Sludge Management Equipment For Water And Wastewater Near Australia
-
Manufactured by DDI Heat Exchangers Inc.based in CANADA
The 3 key advantages of our DDI technology are due to our Patented Technology of Rectangular channeled heat exchangers.It is not the common tube-in-shell technology nor the common Spiral structure of heat exchangers. WE BUY YOUR WASTE. Worlds only direct SLUDGE TO SLUDGE heat ...
-
Manufactured by Finnchain Oybased in FINLAND
Double deck tanks are sedimentation tanks located on top of each other. This solution is used especially when land use requires efficiency. The chain scraper systems in double deck tanks are often either combined surface and bottom scrapers or bottom scraper solutions. Maintenance and repair in such tanks is usually expensive and challenging, which is why the reliable performance of the chain ...
-
Manufactured by ANDRITZ Separation - ANDRITZ Groupbased in AUSTRIA
The PowerDrain gravity belt thickener is a highly efficient and economical solution for sludge thickening. Specially designed ploughs as well as the very large open area under the belt optimize the draining effect. Engineered and supplied by ANDRITZ SEPARATION for decades, the PowerDrain is a heavy-duty unit that operates in a size range of 5-20 m² drainage area. The large open area, special ...
-
Manufactured by Finnchain Oybased in FINLAND
Finnchain’s scum removal system enables sludge removal from large areas using continuous, natural water flow. The most common applications of the FinnFlow system are preliminary and secondary sedimentation tanks in which scraper flights transfer the sludge close to the FinnFlow collector. The water flow transfers the surface scum to a removal pipe, and clean water is transferred to ...
-
Manufactured by CSO Group Ltdbased in UNITED KINGDOM
The Lackeby Heat exchanger sludge / sludge unit consists of two heat exchangers sludge / water connected by a closed water circuit. This creates a compact unit that is simple to install and minimises installation volume. The closed water circuit between the heat exchangers eliminates the risk of digested or pasteurised sludge being contaminated by raw sludge. Circular sludge channels deliver a ...
-
Manufactured by Aquatec-Maxcon Pty Ltdbased in AUSTRALIA
Waste handling systems for treatment and recycling of water treatment plant process residuals - including sedimentation sludge, DAF float skimmings, filter backwash wastewater and chemical ...
-
Manufactured by Organica Water, Incbased in HUNGARY
Fixed-Bed Biofilm Activated Sludge (FBAS) is a type of Integrated Fixed Film Activated Sludge (IFAS) system that leverages the use of various natural AND engineered media to provide a habitat for a diverse fixed-film bacterial culture which metabolizes the contaminants in ...
-
Manufactured by ANDRITZ Separation - ANDRITZ Groupbased in AUSTRIA
A new standard in flexible, efficient and high-throughput dewatering. The ANDRITZ belt press CPF-Q is a continuously operating, heavy-duty belt filter press manufactured in a modular design with unique flexibility. In fact, we have been working closely with customers for more than 150 years to continuously improve the lifetime value of every machine. Our latest heavy-duty belt press is part of ...
-
Manufactured by Haigh Engineering Ltd.based in UNITED KINGDOM
The Macipump range of macerators with integrated pumping capability provide a unique, high performance solution for pumping solids in a ...
-
Manufactured by IST-Anlagenbau GmbHbased in GERMANY
Introduction: Any Sewage Water Work throughout the world will produce sludge, a form of biomass growing in the basins. This biomass has to be evacuated and is, generally speaking, difficult to handle! When liquid it has a dry matter of 3 to 4 %, or only 30 to 40 kg per ton of sludge. When mechanically dehydrated to 20 - 25 % dry matter, most of it is still water, on average 750 to 800 kg per ton ...
-
Manufactured by Finnchain Oybased in FINLAND
Lamella tanks are sometimes used for accelerating sedimentation processes. The space required for lamella installations has been taken into account in this bottom scraper system. Finnchain’s chain scrapers run over two sets of wheels, moving on sliding rails at the bottom of the tank, so there is space in the middle and above the chain system for installing lamella plates. Sludge at the ...
-
Manufactured by Komptech GmbHbased in AUSTRIA
In this process, various types of organic waste are prepared for liquid fermentation (dry matter less than 12%m). They can include packaging and contamination. Preshredding, using a Terminator and screen drum or Crambo, prepares the material for subsequent dissolution and contrary separation. The latter is done in 3 steps. Step 1 is pulping, step 2 is a combination of Multistar wet screening with ...
-
Manufactured by Organica Water, Incbased in HUNGARY
The Organica FCR is a complete wastewater treatment solution including solids removal, biological treatment/nutrient removal, phase separation, and final treatment for reuse quality (if required), all incorporated into a compact, single ...
-
Manufactured by ANDRITZ Separation - ANDRITZ Groupbased in AUSTRIA
The ANDRITZ drum drying system, DDS, dries and granulates different types of municipal, industrial, and agricultural sludges. The dewatered sludge is granulated in a mixer tailored to the application. It is then dried in the triple-pass drum (three concentric cylinders revolving around a joint axis) in a convective drying process to < 10% residual moisture. The sludge is conveyed pneumatically ...
-
Manufactured by Canadian Clearbased in USA
This is a Improvised Waste Water Treatment Process called as Activated Sludge Process. In this process Wastewater is Aerated for biological growth and settled by various treatment units. The treated water will be disinfected and filtered for secondary usage. We offer prefabricated units in MS-FRP and in Civil based ...
-
Manufactured by Hydroflux Epcobased in AUSTRALIA
The COANDA Grit Classifier was developed by HUBER in cooperation with the University of Munich, hydraulics department. Based on the Coanda Effect, the flow into the tank can be defined exactly and simulated mathematically. When operating at optimum flow,the grit separation is up to 98 % (grain size 0.2 ...
-
Manufactured by Canadian Clearbased in USA
Canadian Clearcan design, manufacture and supply clarifiers as per customer requirement. Clarifier is a unit, which is provided to reduce the escape of suspended solids and bio-mass with the sewage. It consist of circular/rectangular tank with a clarifier arm to scrape down the settled sludge through the sloped hopper to the sludge pit from where it is taken to the sludge treatment ...
-
Manufactured by ANDRITZ Separation - ANDRITZ Groupbased in AUSTRIA
Municipal sludge drying and granulation using waste heat. The patented ANDRITZ AG belt drying system (BDS) is characterized by its flexibility and ability to use a wide range of energy sources, particularly low-grade waste energy. BDS can be used for drying a broad range of products, such as industrial and municipal sludge, cow manure, biomass, as well as pre-treated municipal solid ...
-
Manufactured by Piian Systemsbased in USA
A small versatile Odor Control system for operation in freezing, high humidity, or corrosive conditions. For permanent installation into small tanks, inside small buildings, vent stacks etc - WWTPs, Sewage, Sludge, Tanks, Clarifiers, DAFs. This system is connected to a compressed air supply. The system generates a 1 micron odor neutralizing vapor from a super concentrated formula of Piian Odor ...
-
Manufactured by CSO Group Ltdbased in UNITED KINGDOM
The Lackeby Floating decanters are based entirely on gravity and differential pressure. The decanting pipe, which floats on the water surface with the help of floating pontoons, has evenly distributed decanting holes to create an even flow. Due to the floating design with decanting holes located just beneath the surface clean water is always decanted. The decanting holes are fitted with ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you