Water Aeration Equipment

1653 Results found
Only show results in Virginia?
OK
  • Category: Water & Wastewater ×

  • Subcategory: Water Aeration ×

Surfair

by PCPL - Patrick Charles Pty Ltd     based in AUSTRALIA

The Surfair is a direct-drive floating impeller pump type aerator. It’s simple design is based around a screw-type auger impeller rotating at speed within an enclosed tube. This allows for the lifting of large quantities of liquid through the tube that are then directed out over the surface of a basin or tank in a flat splash pattern to mix and ...

ASPIRO

by PCPL - Patrick Charles Pty Ltd     based in AUSTRALIA

The ASPIRO is a surface mounted self-aspirating propeller type aerator that draws atmospheric air below the water surface and transfers it via a hollow induction shaft into a highly mixed horizontal water stream not unlike the wake of a boat. This efficiently creates fine bubbles and mixes air and water into any lagoon, tank or other basin that ...

Model R-Series - Rotary Lobe Blowers: rugged and economical

by Gardner Denver Schopfheim GmbH     based in Schopfheim, GERMANY

These compact rotary lobe blowers belong to the group of dry running positive displacement pumps. This means that there is no need for oil or grease in the compression chamber. Only gear box and bearings, which are separated from the pumping chamber, are oil lubricated. Two non contacting triple lobed rotary lobe rotors rotate against each other ...

Roots - Universal RAI Blowers

by Pollardwater.com     based in New Hyde Park, NEW YORK (USA)

For assistance in sizing a blower, please contact us and provide the following information: CFM and PSI required. Altitude of installation if over 2000 ft. Maximum ambient temperature.

Diffusers

by Alphafluid Hydrauliksysteme Müller GmbH     based in Pliezhausen, GERMANY

Various aspects have to be taken into consideration when dealing with the dimensioning of containers of fluidity circuits. As a result there will be no failures or problems during later operation. An important factor is the rotate time of the medium. Problems concerning the air- and dirt precipitation will occur should the rotate time be too short ...

Model Air-get - Oxygenation System

by SCM Tecnologie     based in San Giorgio, ITALY

This oxygenation system makes it possible to simultaneously aerate and mix any type of industrial and civil liquid.

Brush Aerotors

by SAS Treatment Systems     based in ÇAYIROVA, TURKEY

Brush aerators aerators have a important location within aerators which carry out mixing and aeration in the biological treatment plant. Particularly; they are used oxidation ditches and carrousel systems, for which nitrification and denitrification is carried out in the same tank volume. While current is created toward front with rotor's ...

SIGMA - Model 100 hp - Low Speed Mechanical Surface Aerators

by Purestream ES, LLC     based in Walton, KENTUCKY (USA)

The Purestream Sigma low speed surface mechanical aerator is the result of years of development and refinement from hundreds of successful installations. The Sigma aerator offers the user unsurpassed durable construction, flexible design and maximum efficiency for wastewater treatment. These features make the Sigma Aerator the most cost-efficient ...

BWT - Disc Fine Bubble Diffuser

by BIOWATERTECH PRODUCT (BWT)CO., LTD.     based in Guangzhou, CHINA

Structure: 1.Membrane:Adopted the EPDM/Silicone  to melt. It can restrain the ageing effectively of the membrane, and protract the using life over 8 years. 2.Slit Hole :Adopted the '^' shaped for perforating to prevent adverse of waste water effectively and the bubble would be less than 0.3nn during aeration. 3.Base :Made by PP+FIBER GLASS , ...

Membrane Aerator Elastox-R

by IFO Vattenrening, AB     based in Bromma, SWEDEN

Exchange old ceramic pipe aerators to avoid the problem of stowing which leads to a reduction in the vital biological cleaning effect. A sufficiently flexible rubber material is more suitable for a fine dispersion aeration system. A large number of fine air holes are opened only by working pressure – and are closed afterwards automatically. ...

