Only show results available in Virginia? Ok

Plasti-Fab Weirs, Sluices, Flumes, Gates Equipment

  • Plasti-Fab - H, HS and HL Flumes

    The H flume and related HS & HL flumes are gaining in popularity due to their ability to handle wide ranging flows that can vary by as much 100:1 or more from low to peak. Because of the unique throat, which resembles a weir in some respects, the H flumes provide excellent resolution at low flows and still have capacity to capture peak flow ...

    By Plasti-Fab, Inc. based in Tualatin, OREGON (USA). from Flumes Product line

  • Plasti-Fab - Stop Gate and Stop Plate

    Stop Gate and Stop Plate are interchangeable terms used to identify manually lifted gates that are installed in open channels. Stop gates are normally either in or out and do not include a stem or lifting mechanism. Smaller gates or gates with a balance (equalized) head can usually be raised by hand. Larger gates and gates with unbalanced head ...

    By Plasti-Fab, Inc. based in Tualatin, OREGON (USA). from Gates Product line

  • Plasti-Fab - Large Trapezoidal Flumes

    Trapezoidal flumes fall into two principal groups, 60º V-notch flumes and larger trapezoidal flumes. The 60º V flumes have a sharp V-throat section similar to a V-notch weir and produce superior resolution for accurate flow measurement down to 1 gpm. The larger trapezoidal flumes, up to the 2 foot SRCRC flume, have flat floors and ...

    By Plasti-Fab, Inc. based in Tualatin, OREGON (USA). from Flumes Product line

  • Plasti-Fab - Wedging Titeseal Gate

    The Wedging Titeseal Slide Gate is commonly used as an emergency shutoff gate. Developed and patented by John Vitas at Plasti-Fab, it is the tightest sealing slide gate available on the market today. The Wedging Titeseal® design is capable of reaching extremely low leakage rates: less than 100 cc/min/foot of wetted perimeter. This is 4 to 5 ...

    By Plasti-Fab, Inc. based in Tualatin, OREGON (USA). from Gates Product line

  • Plasti-Fab - Fiberglass Palmer-Bowlus Flumes

    The Palmer-Bowlus flume is well know in the sanitary field, and has been used in the Los Angeles area for over 60 years. It’s primary application is in pipelines, in round bottom channels or in manholes where it is often preferred because of cost and ease of installation that can minimize construction expense.

    By Plasti-Fab, Inc. based in Tualatin, OREGON (USA). from Flumes Product line

  • Plasti-Fab - Gray Fiberglass Reinforced Plastic Slide Gates

    Industrial Slide gates are commonly used in open channel and moderate head applications to isolate equipment, divert flow, close off a wall opening, or cover a pipe that is flush with the wall. Plasti-Fab slide gates are manufactured of gray fiberglass reinforced plastic containing ultraviolet inhibitors. Plasti-Fab penstock is reinforced to ...

    By Plasti-Fab, Inc. based in Tualatin, OREGON (USA). from Gates Product line

  • Plasti-Fab - Corrosion Resistant FRP Parshall Flumes

    Used in monitoring sewage, plant effluent, storm water and irrigation water the Parshall flume is still the best known and most widely used for permanent installations. It is available in throat sizes from 1 inch to 12 feet. Parshall flumes are available with numerous accessories and adaptations to match your flow and installation requirements. ...

    By Plasti-Fab, Inc. based in Tualatin, OREGON (USA). from Flumes Product line

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you