Only show results available in Connecticut? Ok

wastewater tank Applications

  • Premium

    Channel Networks - Stormwater Treatment Facilities solutions for Discharge Control of Stormwater Overflow Tank

    Application: Pipe diameter 0.3 m, made of galvanised steel. Part filled. Low filling levels during night times.

    By NIVUS GmbH based in Eppingen, GERMANY.

  • Premium

    Volume Measurement Overhead Tank solution for Water Supply - Drinking Water

    Application: Pipe with 0.25 m diameter, made of cast iron. Full filled. Overhead tank featuring one single pipeline and flow in both directions.

    By NIVUS GmbH based in Eppingen, GERMANY.

  • Premium

    Stormwater Treatment solutions for logging of stormwater overflow tank without mains power sector

    Application: Stormwater overflow basin in main sewer. Discharge over concrete sill on basin. Remote location without mains power supply.

    By NIVUS GmbH based in Eppingen, GERMANY.

  • Wastewater evaporator Solutions for the vehicle and marina wastewater

    Cars, Boats, Trucks, Busses, Rail Cars, Aircraft, More... All vehicles – cars, boats, trucks, busses, rail cars, aircraft - must be regularly washed to remove road dirt and salt and other wastewater contaminates picked up from use, oil and solutions used for deicing. Boat wash wastewater, bilge wastewater and general marina wastewater present special problems for marina operators because of new regulations. As one example, the wash facility for a modest school bus garage can generate thousand of gallons of...

    By Draygon based in Venice, FLORIDA (USA).

  • Water quality solutions for ice prevention in potable water storage tanks

    Active Tank Mixing Prevents Damaging Ice Buildup. Ice in distribution-system storage tanks is an ever-present wintertime challenge faced by water utilities in cold climates. Ice can form a thick surface cap during prolonged periods of subfreezing weather. This alone can cause structural damage and water leakage but normal tank inflow & outflow can also create vertical movement of huge ice chunks increasing damage potential.

    By Medora Corporation based in Dickinson, NORTH DAKOTA (USA).

  • Zero Liquid Discharge wastewater solution

    Zero Liquid Discharge (ZLD) describes a process that completely eliminates liquid discharge from a system. The goal of any well-designed ZLD system is to minimize the volume of wastewater that requires treatment, process wastewater in an economically feasible manner, while also producing a clean stream suitable for reuse elsewhere in the facility. Interest in ZLD technology has grown in the industrial manufacturing sector over the past decade. Companies may begin to explore ZLD because of ever tightening wastewater...

    By ENCON Evaporators based in Hooksett, NEW HAMPSHIRE (USA).

  • Industrial wastewater solutions for crack detection wastewater

    Tracking the tiniest cracks – with H2O wastewater treatment. Heavy use, material fatigue and material faults can cause tiny cracks in plastic and metal parts. These are so small that they are invisible to the naked eye. But they can still be relevant to safety, e.g. on the wings of passenger jets. That’s why these parts are regularly checked for micro cracks. One way of doing this is the dye penetration process, where the part to be checked is first thoroughly cleaned. Applying a special dye and using...

    By H2O GmbH based in Steinen, GERMANY.

  • Pulsair`s industrial mixers for flue gas desulfurization industry

    Pulsair Systems is a leading supplier of efficient mixing system for Flue Gas Desulfurization (FGD) for over 25 years. Our mixing process is more effective and energy efficient than mechanical top-entry agitators, side-entry agitators and other types of mixers that are expensive and require more maintenance and consume more energy.

    By Pulsair Systems, Inc based in Bellevue, WASHINGTON (USA).

  • Industrial wastewater treatment systems for plating wastewater treatment

    Plating Wastewater Treatment Application: Wastewater generated from chrome and nickel plating operations. Prior Treatment Method: Chrome and nickel streams were segregated because of characteristics. Chrome was reduced from hexavalent to trivalent state then combined with the nickel stream. The full stream was then precipitated via typical hydroxide precipitation methodology. Broad swings in the contaminate concentrations resulted in poor treatment and the facility was issued several NOVs.

