Kett Tool Company products

Replacing the KD-200, these variable-speed, double-cut shears feed quickly and quietly, without warping or bending your finished piece (distortion is in the waste strip). It easily follows a scribed line. The materials edges are not hardened or burred, so you get maximum use of a sheet. The swiping action of blades seals the edge of coated metals. These shears cut C.R. mild steel up to 18 gauge in straight or contour lines at over 300 inches per minute, most grades of stainless, aluminum to .080 and plastic or Formica up to 3/32" thick. These shears are also available with a contour cutting blade 60-21C to cut tighter curves and the HS blade 60-21HS for cutting foam filled doors. (Standard blades - Kit #102)

This lightweight, variable-speed pistol-grip shear cuts 14 gauge C.R. mild steel and most grades of stainless to 16 gauge and aluminum to .125. Double-insulated, the 5 AMP KD-440 cuts at over 150 inches per minute, leaving a clean, flat sheet, ready to fabricate. Distortions are absorbed in an easily disposed of waste curl, leaving the sheet cool and free of burn, chips and burrs. The cutting blades are finest high-speed steel, which you can easily replace. (kit #106)

This durable, lightweight shear is designed to make quick work of cement board up to 1/2" thick. Clean cut, with virtually no airborne dust. Variable cutting speeds up to 2500 RPM will match your pace. Reliable, long-lasting A-2 tool steel blades far outlast any other cutting method. Replaced the KD-493.

With a powerful 5 amp motor and speeds up to 2500 strokes per minute, the KD-441 quickly cuts through plastics, wire mesh and rubber with a clean scissors action. When cutting thin coated metals, the swiping cut seals edges and is less likely to rust or corrode. Set the speed of these shears to suit your work.

NEW and IMPOROVED DESIGN over the HN, AN3000 nibbler. The bronze slider has been replaced by a heavy-duty roller bearing. The old bulky cast plunger has been replaced by a lighter yoke. These changes have resulted in smoother operation and better parts life.

The EHN Electric nibbler provides beefed-up cold cutting performance and portability. The 2 horsepower 15 AMP motor cuts C.R. mild steel to 3/16" and most grades of stainless to 10 gauge at a radius of 8".

Start where you please and cut to any desired depth up to 3/8" with 2" diameter blades. Or cut 5/8" deep with 2-1/2" diameter high-speed steel blades. Great for cutting laminate tops for sinks. Change to a 2" diameter metal cutting blade and cut up to 16 gauge C.R. mild steel. The saw head features a compact blade guard that follows a line with ease, cutting within 1/2` of wall or obstruction. The 2500 RPM, 5 amp variable speed motor has plenty of power for any job.

This light duty, 1/4" depth of cut panel saw, equipped with a cast aluminum saw head, lets you cut plastic and other ridged materials up to 1/4", aluminum up to 1/8" and C.R. mild steel to 18 gauge. Lightweight and highly maneuverable, the saw is great for cutting gutters, aluminum siding, autobody panels, sign-making and model shop work. It leaves a milled, ready-to-fabricate finish without burning the metal. The KS-421 has a variable-speed, 2500 RPM, 5 amp electric motor.

Kett 1/4" depth of cut saw head complete with six blades and wrenches for KS-221 and PS-521 saws.