Z.E.T. Industries products

The valve is made of monolithic cast iron and is intended for installation in places where a fire truck can not enter and in any case use the transition to "2" at the output of the hydride, the heads are cast iron and the stainless steel hinges are not raised.

Dual hydrant Introduction "4 and two outputs" 3 Model ZF-59. The valve is made of monolithic casting (single unit) with the same internal structure as ZF-33 hydrides.

Dual Hydrant Introduction "6 and Two Outputs" 3 Model ZF-60. The valve is made of monolithic casting (single unit) with the same internal structure as ZF-33 hydrides.

Structure: Stainless steel frame for fixing, with stainless steel rails. Stainless steel gate with reinforcement ribs that are connected with copper alloy sliding strips and type j type neoprene gaskets The gate can be retrieved without descending to the channel, operated by conical, gated and sealed bearings without the need for continuous treatment with a raised shaft and attached to the frame.

Closed round wall closure - A circular opening closure with skid tracks, model ZWP-CS. Structure: 316 stainless steel base with an integral sealing bracket (not a ring connected to the base but one part), with 316 stainless steel rails.
The closure plate is made of 316 stainless steel with sliding strips that move inside the stainless steel rails, so that the board tightens to the base only in the final section of the move, and apart from this section there is no contact between the closure and the surface. Removable brakes will be installed in the tracks to prevent the closure plate from being pulled. In the quarantine plate there is a vulcanized seal that ensures complete sealing of positive pressure and negative pressure up to a 40 meter water column.

Square Wall Closure - Closure for square opening with ZWP-SS skid strips. Structure: Stainless steel rails that are attached to a drilled stainless steel frame, suitable for installation by screws or concrete settling. Reinforced stainless steel gate to which is attached a J-TYPE double neoprene seal system.

Description: A ZTM-A telescopic level meter is used to determine the level of the flow in the reservoirs and the droplets by changing the height of the surf. Dimensions: according to customer`s request.

Stone Trap "2-" 28 Model ZT-330. The stone trap is designed for rough filtration according to the customer`s request (starting from 2.5 millimeters). The structure of the trap distinguishes it from diagonal filters in a number of features: Zero-standing losses. The filtration is carried out by a massive stainless steel mesh that is resistant to pressure without risk of splitting even in the case of blockage. The filter lining eliminates the turbulent flow and releases the trapped air, at the top of the trap there is an opening to install an air release valve. At the bottom of the trap there is a large opening washing waste collection chamber without the need for dismantling the trap.