MuoviTech AB products

TurboCollector is a patented development of a traditional collector, with significantly better heat transfer characteristics. This is created by a more turbulent flow. Field measurements show that TurboCollector has up to 33% lower bore resistance than equivalent measurements on a smooth collector.

Polyethylene pressure pipes are used for transporting liquids. E.g. Pressurised water, process water, wastewater spills and stormwater.  MuoviTech manufactures only in PE100, a material with better properties than older, developed materials such as PE80.

The internal pipe is made of PE100 according to EN 12201:2003.

DN 650 is made of polyethylene and designed for smaller projects. If necessary, several chambers can be connected in series.

DN 850 is made of polyethylene and designed for medium-sized projects. If necessary, several chambers can be connected in series.

Casing for permanent lining of borehole. The casings must be installed between the ground surface and bedrock to prevent surface water from mixing with groundwater.

Prevents surface water leakage and Artesian water. Hardened composite plastic with synthetic compression rubber and galvanized screws. Available in several dimensions and models. All single- wound collectors (2x) contain an extra hole for the diversion of artesian water, sounding or refilling. The extra hole is opened by turning the rubber seal.

Use a straight electrofusion coupling to splice 2 tubes or fittings.