Only show results available in Virginia? Ok

water test Applications

  • Premium

    Surface water quality monitoring

    By HORIBA Europe GmbH based in Leichlingen, GERMANY.

  • Wireless multiple parameter monitoring

    Monitoring multiple sensing points including fill level, pH, conductivity, and flow—often from varied locations in a large water treatment plant—can be a challenge. With four analogue inputs, a single SureCross Node can easily centralize and transmit critical monitoring information from multiple Sensors or controllers. Banner’s unique power management capability enables a single Node equipped with a FlexPower™ optimized QT50U or T30UX ultrasonic analogue sensor (level detection) to operate for years on a single DX81 battery power supply.

    By Banner Engineering Corp. based in Minneapolis, MINNESOTA (USA).

  • Premium

    Power-independent flow measurement with GPRS

    In a pit water purification system it was necessary to detect the discharge volumes. The operator wanted a regular and automatic transmission of readings. On the selected measurement place no mains power connection was available. Due to the risk of vandalism, it was not planned to install a switching cabinet. See the NIVUS solution for this measurement task here.

    By NIVUS GmbH based in Eppingen, GERMANY.

  • Water-Wastewater Measurements / NO analyzers for measurement of nitrification processes

    NO analyzers for measurement of nitrification processes applied for treating high concentration nitrogen wastewaters by microbial nitric oxide production. Also, the conversion of N-nitrosomines to nitric oxide for the quantification of those compounds in wastewater impacted waters. View Water-Wastewater Measurement Products

    By ECO PHYSICS INC. based in Ann Arbor, MICHIGAN (USA).

  • Measurement solution for high NH3 monitoring from wastewater

    Protea was asked to supply a high level ammonia (NH3) measurement system for a waste water treatment plant. The reflux drums at the inlet to two ammonia stripping towers needed to be measured continuously. Protea designed a solution based around our Solus TDLAS analyser platform and a high level dilution system. The Solus analyser was configured for NH3 measurements in the range 0-500ppm. A dilution system incorporating special dilution probe and 19` control panel was installed before the analyser. This gave a dilution level of 600:1, enabling the NH3 analyser to measure in the range 0-30% Volume.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you