Far Data Sp. z o.o. products

For all those who struggle with noise and vibration problems, we offer an automatic monitoring station. Unlike other systems, we provide a long-term monitoring solution with flexible expansion possibilities, guaranteeing savings of time and resources. Many years of experience in working with measurement systems allows us to state that information should be collected in an economically justified way, in order to obtain the best possible quality or quantity to price ratio. Accurate recognition of the problem gives a better chance to stop or significantly slow down the process of environmental degradation and, in the most optimistic scenario, which should be in the foreground, to reverse adverse changes.

Combating ubiquitous air pollution requires knowledge of atmospheric trends and high accuracy of measurement results. Continuous monitoring of selected pollution parameters supports decision-making processes and the development of air quality improvement plans. In different regions, different pollutants exceeding limit values may pose a threat. It is therefore important to be able to freely configure the station in terms of the selection of sensors.

Anemometer NP-3 is a device with a very solid construction (anodised aluminium) used for measuring wind speed in open areas. A special device bearing and labyrinth seal enables measurements even at very low wind speeds. The use of specially modified teflons reduces the need to lubricate the device. The use of anodised aluminium and stainless steel makes the transmitter completely resistant to corrosion and weather conditions.

The reconstruction and modernisation of motorways and expressways is a complex process in all countries. Where there are temporary restrictions due to road reconstruction or upgrading, safety and traffic flow aspects are important. Based on our research, we can identify the main factors that generate travel delays, which are often also the cause of accidents at congested road locations.

Installed across the roadway, it measures traffic flow, average and instantaneous vehicle speed and vehicle spacing, accurately classifies vehicles, and covers up to 20 lanes. The SmartSensor HD device is designed, developed and manufactured by Wavetronix specifically for motion detection. Each unit is built to the highest quality standards, rigorously tested and fully supported. It is the only radar traffic detector with patented True High Definition and dual radar beams, providing the most accurate vehicle data for ITS and planning applications.

detection of radio signals originating from Bluetooth (BT) transmitters in the 2.4GHz band and from WiFi transmitters in the 2.4 and 5GHz bands, used for communication between on-board devices installed and carried in vehicles and mobile devices used by drivers and travellers, identification of unique MAC hardware addresses, unambiguously identifying the signal source, calculation of transit times of vehicles moving between BT/WiFi detectors located at different points of the road network, based on the comparison of time stamps.