Oil Water Separation Applications

39 Results found
Only show results in Virginia?
OK
  • Category: Water & Wastewater ×

  • Subcategory: Oil Water Separation ×

High performance separation system for fuel gas streams

by Pentair Filtration Solutions, LLC     based in Conroe, TEXAS (USA)

Fuel Gas Streams are frequently contaminated with liquid aerosols. The liquid exists as a stable and persistent “smoke” in the gas stream. The liquid contaminant can enter the gas stream through any one of a variety of events including – phase separation and condensation, compressor lube-oils from compression, chemical addition to pipelines (including corrosion inhibitors), and entrainment from overheads of contact towers.

Oil Water Separation / Water Treatment - Chemical Reduction

by Hudson Industries     based in Vienna, OHIO (USA)

Adding Wilsa ElectroWaveTM technology to existing separation or water treatment can help reduce or eliminate chemical use. The Wilsa Effect can often take the place of surfactants, demulsifiers, sacle inhibitors and biocides to enhance separation and clarification.

High performance separation system for ethylene industry

by Pentair Filtration Solutions, LLC     based in Conroe, TEXAS (USA)

Fundamental building block chemical used in the production chain of polyethylene, PVC, styrene, ethylene glycol, vinyl acetate, linear ∂-olefins and a host of other chemical products. Eliminate hydrocarbons in Quench Water system, minimize fouling, provide greater system reliability, lower maintenance, lower energy costs. Quench water contains emulsified heavy aromatic hydrocarbon (SG = 0.975). Cracked hydrocarbons are extremely reactive. Polymerization leads to fouling of quench system, exchangers, dilution steam generator. Fouling reduces plant profitability and on-stream reliability.

High performance separation system for caustic treating industry

by Pentair Filtration Solutions, LLC     based in Conroe, TEXAS (USA)

The key aspects of a caustic treating system pertain to the degree of contact between the caustic and hydrocarbon to facilitate the mass transfer. Increasing the specific surface area of contact in a two phase system necessarily creates a tight emulsion. The product hydrocarbon often contains entrained caustic, which is not easily recovered by a simple water wash followed by a separator drum. The spent caustic is often regenerated with sour-naphtha stream that is used to extract the disulfide oils into the hydrocarbon phase.

Oil spill recovery

by DESMI A/S     based in Noerresundby, DENMARK

As the exploration for oil and gas enters areas of greater environmental vulnerability, the need for proven, reliable and robust equipment is doubly important. DESMI continues to answer this challenge with existing as well as specially developed oil spill recovery systems to operate in the most difficult and harsh environments known to man. This equipment is known as the ARCTIC range. This is a special tool kit of systems to enable you to successfully contain, recover and store hydrocarbons in the Arctic environment. In addition, we offer a range of ‘fail safe’ fire booms for use in controlled burning of oil in ice.

High performance separation system for sour water

by Pentair Filtration Solutions, LLC     based in Conroe, TEXAS (USA)

Hydrocarbons in the sour water system are typically present on a continuous basis at up to 10,000 ppm and during upsets to levels greater than 50,000 ppm. As little as 5,000 ppm Cat Naphtha lost to the sour water system from an FCC main fractionator overhead accumulator operating at 100 gpm water represents 262,800 gallons of potential product gasoline lost per year, with a recoverable product value greater than $500,000.

High performance filtration & separation system for frac fluid

by Pentair Filtration Solutions, LLC     based in Conroe, TEXAS (USA)

Proper fluid and proppant placement are critical to a successful propped fracture stimulation treatment. Despite effective placement of the treatment, well performance is often detrimentally affected by incomplete gel breaking and fluid recovery.

High performance separation system for lube oil industry

by Pentair Filtration Solutions, LLC     based in Conroe, TEXAS (USA)

Many lube oil recovery processes create aqueous and hydrocarbon emulsions that are difficult to separate by means of conventional liquid/liquid separations technology. Accomplishing the desired separation requires that these emulsified droplets be captured. Conventional coalescers are unable to provide the degree of brightness and clarity associated with good separation due to the inability to capture and remove the most penetrating droplets that indicate carry-over. Pentair Porous Media technologies have been developed to address the inherent deficiencies of the conventional coalescers.

Activated Carbon Filtration for the Water Filtration Industry

by General Carbon Corp.     based in Paterson, NEW JERSEY (USA)

General Carbon carries a complete line of activated carbon made from coal, coconut shell and wood for most liquid phase applications.  These include acid washed activated carbon for drinking water and food grade applications as well as products suitable for waste water remediation, decolorization applications, chemical and pharmaceutical purification. Additionally, our specialty medias are best for the treatment of non-emulsified oils and heavy metals. Our stock of activated carbon for liquid phase applications are all NSF certified, meaning that they are approved for treatment of food grade applications.


