Only show results in Virginia? Ok

Water Regulations Applications

  • Premium

    Circuit Board Cleanliness Testing

    Contamination of circuit boards can bring about severe degradation of insulation resistance and dielectric strength. Cleanliness of completed circuit boards is, therefore, of vital interest. For those companies who have established circuit board cleaning procedures, the MIL Spec P-28809 has been used as a guideline for control. Now a simple `on line` test for the relative measurement of ionic contamination has been developed. This fast and economical method for testing circuit board cleanliness uses a Myron L Company Ultrameter II™ 4P or 6P, a suitable container, and a mixture of Dl (deionized) water and alcohol.

    By Myron L Company based in Carlsbad, CALIFORNIA (USA).

  • Premium

    Water treatment solutions for zoos industry

    Crystal-clear water in zoos and aquariums. Fresh water = marine animals and sea dwellers full of energy. By reliably treating salt water and fresh water, ProMaqua technology creates the optimum conditions for sharks, polar bears, turtles and other marine animals.

    By ProMinent Group - ProMinent GmbH based in Heidelberg, GERMANY.

  • Premium

    Water oxidation for private an public drinking water

    Carus permanganates have been used in private and public drinking water applications for more than 40 years. Municipal drinking water plants use CAIROX® and AQUOX® potassium permanganates, and CARUSOL® liquid permanganate in both ground water (well) and surface water for Pretreatment, Pre-oxidation and Organics Removal. Today, municipal water providers face increased challenges as more stringent regulations are enacted and public awareness regarding water quality becomes heightened.

    By Carus Corporation based in Peru, ILLINOIS (USA).

  • Premium

    Aeration and mixing technologies for municipal wastewater treatment

    Municipalities of every size are subject to public and governmental scrutiny of their municipal wastewater treatment efficacy. As effluent water quality regulations become increasingly stringent, Aeration Industries partners with municipalities to develop economical, environmentally friendly, and sustainable wastewater treatment solutions; customized for each unique environment.

    By Aeration Industries International (AII) based in Chaska, MINNESOTA (USA).

  • Premium

    Chemical Water Treatment for swimming pool water

    Kurita Water Solutions offers a wide range of products for the water treatment in swimming pools. These products have proven their efficiency over many years. The swimming-pool product range gives you the opportunity to choose your own maintenance program and allows you to operate your swimming pool hygienic and with no harm to human.

    By Kurita based in Tokyo, JAPAN.

  • Premium

    Industrial solutions for food and beverage industry

    Water is a precious and crucial resource in the process of food and beverage production. From screening to tertiary treatment, biological nutrient removal to water reclamation, WesTech equipment is designed to maximize efficiencies and minimize downtime, all while meeting the ever-tightening EPA regulations.

    By WesTech Engineering, Inc. based in Salt Lake City, UTAH (USA).

  • Premium

    Surface water monitoring

    The EU Water Framework Directive (2000/60/EC WFD) is probably the most significant international legislative instrument in the water field. Water management policy as set out in the WFD is focused on surface water as it flows through river basins to the sea. An integrated approach has been introduced for matters concerning water quality and water quantity and the Directive establishes a framework for water management based on river basin districts. Linked to the WFD objectives, a series of milestones has to be complied with, including monitoring programmes.

    By microLAN B.V. based in Waalwijk, NETHERLANDS.

  • Premium

    Water treatment solutions for food industry

    Metering and disinfection in the food industry. Perfect hygiene and precise metering are indispensable in food production. To achieve this, ProMinent supplies appropriate and reliable measurement, control and metering technology as well as various water disinfection systems.

    By ProMinent Group - ProMinent GmbH based in Heidelberg, GERMANY.

  • Premium

    Monitoring of phenol in water

    The Situation

    A plant located in the eastern United States manufactures phenolic resin for applications in plastics molding. This plant uses well water for cooling its reaction process and then discharges the water into a local creek.

    By Turner Designs Hydrocarbon Instruments, Inc. based in Fresno, CALIFORNIA (USA).

  • Premium

    Inspection of flow measuring equipment for hydraulic inspection

    Definition of Task: Metrologic inspection of flow measuring equipment according to German self-control ordination (EKVO). Inspection of flow measurement at relevant discharge point according to German regulations.

    By NIVUS GmbH based in Eppingen, GERMANY.

  • Premium

    Evaporation technology for graphic arts, pulp & paper & textile industries

    Different industries with many different challenges to face. All of them have to find efficient and effective solutions to optimize the available resources for an ever more high competitiveness and, contextually, to comply with the most stringent regulations about the protection of the environment.

    By EVALED - Veolia Water Technologies based in Zoppola (PN), ITALY.

  • Premium

    Ultraviolet Disinfection for Drinking Water

    Validated UV Systems for drinking water applications. Fully compliment with DWI Feb 2010 guidelines for primary disinfection and Cryptosporidium reduction.

    By atg UV Technology based in Wigan, UNITED KINGDOM.

