The ILS-1 In-Line Strainer separates and collects coarse solids larger than 1” (25 mm) in diameter found in typical institutional-type kitchen flows. This option is designed to couple with large Big Dipper Grease Removal Units (50 GPM and higher). How does the ILS-1 In-line strainer work? As kitchen effluent flows into the ILS-1In-line ...
Champion specializes in manufacture of In Line Basket Strainers to suit applications of various industries like Cement Plants, Petrochemicals, Oil Processing Industries, Drugs, Pharmaceuticals, Refineries and other Process Industries.
Safgard Angle Line Strainer/Filters; Sturdily constructed for continuous and extended service life. Strainer housing is 4' milk tube with large radius end cap for easy flush cleaning. Standard fittings are quick clamp type with maximum pressure rating of 100 psi. The standard filter frame is made of 14 ga. SS with ¼' hole perforations. ...
Safgard Straight Line Strainer/Filters Sturdily constructed for continuous and extended service life. Strainer housing is 4' milk tube with large radius end cap for easy flush cleaning. Standard fittings are quick clamp type with maximum pressure rating of 100 psi. The standard filter frame is made of 14 ga. SS with ¼' hole perforations. ...
The filter elements are replaceable. They have pleated stainless steel wire cloth or cellose over a metal support tube. Choose from six micron ratings, from 238 to 3. Machined aluminum, stainless steel and steel housings. Rated from 6 to 15-gpm (suction), 12 to 22 (return line). Mounting clamps sold as option.
The In-Line Power Jet Siphon is designed for use with two or more Fol-Da-Tanks. When the tanks are not close together, an In-Line Power Jet Siphon attached to two hard suction hoses assist water transfer from one tank to another. This keeps the main tank full of water for drafting as the secondary tank is refilled.
Pleated stainless wire elements are housed in Y-shaped housings for four times the element area of a typical Y-strainer. For suction and return line service. Pipe sizes 1/2 thru 2 in., with a choice of element ratings down to 25 micron. Other sizes available.
These line-mounted devices consist of a spring-loaded disc built into a reducing pipe bushing. They can be used to ensure flow through a partial-flow heat exchanger, provide required back pressure in drain lines, and many other places. Eliminates the need for more expensive relief and check valves, gets the same results. Various spring ratings.
The ultimate in sensible, workable suction and return line hydraulic (or other) fluids. Elements offered from 30-mesh wire to 3-micron paper. They are serviced through a clean-out cover. Housings are low-cost, large-diameter steel tubes. Port sizes from 1 to3-in. NPT.
The Model 53BTX Duplex Strainer will give years of trouble-free service, protecting expensive pipeline system components from damage by unwanted particles. cleaning, the Model 53BTX strainer is perfect for lines that must run continuously.
Designed for large-volume hydraulic fluid suction or return line service filtration, these are BIG Texas-size filters, with first-quality, large-area, cleanable filter elements in a low-cost package. Available in three sizes, with flow rate capacities to nearly 700 gpm and port sizes to six inches. Connections are female NPT.
Placement between flange according to DIN EN 1092-1, PN 6-40. From DN 125 to 300 placement with sealing between flange according to DIN EN 1092-1, PN10. Operational limits according to DIN EN 1092-1 and AD-Data-Sheet W10 . Overall lengths according to DIN EN 558-1 line 49, from DN 250 DIN EN 558-2 line 52. Identification according to DIN EN 19