Gas Scrubbers Articles

  • Case study - Jämtlands Värme, Strömsund

    The boiler for Jämtlands Värme in Stromsund was built in 1987.  The old flue gas condenser, from another supplier, began leaking and needed to be replaced. Boiler: 10 MW Fuel: Bio fuels Condensor effect: 2 MW The boiler in Strömsund was built in 1987 and in 1994 it was equipped with a flue gas ...


    By Envibat AB

  • Coke Plant Scrubber Water Case Study

    Challenge For the production of coke, volatile constituents of the coal —including water, coal-gas, and coal-tar— are driven off by baking in an airless furnace at temperatures as high as 2.000 °C. The flue gas goes through an ammonia-based scrubbing process. The resulting scrubber water contain small coal-tar and other organic particles (1-250 micron) that cause scaling in ...


    By akvola Technologies

  • Case study - WESPs: Securing a cleaner future for power-generating facilities

    This article explains why wet electrostatic precipitators remain a viable technology for dealing with today's increasingly stringent compliance issues. Despite recent, recession-related volatility in both power generation and consumption, industry analysts expect a resumption of long-term growth trends as continued global demand for energy — in both developed and developing nations ...


    By Beltran Technologies, Inc.

  • Advanced WESP designs assure superior gas cleaning performance

    Nowadays, many industries are facing formidable environmental challenges and there is a growing need for effective, economical gas cleaning and air pollution control equipment. Michael Beltran of Beltran Technologies, Inc. reports on a renewed interest in high-efficiency wet electrostatic precipitators (WESPs) and discusses their importance for controlling sulphuric acid mists and other ...


    By Beltran Technologies, Inc.

  • Dry/Wet Scrubbers for Clean Air Compliance

    Air-scrubbing venturis and towers may be the answer to clean air compliance for small- to medium-sized companies. Forthcoming requirements of the Clean Air Act Amendments of 1990 will inventory many more specific chemicals considered hazardous. From acetaldehyde to xylenes, the list regulated under the air taxies program includes 189 hazardous air pollutants (HAPs). That number may ...


    By CR Clean Air Group, LLC

  • Chemical Industry: Ammonia Emergency Plan Calls on Packed Tower to Scrub Released Chemicals Case Study

    A few years ago Union Camp turned a corner. Management decided that advance planning would take the place of reacting after the fact to an emergency or regulatory agency demands. At Union Camp’s Dover, OH. facility, byproducts of the paper industry are converted into usable specialty chemicals for cosmetics, adhesives and other industries. Crystallization is a process used intensively with ...


    By CR Clean Air Group, LLC

  • Chemical Industry: Wet Scrubbing HCL & SiCl4 Fumes Case Study

    This two-stage scrubbing system utilizes a jet venturi scrubber in conjunction with a counter current packed tower including entrainment mist eliminator. It was designed to eliminate the HCl (hydrochloric acid) fumes generated when SiC14 (silicon tetrachloride) comes in contact with moisture during processing operations at a zirconium processing tank farm, and also the remaining small amount of ...


    By CR Clean Air Group, LLC

  • Automotive: At Sandvik Coromant, Clean Air Group Scrubber Handle Emissions Emergencies case study

    Mr. Tahvanainen heads up a staff of eight maintenance personnel and a supervisor. He is a mechanical engineer with a background in power production and thermodynamics. Editorial Background: Sandvik Coromant of Fair Lawn, NJ is part of Sandvik’s tooling division. The overall Sandvik Corporation employs 35,000 in one hundred and thirty (130) countries. ...


    By CR Clean Air Group, LLC

  • Optimizing the Slaking Process

    Poorly-slaked lime can have a major negative impact on lime consumption and the operating cost at an end-user’s site. The amount of lime used in the process is determined by a combination of slaking parameters. The optimisation of the slaking process will help drive operating costs down and also reduce CO2 emissions.  When the slaking of lime (ie, the conversion to calcium hydroxide ...


    By STT Enviro Corp

  • More to Scrubber Pumps than Meets the Eye

    One component, in particular, needs to be carefully selected to ensure safe and efficient sulphur removal. The time is now Shipowners are having to move fast to change fuel type to distillate fuel or LNG, or to install the exhaust gas cleaning systems (EGC systems) known as scrubbers. They’re reacting to new sulphur emission legislation set to come into force in designated ...


