Lancier Monitoring GmbH products

LANCIER Monitoring`s UMS display and evaluation software is the high-end cable and device monitoring solution. It combines the measured data values from all the monitoring stations, sensors and pressurization systems on a single desktop, evaluates them, localises any faults and drafts profiles and measured data graphs.

The Rail-Module-Bus by LANCIER Monitoring is a modular and robust sensor system. Several measuring modules are mounted on a DIN rail and are directly connected to one another by means of plug-in contacts. The RM-Basic module is the core of the new Rail-Module-Bus by LANCIER Monitoring. It takes over the energy supply of the measuring modules, shows the measurements and parameters and transmits the readings to a superordinate control system via one of the integrated interfaces. The RM-Basic module display is also used to set the thresholds of the connected sensors.

All sensor types mentioned below are connectable to the LANCIER Tx-Bus. They are applicable for a wide spectrum of tasks. The LANCIER Tx-Bus is a robust two-wire bus. It only requires a dedicated pair of a copper cable. Up to 127 sensors can be connected to a single pair to transmit their measurement values in assigned time slots. Due to the fact that the power supply is also provided by means of the transmitting pair, an external supply voltage is obsolete. The working distance of the Tx-Bus reaches up to 200 (!) km, depending on the cable type and quality, thus enabling monitoringtasks in even very remote areas of the network. More details about the function of the Tx-Bus and the achievable ranges can be found in the"LANCIER Tx-Bus Engineering information".

The FMA 200C is a highly accurate and reliable instrument to monitor pressurized cables. It may be used as a local measuring device or as an adressable sensor within the LANCIER monitoring system. The airflow measurement ispressure-independent at a range of 0 - 200 l/h. Actual values are shown at the 3 digit LC-display with a resolution of 1 l/h. The FMA 200C signalises the exceeding of programmed thresholds by means of a signal LED and the closing of an alarm relay contact. A built-in key is used to acknowledge the local signal.