Ortner Wassertechnik GmbH products

In case of a high variance in the inlet flow and when low amounts of oil can be expected in high flow conditions it is not economical to design the oil separator to the maximum flow condition. In this case an ORTNER  bypass system can be supplied.  Flows up to the design flow of the ORTNER oil separator will be conducted through the separator. Any flow exceeding the design flow will be conducted via a bypass duct directly into the discharge duct of the separator.

In various applications you will find large amounts of oil. In this case you can reduce the cost of maintenance and waste disposal by installing an ORTNER automatic or manual discharge valve. This valve will take off the oil accumulated inside your tank and conduct it to a separate vessel that can be located inside or outside your separator. The oil can be easily removed from this vessel.

Oil accidents can cause enormous damages. Only a few droplets of oil can spoil several thousand liters of drinking water and cause damage to Flora and Fauna.ORTNER Mobile separators can be quickly dispatched tot he site of an accident thereby limiting the damages.

ORTNER grease separators can be produced in a freestanding version or for underground installation. The tight vessel is trapping malodors inside. The level of grease can be easily checked via a glass sight funnel reducing costly maintenance.

ORTNER Oil/Water Separators are required wherever there is a risk of hydrocarbon pollutants causing contamination at the point of discharge, i.e. car parks, motorways, petrol stations, garages, car washes, industrial plants etc. In order to guarantee the proper functioning of the oil separator a slit trap has to be placed either in a separate tank upstream of the separator or below the separator. For dimensioning of the slit trap you need to refer to European Standard EN 858.