    By Ecolotron, Inc. based in E. Dickinson, TEXAS (USA).

  • Water and wastewater for infiltration/detention tank

    Depending on the required application, appropriate accessories and geotextiles or geomembranes are used.

    By Hidrostank SL based in Tafalla, SPAIN.

  • Prestressed Concrete Tanks for Wastewater

    Prestressed concrete tanks are the perfect solution for most wastewater processes:

    By Precon Corporation based in Newberry, FLORIDA (USA).

  • Solutions for Petrochemical

    Petrochemical plants, and especially their process water recovery plants, are a major source of air pollution. If odours are a recurring problem, the emission of greenhouse gases may also be particularly important.

    By PiĀ² Technologies Inc based in Montreal, QUEBEC (CANADA).

  • Bioremediation solutions for tank cleaning and degreasing

    When used to suppress toxic vapors and break down tank sludge, iSorb is a safe and reliable treatment before removing or maintaining underground and above-ground tanks. iSorb supports safe working conditions, minimizes tank downtime, and reduces waste-handling and treatment.

    By Beyond Environmental based in Geneva, ILLINOIS (USA).

  • Potable Water Storage Tank Mixing

    Inadequate potable tank mixing is a persistent problem for many municipal water systems across the United States, Canada, & the world. Simply put, tanks need consistent, effective, and reliable mixing. Test sample inconsistencies, thermal stratification, inconsistent water age, low disinfectant, and other DBP issues can all be mitigated with complete top to bottom tank mixing.

    By Medora Corporation based in Dickinson, NORTH DAKOTA (USA).

  • Water reuse solutions for storage tanks

    Mixing Is Key. Just like any other water tank, circulation is key to improve the overall quality. Tanks receiving reuse water most times suffer low dissolved oxygen due to higher than normal incoming BOD which in turn can cause odor issues. They also are vulnerable to faster sludge accumulations. By introducing the appropriate amount of mixing, many of these issues can be minimized or alleviated.

    By Medora Corporation based in Dickinson, NORTH DAKOTA (USA).

  • Odor control for refining/petroleum

    You refine the fuel, we’ll remove the odors. Oil refineries and petrochemical plants may generate large volumes of odor from the processing and refining of different fuels. Sulfides, mercaptans, and hydrocarbon compounds are all closely related to the oil industry. The odors generated from these industrial compounds are of a high nuisance value and generally create concern among local air boards and the public. Ecosorb odor removal products may be used in a variety of areas around the refinery including...

    By OMI Industries (OMI) based in Long Grove, ILLINOIS (USA).

  • Solutions for the large tank cleaning and degassing

    Rapid turnaround is essential when an oil or fuel storage tank is stripped for repair or scheduled maintenance. This time-sensitive process can be frustrated by the presence of high vapor levels and unpumpable sludge. Over the past 30 years, BioSolve Pinkwater has proven to be a worker friendly solution to these challenges.

    By The BioSolve Company based in Lexington, MASSACHUSETTS (USA).

  • Aluminium coverage for potable water storage tanks

    Aluminum domes are the preferred cover for potable water storage tanks. Whether it is an above ground elevated water storage application, the aluminum dome is the most durable and lowest lifetime cost solution for thousands of water districts throughout the world. No other cover design has the corrosion resistant properties of aluminum domes which makes it ideal for tough outdoor environmental challenges.

    By CST Industries Inc based in Kansas City, MISSOURI (USA).

  • Marine Fresh Water Tank

    Marine Fresh Water Tank used for water storage on the boat when sailing. Its advantages are handles welded around the perimeter allow for easy setup and packing, rapid deployment, large capacity, and low cost. If you have any need kindly let us know, we w

    By Space Bladder based in CHINA.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you