Membrane Aeration Equipment For Water And Wastewater Available In Egypt
-
PremiumManufactured by ENVICON GmbHbased in GERMANY
ENVICON EMR membrane tube diffusers are available with different membrane materials and in various lengths. The standard lengths are 500, 750 and 1000 mm perforated length. Other lengths are available on request. In combination with the EBA variable adapter system, a wide range of requirements can be fulfilled. Our rugged, powerful diffusers are made in Germany and have been in use throughout the ...
-
PremiumManufactured by Fluence Corporationbased in USA
Upgrade Wastewater Treatment Plants with SUBRE; With increased urbanization, wastewater resource recovery facilities face new challenges. When a conventional activated sludge wastewater treatment facility has reached its limit, Fluence's SUBRE can come to the rescue. Instead of enlarging current plants and building new basins, SUBRE modules are submerged in existing chambers, improving effluent ...
-
PremiumManufactured by Fluence Corporationbased in USA
This revolutionary aerobic wastewater treatment solution is modular and reduces energy usage by up to 90% compared to conventional treatment. Activated sludge treatment has long been used for aerobic wastewater treatment, but its aeration stage is particularly energy-intensive, which makes it less cost-efficient as a step in decentralized water reuse. At Fluence, our self-respiring membrane ...
-
Manufactured by KHN Water Treatment Equipments Co., Ltd.based in CHINA
The key to the operation of fine bubble diffuser aerator in aeration equipment is the selection of fine bubble diffuser aerator. ABS engineering plastics are mostly used as the support plate of aerator, EPDM rubber is used as the rubber membrane tube, which has the characteristics of heat resistance, ozone resistance, acid and alkali resistance and good chemical stability. Compared with general ...
-
Manufactured by Raetts Rui Tian Electrical Technology Co.,Ltd.based in CHINA
The impellers in the air blower are mounted directly on the motor shaft for noncontact compression entirely without friction. Maximum operational reliability, even at high differential pressure is ensured by the arrangement of the bearings outside the compression chamber. The gas it has taken in through the inlet 1 channel 2. As it enters the side, the rotating impeller 3 imparts velocity to the ...
-
Manufactured by WILO GVA GmbHbased in GERMANY
With the latest generation of aerators, the ELASTOX-P plate air diffuser, we offer a new system component for sewage technology based on our extensive know-how and many years of experience in the production and operation of waste water treatment ...
-
Manufactured by Oxymo Technologybased in CHINA
PTFE membrane is made of polytetrafluoroethylene as raw material and made of per-tetrafluoro hollow fiber membrane material by special process. It has non-toxic, excellent chemical stability, temperature resistance, corrosion resistance and chemical resistance .The advantages of hydrophobic, high porosity, and pollution resistance are widely used in desalination of seawater brackish water, ...
-
Manufactured by Aquatreat bvbabased in BELGIUM
Air stripping or plate aerators remove volatile contaminants out of the liquid phase ( VOCl’s) because there is a transfer from liquid to gas phase. The most common problem on plate aerators is scaling of calcium carbonate and iron. To prevent this problem it is possible to continue dose an anti-scale product. These products are a safer option for the environment and people then common used ...
-
Manufactured by Oxybee Solutionsbased in INDIA
Our organization is a reputed manufacturer, exporter and supplier quality assured Industrial Ultrafiltration Systems. It is a latest and growing membrane based plant that is normally used for fine physical filtration. Offered systems are designed for a variety of industrial, commercial and municipal applications that requires high quality equipment with a fast delivery. These Industrial ...
-
Manufactured by INVENT Umwelt- und Verfahrenstechnik AGbased in GERMANY
The INVENT Coarse Bubble Aeration system (iCBA) has been developed and optimised for special applications in industrial and municipal wastewater treatment plants. It provides oxygen supply and optimal mixing during the biological phase, in particular for use in processes that use carrier media for biomass detention, whether moving-bed or fixed-bed ...
-
Manufactured by Huber SEbased in GERMANY
The HUBER VRM® process is a system of ultrafiltration membranes submerged within the aeration tank. The resultant high effluent quality meets the most stringent regulations whilst also allowing for the capacity to meet the increasing and higher disposal legislation anticipated in the future, with optimised investment and operating ...
-
Manufactured by ROTO Groupbased in SLOVENIA
The principle of SBR lifting technology All movement processes are performed by air lift pumps. The air compressor is very durable and quiet, it provides air to the aeration plate on the bottom of the tank. The distribution of air in the individual pump processes is realised via the control. Holiday mode - The SBR wastewater treatment system can be adjusted to changing conditions by altering the ...
-
Manufactured by KIK Kunststofftechnikbased in GERMANY
Fluidizing with PE-porös: Many dry bulk materials can be put into a fluid-like state by “fluidization”, in other words, passing air through them. This mobile state can be used for homogenizing or mixing, discharging or flow-conveying, drying or cooling, fluidized-bed sintering of powdered ...
-
Manufactured by Shubham Incorporatedbased in INDIA
Ultrafiltration (UF) is an important purification technology used for the production of high-purity water in the many industries.When strategically combined with other purification technologies in a complete water & Wastewater system. UF membranes used to remove high molecular-weight substances, colloidal materials, silt, turbidity, organic / inorganic polymeric molecules, algae, particulate ...
-
Manufactured by Blinex Filter Coat Pvt Ltdbased in INDIA
POLYPOR- Porous Plastic Filter Material of Polypropylene, PTFE, HDPE, Cellulose Acetate, and Polystyrene ranges from 5 to 250 microns. Form of rods, hollow pipes, sheets and joined parts of porous with a non-porous plastic and can be moulded as per your drawing and ...
-
Manufactured by Aqua Bio Technologiesbased in USA
The Pro-Air odor-control system utilizes natural forces to prevent reused wash water from containing an odor. Traditional methods of odor control are chlorine bleach, air spargers, bubblers, and ozone. These methods have all proven to be ineffective for year-round control of odors caused by anaerobic bacteria. The Pro-Air odor-control system includes an aeration pump and ...
-
Manufactured by SUEZ Water Technologies and Solutionsbased in USA
Lower energy costs, increase productivity, and lower your footprint with our latest Membrane Bioreactor (MBR). LEAPmbr* builds on 25 years of membrane bioreactor experience to deliver the most advanced MBR solution to date. It dramatically lowers energy costs, increases productivity, and offers a flexible design that can fit within a smaller footprint than conventional MBR technology. See how ...
-
based in USA
Lower energy costs, increase productivity, and lower your footprint with our latest MBR. LEAPmbr* builds on 25 years of membrane bioreactor experience to deliver the most advanced MBR solution to date. It dramatically lowers energy costs, increases productivity, and offers a flexible design that can fit within a smaller footprint than conventional MBR technology. See how GE offers our wastewater ...
-
Manufactured by Biomicrobe Technologybased in INDONESIA
All our EPDM membranes are low in plasticizer and they are available in inexpensive, free- heated and high quality spike heated version. The material thickness is 1.8 mm as standard, which guarantees long standing times when used in municipal wastewater. All membranes are selectable in lengths 500/750/1000 mm with diameters of 65 or 90 mm. On request we can deliver any length of membranes or ...
-
Manufactured by KLARO GmbHbased in GERMANY
The tried and tested: a two-stage, fully biological sewage treatment plant using the SBR process. The KLARO system is our "standard plant". It has been on the market since 2001 and has proven itself a thousand times over. Over the years, we have continuously developed the plant and added additional modules. The particular advantages of the KLARO are its robustness and flexibility. In sizes from 4 ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you