Water Pumping Equipment Near Papua New Guinea
-
Manufactured by Mueller Water Productsbased in CANADA
The 106-RPS-D and 206-RPS-D pressure differential sustaining valves are based on the 106-PG or 06-PG main valve. The RPS-D uses the 81-RPD pilot valve and has two sensing connections. The valve and pilot remain closed until the difference between the two pressures exceeds the pilot setting. Under flowing conditions, the pilot reacts to small changes in pressure to control the valve position by ...
-
Manufactured by Mueller Water Productsbased in CANADA
The SAP surge anticipator panel provides the interface between a customer supplied, system pressure switch and the Singer surge anticipating control valve. Together they provide protection against destructive pressure surges. The SAP panel energizes the control valve pilot solenoid on an abnormally low pressure reading and/or power failure to pumps. The 12 VDC pilot solenoid is energized to open ...
-
Manufactured by Mueller Water Productsbased in CANADA
The 106-HC and 206-HC hydraulic check valves are based on the 106-PG or 206-PG main valve. The valve functions as a two position valve - either fully open or fully closed. The HC allows one way flow only. Under normal forward flow, the valve opens as the higher inlet pressure lifts the inner valve assembly and the fluid in the upper chamber is discharged to the lower pressure, downstream side of ...
-
Manufactured by Mueller Water Productsbased in CANADA
The 106-DW and 206-DW deep well pump control valves are installed in a tee between the pump discharge and the check valve. The valve is normally open, and, on pump start-up, a pilot solenoid is energized to start closing the valve at a rate governed by the closing speed ...
-
Manufactured by Mueller Water Productsbased in CANADA
The A106-Dynamic Lifter (DL) sewage pressure relief valve is a direct acting spring loaded relief valve. The valve is adjusted to open when the pressure exceeds the set-point, which is approximately 10% above the normal operating pressure. The valve closes drip-tight when pressure falls below the set-point. The DL is connected on a tee off the main line and usually discharges relief flow back to ...
-
Manufactured by Mueller Water Productsbased in CANADA
The 106-PT and 106-PTC series control valves are hydraulically operated by introducing or releasing water from the control chambers. PT and PTC valves have two operating chambers that are divided from each other by the diaphragm, and are separated from the flowing media by an adaptor ...
-
Manufactured by Mueller Water Productsbased in CANADA
The 106-PG-BPC or 206-PG-BPC booster pump control valve is installed in-line directly downstream of the pump discharge. The valve is normally closed, and, on pump start-up, a pilot solenoid is energized to slowly open the valve, at a rate governed by the opening speed control. The pipeline flow is gradually ...
-
Manufactured by Mueller Water Productsbased in CANADA
The 206-PT and 206-PTC series control valves are hydraulically operated by introducing or releasing water from the control chambers. PT and PTC valves have two operating chambers which are divided from each other by the diaphragm, and are separated from the flowing media by an adaptor ...
-
Manufactured by Mueller Water Productsbased in CANADA
The 106-BPC and 206-BPC booster pump control valves are installed in-line, directly downstream of the pump discharge. The pump control valve is normally closed and on pump start-up, a pilot solenoid is energized to open the valve, at a rate governed by the opening speed control. When shut-down is required the pilot solenoid on the valve is de-energized to commence closing. The pump is kept ...
-
Manufactured by Mueller Water Productsbased in CANADA
The Singer models 106-2SC-MV and 206-2SC-MV electronic flow control and metering valves are based on the 106-PG or 206-PG main valve. The pressure in the upper operating chamber is controlled by operating the pilot solenoids. The PLC within the MV1-TP control panel determines whether the opening solenoid or the closing solenoid is operated. The change in valve position is dependent upon which ...
-
Manufactured by Mueller Water Productsbased in CANADA
The SPC pump control panel provides the interface between the pump motor starter and the Singer pump control valve. The SPC ensures that the pump starts and stops without causing line ...
-
Manufactured by Mueller Water Productsbased in CANADA
Micrometer flow control valves allow for precise flow control. There is full flow in one direction and adjustable restricted flow in the opposite direction. They are standard on certain models, such as BPC pump control valves and available as an option for other applications. Standard end connections are female-to-female 1/4 in / 6.35 mm ...
-
Manufactured by Campbell Scientific, Inc.based in USA
The LevelVUE™B10 is a cost-effective, accurate, reliable solution for water-level measurements based on a non-submersible pressure transducer system. This type of sensor is a bubbler. Bubblers accurately measure the pressure it takes to create a continuous airflow in an airline submerged in water. The LevelVUE™B10 is designed for ease of use while providing long-term performance and accuracy. ...
-
Manufactured by Campbell Scientific, Inc.based in USA
The CPEC306 with EasyFlux® is a turn-key, closed-path eddy-covariance (EC) flux system for long-term monitoring of atmospheric-biosphere exchanges of carbon dioxide, water vapor, heat, and momentum. A complete system consists of a closed-path gas analyzer (EC155 closed-path gas analyzer), sonic anemometer (CSAT3A sonic anemometer), data logger (CR6 datalogger), sample pump, and accommodations ...
-
Manufactured by Campbell Scientific, Inc.based in USA
The AP200 is a complete, integrated CO2 and H2O atmospheric profile system. It measures carbon dioxide (CO2) and water vapor (H2O) concentration from up to eight intakes, which are normally spaced along the height of a tower to give a vertical profile. The AP200 is often used in conjunction with an eddy-covariance system to measure the storage term and provide you with a more complete measure of ...
-
Manufactured by Campbell Scientific, Inc.based in USA
The CPEC310 with EasyFlux® is a turn-key, closed-path eddy-covariance (EC) flux system for long-term monitoring of atmospheric-biosphere exchanges of carbon dioxide, water vapor, heat, and momentum. A complete system consists of a closed-path gas analyzer (EC155 closed-path gas analyzer), sonic anemometer (CSAT3A sonic anemometer), data logger (CR6 datalogger), sample pump, three-valve module ...
-
Manufactured by Campbell Scientific, Inc.based in USA
The LevelVUE™B10 is a cost-effective, accurate, reliable solution for water-level measurements based on a non-submersible pressure transducer system. This type of sensor is a bubbler. Bubblers accurately measure the pressure it takes to create a continuous airflow in an airline submerged in water. The LevelVUE™B10 is designed for ease of use while providing long-term performance and ...
-
Manufactured by PumpEng Pty Ltdbased in AUSTRALIA
The CorroTuff® Pump has been designed to efficiently pump dirty water from many types of duties from seepage sumps on tails dams to excavations below the water table to ballast pumping on barges. CorroTuff® is a small, robust pump capable of all the hard knocks and bumps that can occur on site. With six sizes to choose from, three 240v which all come with float switches and three 415v ...
-
Manufactured by PumpEng Pty Ltdbased in AUSTRALIA
The Raptor 5kW High Head Dewatering submersible pump offers a multitude of operating and cost saving benefits. The Raptor 5kW has a two part stator casing / junction box lid which reduces down time and on-going maintenance costs. Complete Flygt* stator casing change out kits are available. Flygt Interchangeable: BS ...
-
Manufactured by PumpEng Pty Ltdbased in AUSTRALIA
The new leader in underground dewatering submersibles with shotcrete management capability to help avoid clogged pumps. It is a heavy duty electro submersible pump with a high chrome impeller. ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you