Several waste gas streams: Short, high concentration peaks and a constant |medium concentration

by Chemisch Thermische Prozesstechnik GmbH / CTP Air Pollution Control     based in Graz, AUSTRIA

Concentration peaks and liquid waste posed a tough challenge on the air pollution control system. With the CTP solution, this waste is not only disposed of but also reduces the burner energy considerably.

Oil Mist Separators for Shipbuilding

by contec GmbH Industrieausrüstungen     based in Bad Honnef, GERMANY

A  Contec oil mist separator (COMS), type 9.200/762, with special frame construction for the lubrication system of the energy supply is being used on the latest cruise ship of the Celebrity Cruises shipping line. The energy requirements of the cruise ship - built by Meyer Werft Papenburg - is covered by four MAN Diesel & Turbo SE, type 14V48/60CR, diesel engines. The Contec oil mist separator, type 9.200/762, with upstream demister and M6 filter cartridge ensures the reduction of particle contamination. Throughput: 1,200 Nm³/h @ 50 Hz.

Wastewater technology for the oil exploration and refinery

by AWAS International GmbH     based in Wilnsdorf, GERMANY

In the secondary recovery stage of an oil reservoir, process water plays a central role, just as in the extraction of natural gas. After the oil exploration, the produced water must be separated from the oil and gas. The process water needs to be prepared in order to be re-injected into the water cycle of production. For this purpose, highly efficient separation methods are required.

Innovative pump technology for energy industry

by EDUR-Pumpenfabrik Eduard Redlien GmbH & Co. KG     based in Kiel, GERMANY

Different temperatures, varying media – and always the demand for reliability, long service life and efficiency. EDUR additionally offer the principle of application-specific pump design.

Mixers, dryers, innovative solutions for chemical industry

by AVA - Huep GmbH u. Co. KG     based in Herrsching, GERMANY

We offer excellent process engineering solutions for the chemical industry in the fields of mixing, drying, evaporating, reacting, and granulating. Our ultimate goal is the satisfaction of our customers and a collaborative long-term partnership. The most up-to-date machines are at your disposal at our technology center in Herrsching, where you can carry out series of tests. Following delivery of the equipment, we support you from installation to commissioning and trial operation and assist you with maintenance and service tasks.

Absolute separation for the energy sector

by Vitone Eco S.r.l.     based in Bitonto, ITALY

Energy will have more influence in the future than in the past, not only in the economic field, but also in social and individual behaviours. VITONE ECO supports its customers in this important sector supplying with plants, which assure great efficiency and whose use fits into an idea of sustainable development. VITONE ECO offers solutions for the treatment of mineral oils and fuels from refineries and lagoons, dehydration of plants producing biogas, production processes of non-fossil fuels, such as biodiesel and bioethanol.

Oil Water Separator for Hydrocarbon Recovery from Flowback, Produced Brinewater

by Hudson Industries     based in Vienna, OHIO (USA)

Hudson Oil Water Separators can be used to reclaim more oil and hydrocarbons from flowback, produced water, brine water or waste water before sending this value stream to disposal/injection sites. To enhance recovery even further package a Hudson Separator with a Wilsa ElectroWaveTM Conditioner for ultimate results. Up to 99.999% of oil and hydrocarbons recovered, including emulsified oils. Please call us today to evaluate your recovery potential.

Salt Water Disposal - Operational improvements and savings

by Hudson Industries     based in Vienna, OHIO (USA)

Adding Wilsa ElectroWaveTM technology to existing separation equipment at Salt Water Disposal Wells (SWD) or Salt Water Injection Wells (SWIW) has a profound impact on the amount of oil can be recovered without using chemicals. Additionally there is a host of operational improvements and savings that result from the Wilsa Effect. Oil free solids settle out faster for cleaner, clearer brine for injection. Cleaner brine means less injection pressure and fewer acid jobs in the formation. Pump packings last longer by reducing solids and abrasive elements from the brine. More targeted solids settling allows for less tank clean outs. All of this adds up to significant operational savings.

Wilsa ElectroWaveTM Conditioning - Non-chemical water conditioning, break emulsions, enhance recovery

by Hudson Industries     based in Vienna, OHIO (USA)

Hudson Industries (a licensed partner) is now offering the patented Wilsa ElectroWaveTM Conditioner (EWC) for non-chemical water conditioning that provides enhanced oil recovery up to 99.999% with the power to break difficult emulsions. The Wilsa Effect is targeted at polar fluids, such as water. The Wilsa EWC directly targets the surface and interfacial tension of water molecules which breaks emulsions and forces the water to reject foreign matter such as oil and suspended solids. Furthermore viscosity is greatly reduced which allows the now coalesced oil to exit the water column with less friction, thus Stokes Law is fundamentally enhanced and retention time is greatly reduced. Combine the Wilsa EWC with your existing separation equipment or pair it with Hudson Coalescing Separator for maximum oil recovery/ removal. Contact us today for more information about Hudson Separators and Wilsa ElectroWaveTM Conditioning.

Need help finding the right suppliers?

Let the XPRTs do the work for you