  • Premium

    Water Treatment Solutions for Uranium Removal

    AdEdge provides treatment systems for for Uranium removal using AD92 an anion exchange media that is ideal for use in potable water as well as non-potable and environmental remediation applications for removal of naturally occurring uranium. The high efficiency AD92 can selectively remove the negatively charged uranium anion (most often in the form of uranyl carbonate) to below the existing EPA MCL of 30 ug/L. The AdEdge AD92 systems can deliver the needed performance in two ways: (1) via regeneration type systems which use the media to remove the uranium with periodic regeneration using NaCl brine; or (2) as a “throw away” discardable media, which can be discarded when spent. This option maximizes the very high capacity of the AD92. Where on-site regeneration is not available, this disposal option is the preferred option. Disposal options will vary based on federal, state, and local regulations.

    By Adedge Water Technologies, LLC based in Buford, GEORGIA (US) (USA).

  • Premium

    ppm Measurement of Oil in Water for the Petrochemical Industry

    Measuring the oil content in water or soil is a specialty of Wilks Enterprise. InfraCal TOG/TPH Analyzers provide on-site ppm measurements to help ensure upstream or downstream wastewater complies with discharge permits to avoid potentially costly fines. There are over 3,000 InfraCal TOG/TPH Analyzers in operation today around the world measuring the oil and grease levels in produced water on drilling platforms, oil content in FRAC water, hydrocarbons in wastewater effluents from refineries, and TPH in soil at remediation sites.

    By Spectro Scientific based in Chelmsford, MASSACHUSETTS (USA).

  • Pumping & wastewater treatment solutions for military & government sector

    When Uncle Sam comes calling, Smith & Loveless has dutifully enlisted itself for service in military and civilian applications. For decades, we have served our country with honor, providing long-lasting, durable water and wastewater treatment and pumping equipment that doesn`t tax the operator with heavy-duty maintenance and operation nor require audits from procurement authorities because of its long service life rating.

    By Smith & Loveless Inc. based in Lenexa, KANSAS (USA).

  • Waste water respirometry solutions for toxicity based consents

    Water companies, water authorities or publicly-owned treatment works (POTW) need to have some knowledge of the composition of the wastes they it receive. In addition to testing for ammonia and BOD or COD levels, treatment works can license industrial discharges on the basis of concentrations of some of the known toxic compounds. However, it is recognised that very many non-regulated toxic materials still enter the treatment works and reduce the efficiency of biodegradation, and may cause toxic shock. The way is now open for more widespread use of direct toxicity tests as a basis for toxicity-based consents. Samples of the industrial effluent are collected at source, for testing on the actual bacteria of the receiving activated sludge. The tests used are the Respiration Inhibition Test and the Nitrification Inhibition Test. Note that this approach mirrors that of the regulators of discharges to receiving waters, who are now using direct toxicity tests (DTA) or whole effluent toxicity tests (WET tests) in order to protect the receiving environment.

    By Strathkelvin Instruments Ltd. based in Motherwell, UNITED KINGDOM.

  • Water disinfection for the food and beverage industry

    Pure Aqua has a wide range of solutions for the varied sources of water and different types of contaminants. Pure Aqua understands the stringent potable water drinking regulations and has executed potable water projects exceeding the state requirements.  Components are specifically selected to meet NSF/ANSI 61 standard and we work closely with consultants to ensure project approval. 

    By Pure Aqua, Inc. based in Santa Ana, CALIFORNIA (USA).

  • Membrane filtration systems for reduction of BOD/COD

    Reverse Osmosis Polishers can concentrate BOD/COD from evaporator condensate and RO permeate streams to reduce waste water. Polished water can also be re-used in plant for boiler water make-up and CIP systems. In Dairy Industry applications, `polishing` of these process water streams aids in the production of Class I water for re-use from dairy products as defined and regulated under Food & Drug Administration rules. Water produced with this technique is also very soft, generally resulting in lower cleaning chemical consumption.

    By GEA Filtration based in Hudson, WISCONSIN (USA).

  • Airport Environmental Monitoring

    Water pollution from airport run-off is increasingly coming under public and government scrutiny. As environmental regulations tighten, the ability to monitor for aviation fuel contamination from runway run-off has become essential.

    Monitoring sites at airports can be extremely challenging often with no power or telephone lines available and with limited access for maintenance. Chelsea’s robust UviLux Hydrocarbon Sensor with its low power consumption and high accuracy is ideally suited for this application. Installed at various locations around the airport, deployed with it’s own integrated anti-biofouling system, utilising the GSM network, the monitoring sites send data to a secure ftp site, where any internet enabled device can access the data. In this way the systems act as any early warning system allowing any hydrocarbon discharge to be detected in real-time.

    Optional environmental monitoring features include remote control to allow the user to turn equipment on and off, change the sample rate and detection range. There is also a facility to allow SMS text and email alarm notifications triggered by user-defined set-points together with customised web pages, data displays and automated data downloads via an ftp server.

    Airport runoff can contain high concentrations of various pollutants, in particular polycyclic aromatic hydrocarbons (PAHs) and polychlorinated biphenyls (PCBs), the environmental levels of which have to be monitored. An understanding of the magnitude of contamination due to airport runoff water is important for the effective management of airport infrastructure. Chelsea’s robust UviLux Hydrocarbon Sensor with its low power consumption and high accuracy is ideally suited to the airport environment.

    By Chelsea Technologies Group based in West Molesey, UNITED KINGDOM.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you