the primary source of raw material, ore. The goal for TITECH and the industry as a whole is to utilise electronic scrap recycling and sort out pollutants on one hand and profitable components in high purity on the other. For electronic recycling purposes, the EU classifies W??? into 10 categories. After separate collection of TVs, fridges and so on, they are processed and sorted in electronic scrap recycling systems. The average content of thus gained materials is as follows: metals (50%), plastics (30%), glass (10%) and other materials (10%).

    By TOMRA Sorting GmbH. based in Mülheim-Kärlich, GERMANY.

  • Premium

    Continuous emissions monitoring in waste incineration plants

    Waste-to-energy through incineration of waste is an effective way of producing electricity and heat, at the same time getting rid of the possibly hazardous or unrecyclable waste. The waste can be incinerated at specific WtE plants or at plants with permission for co-incineration of waste at biomass boilers or cement kilns. The waste incineration plants are, however, governed by strict emissions regulations.

    By Gasmet Technologies Oy based in Helsinki, FINLAND.

  • Premium

    Portable and fixed gas analysers for landfill perimeter monitoring

    Controlling potentially explosive and asphyxiate gases from escaping off site is important for meeting Health and Safety standards and protecting the local environment.

    By Geotech based in Leamington Spa, UNITED KINGDOM.

  • Premium

    Recycling and processing of WEEE

    Next to processing shredder light and heavy shredder fraction the Ad Rem machinery is also capable of processing waste of electrical and electronic equipment. WEEE can be processed on the same machinery as ASR is processed without any modifications. This makes it possible to get more input into the system and therefore costing less per ton.

    By AD REM N.V. (Valtech Group) based in Menen, BELGIUM.

  • Premium

    Environmental testing & compliance screening for energy/environmental sector

    Compliance screening and testing is often carried out during the manufacturing phase of a product, and all the way through its disposal or recycling process. It ensures that products and materials meet specific standards or comply with international and local directives or regulations. These standards and regulations are introduced to ensure the quality and safety of a product, and to minimise or eliminate its negative impact on the environment and people. Examples of products or materials tested are: electrical and electronic equipment (for compliance with the Restriction of Hazardous Substances (RoHS) directive), waste oils, soil (soil remediation depending on contents of toxic metals), children’s products (for compliance with Consumer Product Safety Improvement Act of 2008), etc.

    By Oxford Instruments plc based in Abingdon, UNITED KINGDOM.

  • Premium

    Food Waste Recycling, Reduction or Disposal Systems for Mining Oil & Gas Exploration

    Oil and Gas Pipeline Labour Camps: With applications across Turkey, Azerbaijan and the former Russian State of Georgia, Tidy Planet are suppliers to 7 different locations for large scale equipment to generate energy from the food wastes at these 400-2000 person sites. With the sites needing a solution that prevents waste being backhauled many miles to registered facilities, having a robust unit on hand that generates the heating and hot water for the kitchens, shower block and laundry is ideal. The Dragon is a scalable solution and can be provided for sites with 200-10,000 staff on site. •Remote Mines & Mine Labour: Treating food wastes at source in remote applications where landfill or uncontrolled dumping of wastes is no longer permitted, on site Rocket composting to allow the use of a composted end product for land remediation is often chosen. Otherwise as with oil & gas the Dragon food waste / energy system a preferred alternative providing a simple method of energy generation

    By Tidy Planet Limited based in Macclesfield, UNITED KINGDOM.

  • Premium

    Methane and Carbon Dioxide Sensing for Landfill Applications

    Application: In March 1986 an explosion destroyed a bungalow adjacent to a landfill site in Loscoe, Derbyshire. Subsequent measurements showed that 150-200 cubic meters of gas per hour were being generated by landfill waste. This event triggered a change in the way the waste industry considered and regulated gas generated at landfill sites; resulting in the landfill regulations of 2002, and in particular LFTGN03: the Guidance on the Management of landfill Gas.

    By Edinburgh Instruments Ltd based in Livingston, UNITED KINGDOM.

  • Premium

    Shredders for Electric and Electronic Equipment (WEEE) and Refrigerators

    Electric and electronic waste (WEEE), are coming from technology products such as home appliances (washing machines, vacuum cleaners), computers and tools. An economy based on the consumption such as today, provides a continuous increase of WEEE, and determines an increasing risk of dropping out in the environment or in landfills, with the consequences of pollution of soil, air, water and health human repercussions. These products should be handled properly and used for the differential recovery of the materials they are made of, such as copper, iron, steel, aluminum, glass, silver, thus avoiding a waste of resources that can be reused to build new equipment in addition to the environmental sustainability.

    By SA Eng Soluzioni per l`Ambiente based in San Donà di Piave, ITALY.

  • Premium

    Evaporation technology for graphic arts, pulp & paper & textile industries

    Different industries with many different challenges to face. All of them have to find efficient and effective solutions to optimize the available resources for an ever more high competitiveness and, contextually, to comply with the most stringent regulations about the protection of the environment.

    By EVALED - Veolia Water Technologies based in Zoppola (PN), ITALY.

  • Premium

    Shredding of electronic waste with Mercodor equipment

    For optimal processing of electronic waste, it is especially important to yield secondary raw materials that are as pure as possible. For this purpose Mercodor, with its rugged, compact precision cutters, has exactly the right solution.

    By MERCODOR GmbH Sondermaschinenbau KG based in Frankfurt am Main, GERMANY.

  • Premium

    Shredders for Hazardous and Medical Waste

    SA Eng. designs and manufactures single machines and / or complete plants for the treatment of Hazardous Waste. The supply can relate to the single shredder used only for the volume reduction of the material or to imply the use of a Nitrogen Blanketing System of the machine and / or of the complete system with subsequent separation of the product. SA Eng. provides for the study of customized systems in compliance with the specific need/request of each customer.

    By SA Eng Soluzioni per l`Ambiente based in San Donà di Piave, ITALY.

  • Premium

    Industrial wastewater solutions for clearcat crystal-clear distillate from used coolant emulsions

    Metal-working factories generate a lot of oily effluent as a result of manufacturing processes. The coolant emulsions tailored to the individual application contain oils, waxes, greases and preservatives, as well as a cocktail of ingredients to improve product properties. The emulsions used must not be discharged untreated into the drain system or open bodies of water; they must be disposed of at high cost.

    By H2O GmbH based in Steinen, GERMANY.

  • Premium

    Evaporation technology for oil & gas industry

    The oil & gas industry faces water and wastewater treatment specific challenges. EVALED evaporators represent an effective solution for both downstream (onshore and offshore) and upstream plants, allowing ZLD (Zero Liquid Discharge).

    By EVALED - Veolia Water Technologies based in Zoppola (PN), ITALY.

  • Premium

    Evaporation technology for waste industry

    The leachate produced by the waste in the landfill is an extremely pollutant effluent that requires high effective treatment processes to comply with the very strict limits for discharging operations. EVALED evaporators are a technological solution which allow to exploit the biogas cogeneration for the full or partial power supply of the plant within the limits of the environmental regulations and to reduce the relevant costs for thermal energy and leachate disposal.

    By EVALED - Veolia Water Technologies based in Zoppola (PN), ITALY.

  • Premium

    Shredding and crushing systems for electronic waste

    For optimal processing of electronic waste, it is especially important to yield secondary raw materials that are as pure as possible. For this purpose Mercodor, with its rugged, compact precision cutters, has exactly the right solution.

    By MERCODOR GmbH Sondermaschinenbau KG based in Frankfurt am Main, GERMANY.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you