Sarnafil Roof Mold Problem EBB Cleaner Prep - Case Study

He bought a 5 gallon pail of our concentrated Contractor Grade Mold & Grime Cleaner Prep and had his crew dilute it 4-to-1 with water per instructions on the label. The crew coated the moldy roof areas with the Cleaner Prep solution, let it stand for 15 minutes, then used push brooms to easily scrub off the mold, dirt and grime.

After finishing the scrubbing process with the brooms, the crew hosed down the surface without any worry about harming bushes, grass and flowers near the downspouts.

The second photo shows a very clean roof after the mold clean-up process.

But the mold removal process was only step 1. The owner did not want to incur the time, cost and hassle of having his crew up on the roof scrubbing mold every couple months.

So immediately after hosing down the roof after the scrubbing process, he had his crew use a pressurized hand-pump sprayer with a fine mist nozzle to apply our Endurance BioBarrier Mold Prevention product.

Luckily, our Mold Prevention Spray can be applied to slightly damp surfaces. This benefit allowed the crew to immediately spray the damp, newly cleaned surface with EBB instead of needing to wait hours before spraying.

Months later, as seen in the third photo, the sarnafil roof was still mold-free thanks to Endurance BioBarrier and its ability to last through hundreds of wet-dry cycles.

Outdoor surfaces like this are guaranteed to remain mold-free for up to 2 years when Endurance BioBarrier Mold Prevention Spray is applied per directions.