SchulzEP products

The station is designed to control the volume of water taken when filling the tanks.

The sampler is designed for the sampling of water (waste water, potable water, industrial, chemical, etc.). This device allows you to check the quality of water flowing in a certain period of time depending on the setting. Sampler taken from the flow of small quantities of water, which stores the one or more bottles. After filling, the bottles are obtained samples taken to the lab for analysis.

Continual WWS is a sampler of the new generation, which extends its principle, and today far surpasses the commonly used principles for sampling water. Sampler takes samples of water in minimal time lag of two samples per second. This spacing is extended depending on the flow rate and the length of the sampling. Due to the high sampling frequency allows the collection of a representative sample of maximum.

This model controller module itself sampler pump. A0 sampler is designed for installation in existing samplers, portable and stationary. It is a fully functional module samplers, including an external power supply and battery. factories and the like.

This portable sampler is designed for both routine sampling and sampling relief objects. Sampler meets the requirements for sampling relief objects that are specified in the document of the Ministry of the Environment Article: Communication Water Protection Department Ministry of the Environment to change § 8 and § 38 of Act no. 254/2001 Coll., On waters and amending some laws (the Water Act) , as amended, resulting from the entry into force of law no. 113/2018 Coll.

Stationary samplers are metal casing with a thermal insulation for tempering the samples at 4 ° C, are supplied from the power distribution. They are mainly used to control the water in sewage treatment plants, to discharges of wastewater into rivers ...

Extending surcharge: sampler SVP 23 SPOV automatic rinsing and hose inside diameter of 19 mm outside design - the protective casing, a heating isolation pH and water temperature measurements of electrical conductivity of the water a second communication port RS485 external contactless card reader for controlling gateways (price on request) printer delivery leaves the editor in a protective cabinet (like in parking)

Stationary Sampler vacuum JHA 23 SPOV This sampler is specially designed for easy sampling of imported water from stations SPOV. The control unit of the sampler is directly connected to the control station computer SPOV from sampler which receives control instructions for sampling. The cleaning cycle of the sampler is provided, the automatic rinsing with pure water while mixing with compressed air. This cleaning cycle ensures a maximum possible automatic cleaning of all sampling tract after each sampling of imported water. We are preparing a short film with a demonstration of cleaning.  

Stations for the acceptance of waste water SPOV S1 station SPOV S1 is easier cheaper option SPOV4 station. This station is primarily intended for smaller wastewater which allows registration of an imported amount of wastewater. The station is equipped as standard with an anti-flow empty pipe and gate valve. The station can also be equipped with probes for measuring the pH and conductivity with the possibility of closing the discharge conduit when the pre-set parameters, pH and conductivity. Identifying the importer is solved by a key switch, each driver must be unlocked prior to the discharge station of his key which opens the discharge pipe, and activates its counter imported amount of wastewater. The station is equipped with standard 5-identification keys, this number can be extended to 20th