    By DESMI A/S

  • ReCyclone® EH: ZnO Reactor - ZnO Nanoparticles recovery - Case Study

    FOREWORD In 2009, ACS was approached by Innovnano, one important micro and nanoparticles of metal oxides manufacturer in Portugal to increase the yield of one manufacturing facility. Innovnano is a subsidiary of CUF, centenary in the chemical industry. CUF is the largest Portuguese chemical group, with production facilities in Portugal and Spain. ...

  • Combating Corrosion within Power Generation Facilities

    Just about every utility facility that generates power or engages in some form of incineration must deal with corrosion issues. Since the ac Air Act of 1990, gas-scrubbing technologics have increased the im serving the assets of power plants and othe incineration infrastructure. These demands will increase further with the advent of new mercury removal requirements to be phased in during e near ...


    By Sauereisen Inc.

  • NOx Scrubbing Technology Breakthrough

    Pacific Rim Design and Development and Dupont are proud to introduce a technology breakthrough in the treatment and safe elimination of problematic nitric oxide (NO) and nitrogen dioxide (NO2 ).  There are six forms of nitrogen oxide (NOx); the drawings to the right show the two most problematic forms.  These two are of particular interest because they are identified as atmospheric ...


  • Flux force condensation scrubbing

    Flux force condensation scrubbing technology is used to capture fine (submicron) particulate at extremely high efficiency. It is a preferred method when using wet scrubbing to collect and control dioxins from combustion sources. As an added benefit, through the use of condensation, the water vapor plume commonly associated with a wet scrubbing system can be effectively eliminated. The overall ...


    By Bionomic Industries Inc.

  • Hydrogen Sulfide Scrubber Systems in Hydrometallurgical Application

    Hydrogen Sulfide is a highly toxic and flammable gas. Being heavier than air, it tends to accumulate at the bottom of poorly ventilated spaces. Although very pungent at first, it quickly deadens the sense of smell, so potential victims may be unaware of its presence until it is too late. The lethal concentration for 50% of humans is 800ppm for 5 minutes of exposure. H2S is a by-product in many ...


    By Macrotek Inc.

  • Nitrification processes in scrubbing liquid of an exhaust air treatment system of a large-scale pig housing facility

    The use of multi-staged exhaust air treatment systems is an effective method of substantially reducing the emission of ammonia, dust particles and odorous substances. Wet filter walls are able to absorb large amounts of ammonia when scrubbing fluid containing sulphuric acid is used. In addition, due to their large surface areas and the permanent supply of oxygen and nutrients, wet filter walls ...


    By IWA Publishing

  • Pharmaceutical Gas Scrubbing - Case Study

    Application Novartis Ringaskiddy Limited needed to scrub a variety of aggressive acid and volatile organic compounds from the vents of pharmaceutical batch reactors. These make up part of the manufacturing process of a range of pharmaceutical ingredients. The compounds included HCl and methyl bromide fumes within air or nitrogen streams. System description ...

  • Pollution Systems VS-3 wet srubber removes grease and particulate

    A leader in the Food Industry has several Pork Sausage Cookers at their manufacturing site in Alabama.  Each cooker exhausts over 4,000 ACFM.  The streams are saturated with moisture and the pollutant load is pork grease.  Electrostatic Precipitators (ESP’s) have been installed to treat the exhaust.  However, the ESP's were not working well and have high maintenance and ...


    By Pollution Systems

  • Wet Flue Gas Desulfurization System

    Installing the optimum wet flue gas desulfurization technology, B&V Energy is bringing superior multi-pollutant removal technology to the North American utility marketplace. To help make a positive impact on the global environment and to comply with the Clean Air Interstate and Clean Air Mercury Rules, Dayton Power & Light needed to remain in compliance as more stringent air quality ...


    By Black & Veatch Corporation

  • Tri-NOx Multi-Chem Wet Scrubber. Case Study of Our NOx Scrubber in a Plastics Resin Plant.

    As part of a commitment to reduce airborne emissions – or even the threat of such emissions – the Mt. Vernon, IN plant of GE Plastics has installed a NOx scrubber. When such GE Plastics products as Ultem resins are produced, nitric acid is used, and emissions from this step are tightly controlled. But to address upset conditions, the company opted to install an emergency scrubber that can treat ...


    By Tri-Mer Corporation

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you