Robust transport and metering solutions for mining. Our applications are not sensitive to chemicals, dust or heat and also work smoothly underground. Chemicals are always metered correctly and the process runs reliably.
Saving Money, Time, and the Environment Through Chemistry A General Process Philosophy Description of Elgin’s Drilling Fluid Dewatering Systems. The drilling industry is regulated by a myriad of environmental regulations that protect our air, water, and land resources. As these regulations continue to evolve, so too must the technologies utilized by the drilling industry. Though lowering compliance costs is always a worthy initiative, incorporating technology that also enhances the drilling process by...
Municipal water treatment facilities utilize continuous mixing to process drinking water for municipalities. There are a variety of drinking water sources and therefore different processing steps for the water. Processes utilize rotating and static mixing to treat the water for human consumption.
A tomato cannery needed additional treatment to remove suspended solids from their process wastewater. At Heron Innovators, we specialize in the design, development, fabrication, and installation of highly efficient SAF™ systems. A pilot trailer was placed at the plant and ran for two months during the 2012 processing season, proving the system’s capabilities and setting the stage for the customer’s order for a complete system to be installed.
Industrial drilling mud agitators and mixing equipment for oil & gas exploration. Pulsair Systems supplies oil & gas operators with industrial drilling mud mixer agitators for mud tank mixing. The Pulsair mixing process quickly allows drillers and operators to ensure homogenous mud consistency for their drilling mud needs.
Trisoplast’s roots are in the environmental sector. From the very beginning, it was used as a mineral bottom liner for landfills and remediation sites. The mining industry, too, was quick to adopt this product. More than 90 percent of Dutch landfills are now using Trisoplast, and our share of the global market is growing steadily.
The rapid growth of megastores and an increasing trend toward bulk purchasing contracts are exerting a downward force on packaged food profit margins. In the face of these challenges, plants must figure out how to increase production volumes while decreasing operating costs. ChemTreat has the solutions to help.
Packaging waste is mostly made up of different polymers, beverage cartons, paper and glass. Depending on the country in question, different collection systems apply and the material will invariably arrive in different conditions to the MRF’s (Materials Recovery Facility).
The key to understanding the production process of synthetic plastic, rubber, or fiber lies in the four principle methods commercially used in polymer production. All polymers and copolymers are made by either the use of one or a combination of methods. These methods are bulk, solution, suspension, and emulsion.
Problem: Drinking water plants that use surface water or ground water under the influence of surface water are susceptible to high levels of organic matter in the raw water. Reduction of organic matter through coagulation/sedimentation and filtration is important to lower the potential for disinfection by-product formation (DBP) and limit operational problems. In addition, organics in water consume the polymers used for the coagulation process, which reduces the efficiency of the treatment. Therefore, optimization...
Trisoplast’s properties also make this mineral liner extremely well suited to industrial applications. These include tank terminals, waste recycling centres, disposal sites, water treatment plants and shredder companies.
The use of white filling in coating, putty, floor filler, plaster production in the construction sector, ready plaster, putty etc. newly developing rin Turkey is very common is Europe and USA. In the construction industry, white colored, cement based plasters and putties are mixed with powder polymers and applied to the wall, thus solving the coarse plaster, fine plaster, putty and even paint processes at the same time. Various sizes of ground calcite are mixed with plaster, cement, powder polymer binders and are...
Calcite filling, which is mixed with polymers, has started to be used intensively in construction and automotive industries. The development in the adhesive industry has accelerated very much and the consumption amount has been much higher than expected.
This project installed a model SAF250 Suspended Air Flotation (SAFƒ) treatment system for a California food processing customer. They contacted Heron Innovators for a system to be used for wastewater pretreatment. At Heron Innovators, we build mechanically and electrically reliable systems, and provide installation support which comprehensively meets our customer’s operational needs. The system is ideal for food processing wastewater pretreatment for reducing TSS and BOD/COD in discharges to sewers.
TenCate Geotube technology provides cost-effective and sure dewatering and containment in a wide variety of industries. In Power and Utility, Pulp and Paper and other general industries that produce sludge, TenCate Geotube dewatering technology enables the recovery of valuable materials, provides structural stability, improves water quality, or just reduces storage footprint by sometimes 50 to 80%. The dewatering containers can be custom-sized to the application, placed in available space between other structures...