Ceramic Fine Bubble Diffusers

by Diffused Gas Technologies Inc.     based in Lebanon, OHIO (USA)

The Diffused Gas Technologies, Inc. Ceramic Fine Bubble Diffusers were developed for use in environments which require the delivery of fine gas bubbles in extreme duty applications. Ceramic fine bubbles diffusers have consistently delivered the highest gas transfer rates of any type of diffuser devices available. The relatively small bubble ...

Lagoon Aeration

by ATAC SOLUTIONS LTD     based in Maidstone, Kent, UNITED KINGDOM

Lagoon aeration is used to improve the BOD levels within a given lagoon. We’ve achieved 25% improvement in Ashford Common Clean Water Site, on request of Thames Water.

Toro ProCore - Model 648 (09200) - Turf Cultivation

by Miller Lawn & Power Equipment     based in E Marion, OHIO (USA)

From the innovative wheels within the coring path, to the large 48 in. (122 cm) aeration swath, there's nothing ordinary about the ProCore® 648 aerator. Years of research, customer input, testing and attention to detail went into making the ProCore® 648 the most productive and efficient walking aerator on the market.

Ceramic Diffusers System

by O I Filtration Ltd     based in Barlaston, UNITED KINGDOM

Diffuser aeration is used in a wide range of environments which require the delivery of bubbles into the liquid. Bubble sizes are controlled by the volume of gas injected into the liquid and by the particular grade size of the ceramic media used. The matrix pore structure of the ceramic is predominantly formed and will provide consistent high ...

KAMPS - Model AIRMAX - Low Speed Surface Aerator

by KAMPS s.a.     based in Battice, BELGIUM

KAMPS supplies the surface aerators AIRMAX. The low speed vertical shaft aerator AIRMAX presents all the required qualities for efficient aeration of biological plants. The main advantages of the low speed surface aerator are: Very high oxygen input in standard conditions per unit. Stable oxygen input in time. Nearly no maintenance. Very high ...

TYPHOON - High Speed Floating Surface Aerator

by RWL Water LLC     based in Minneapolis, MINNESOTA (USA)

TYPHOON high speed floating aerators provide high oxygen transfer and effective mixing for wastewater treatment lagoons and tanks. The TYPHOON aerator produces high pumping rates with a low trajectory for intense air-to-water mixing, resulting in excellent oxygen transfer rates. Let our technical experts size and recommend a properly engineered ...

Malmberg - Bottom Aeration System

by Malmberg Water AB     based in Yngsjö, SWEDEN

Malmberg Bottom Aeration System has been carefully planned, from design to installation. The aeration system is made of membrane diffusers, tube diffusers or vertical diffusers.

Model SEP - Oxygen Generator

by Oxywise s.r.o.     based in Piešťany, SLOVAKIA

Oxygen generators produce gaseous oxygen from compressed air on site and offer a cost-effective, reliable and safe alternative to traditional oxygen gas supplies such as cylinders or cryogenic liquid. Oxywise oxygen generators are available in 20 standard models with capacity ranging from 0,4 to 150 Nm3/hour at 95% purity. The design is made ...

Titan - Model H2Oasis - Hydrogen/Oxygen Generation Systems

by Teledyne Brown Engineering Inc     based in Huntsville, ALABAMA (USA)

Interior Lighting, Split Chiller/Condenser, Ventilation Fans, N2 Purge Panel, Interface Panel: H2 Delivery/H2 Vent, Service Access Doors, H2 Generator (EC Series Shown), Interface Panel: Feedwater/O2 Vent, Hydrogen Generator Power Supply, Power Distribution Panel, Cable Trays, Engineered Deck, Walls, and Ceiling Load Design to Resist Wind Sheer ...

Fine Bubble Ceramic Disc Aeration System

by Aquarius Technologies Inc.     based in Port Washington, WISCONSIN (USA)

The Aquarius Fine Bubble Ceramic Disc Aeration System has been developed by our team of engineers with an unparalleled background of experience in the design, application and operation of wastewater treatment aeration systems. This experience comes with the knowledge that a high performance diffuser requires an equally well engineered piping ...

Need help finding the right suppliers?

Let the XPRTs do the work for you