Pressure Reducing Valves Equipment For Water And Wastewater Available In Virginia
-
ShowcaseManufactured by J.U.M. Engineering GmbHbased in GERMANY
Our model VE7 heated FID is being manufactured since 1974 and is the first heated THC analyzer ever built with a permanent back purge sample filter. It is still the most liked heated FID throughout the stack testing community due to its legendary ruggedness, forgivingness and long standing accuracy and sensitivity. The VE7 belongs to the very first total hydrocarbon analyzers being officially ...
-
PremiumManufactured by Synspec BVbased in NETHERLANDS
Synspec supplies the Fidstation RC product line of High Purity Hydrogen & Zero Air generators with compressor to supply all gases necessary to aliment the FID detector, close to the consumer, in an elegant 19” casing with full color display and touchpad. The FID Station is composed of a High purity Hydrogen generator and an Ultra Zero Air generator with on board Air compressor. Based on ...
-
PremiumManufactured by J.U.M. Engineering GmbHbased in GERMANY
Our transportable model 3-200 fully heated FID is successfully used throughout international markets for over 30 years. Also among other portable gas FIDs, the 3-200 It is the first ever built transportable fully heated FID using our proprietary back purge sample filter. It is widely distributed throughout the industry and the stack testing community and is much liked for its ruggedness, high ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
During the operation of gas insulated switchgear decomposition products might occur after a breakdown which has a negative impact on the gas quality in the circuit breaker as well as on the insulation properties. For this reason the measurement of decomposition products is very important. The measurement can be carried out easily by means of test tubes and plastic ...
-
PremiumManufactured by Gasmet Technologies - a Nederman companybased in FINLAND
Gasmet portable calibrator is one of the most important tools in generating new applications for the Gasmet FTIR gas analyzer. The calibrator incorporates a syringe pump, a manual needle valve, a mass flow meter, and a stainless-steel injection chamber. The syringe pump injects precise amounts of liquid or gas into a hot nitrogen gas flow, thus producing a continuous flow of a known concentration ...
-
PremiumManufactured by Particle Measuring Systems (PMS)based in USA
The Bubble Separator from Particle Measuring Systems is a welded PFA device that allows entrained bubbles in an ultrapure water (UPW) or process chemical sample to separate from the sample stream through buoyancy, prior to the sample entering the liquid particle counter. The UPW or chemical sample 1) enters the middle of the bubble separator and 2) separates at the tee, with 3) the liquid sample ...
-
PremiumManufactured by Mobiltex Data Ltdbased in CANADA
Pressure management and control in water distribution systems is a proven technique for reducing leakage and the frequency of bursts. Normally, a PRV (Pressure Reducing Valve) is set to a fixed outlet pressure to ensure a guaranteed minimum pressure to the critical point in the network during maximum flow ...
-
PremiumManufactured by F&J Specialty Products, Inc.based in USA
Model SRS-14MHT is a heavy-duty hand truck mounted low volume air sampler with an adjustable, aluminum sampling gooseneck. The adjustable gooseneck permits sampling at heights varying from 4′ to 7′ (122 cm – 213 cm) above floor level. The SRS-14MHT includes the GFCI protection and the card mounted filter holder with a quick disconnect ...
-
PremiumManufactured by F&J Specialty Products, Inc.based in USA
The Model SRS-28BMHT heavy duty hand truck mounted mobile low volume air sampler designed for outdoor use with an adjustable, aluminum sampling gooseneck. The adjustable gooseneck permits sampling at heights varying from 4’ to 7’ above floor level. Model SRS-28BMHT contains a standard rotameter for flow measurements. The air sampler is contained in a powder coat painted environmental ...
-
PremiumManufactured by J.U.M. Engineering GmbHbased in GERMANY
The J.U.M. Engineering HFID Model 5-100 is a compact 19" rack mount or table top heated total hydrocarbon analyzer for high accuracy, sensitivity and stability for pressurized samples with conventional sample back pressure ...
-
PremiumManufactured by J.U.M. Engineering GmbHbased in GERMANY
The J.U.M W600 Heated Total Hydrocarbon Analyzer is a very compact wall or panel mount heated FID analyzer to continuously measure the total concentration of hydrocarbons within a gaseous sample. This can be ambient air, exhaust gases from a combustion process e.g. stack emissions, from any type of an industrial vent, from an internal combustion engine, or from any other emission containing ...
-
PremiumManufactured by J.U.M. Engineering GmbHbased in GERMANY
Our HFID Model H100 is a compact heated FID analyzer for high purity hydrogen applications. The H100 measures low trace total hydrocarbon concentration in Hydrogen. For fastest response and highest accuracy except the pressure regulator all components in contact with sample are housed in a 190 deg Celsius heated oven.. The Model H100 is ideally suited for the detection of very low traces of ...
-
PremiumManufactured by Tecnidro Srlbased in ITALY
The valve reduces high upstream pressure to a pre-set lower and constant downstream pressure level, regardless of fluctuating flow or varying upstream pressure. A hydraulic regulating pilot drives the valve. The pilot is able to detect upstream pressure values and regulates closing steps of the valve until the pre-set pressure value is ...
-
PremiumManufactured by Tecnidro Srlbased in ITALY
IM-RP2 Pressure Reducing Control Valve with 2-Way ...
-
PremiumManufactured by J.U.M. Engineering GmbHbased in GERMANY
The J.U.M Heated Total Hydrocarbon Analyzer Model 3-700 FID is designed to be installed directly upstream of a FTIR analyzer (e.g. Gasmet) to continuously measure the total concentration of hydrocarbons within a gaseous sample. All controls which allow to calibrate the FTIR or FID individually are built in. Sources can be ambient air, exhaust gases from a combustion process e.g. stack emissions, ...
-
PremiumManufactured by HI-Q Environmental Products Company, Inc.based in USA
The BRL-3000M & BRL-3300M Series Retro-Fit Kits are for the conversion of Brushed, Shelter Type, High Volume units to complete Manual Speed Flow Controlled, 2 or 3 Stage Brushless Blower High Volume Air ...
-
PremiumManufactured by Synspec BVbased in NETHERLANDS
Synspec supplies the GCSTATION ULTRA RC product line of High Purity Hydrogen & Zero Air & Nitrogen generators with compressor to supply independently all gases necessary to aliment GC and GC/MS, close to the consumer in 2 elegant 19’’ Rack casing with full color display and touchscreen. The GCSTATION ULTRA RC is composed of an High purity Hydrogen generator and Zero Air and ...
-
PremiumManufactured by J.U.M. Engineering GmbHbased in GERMANY
The HFID Model 603 is a competitively priced, digitally controlled self extracting, heated total hydrocarbon analyzer for high accuracy, sensitivity and long term stability. It can be used in a 19' rack or as a table top ...
-
PremiumManufactured by J.U.M. Engineering GmbHbased in GERMANY
The J.U.M Heated Total Hydrocarbon Analyzer Model 3-600 FID is another low cost alternative to continuously measure the total concentration of hydrocarbons within a gaseous sample. This can be ambient air, exhaust gases from a combustion process e.g. stack emissions, from any type of an industrial vent, from an internal combustion engine, or from any other emission containing hydrocarbons. The ...
-
PremiumManufactured by Lenntech Water Treatmentbased in NETHERLANDS
Lenntech large reverse osmosis systems provide low conductivity water from brackish water. Lenntech units are ready-to-use, skid mounted, easy to operate. Compact design, low energy demand and high recovery; Fully automatic system, microprocessor ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you