7. Liquids_SAA_19.1.6

? Two different models for sampling fixed volumes of 3 cc or 8 cc per sample cycle? Can handle line pressures from vacuum up to 200 psi (13.8 bar) in most applications? Rugged 316 stainless steel construction? Batch or composite samplingThe ISOLOK® SAA provides accurate samples of liquids and slurries such as waste acid, resin bead slurry, bauxite mud and raw municipal sludge.The ISOLOK® SAA operates when compressed air forces the plunger into the process line to capture a fixed volume of material. Compressed air then acts on the opposite side of the piston to retract the plunger to a position which allows the sample to drop by gravity into a container.The operator is isolated from the process at all times by the sampler's seal design, and the sample captured in the container is "locked out" from external influences.Metal parts are made of 316 stainless steel; other alloys are available. Process contact seals are filled-Teflon® for chemical applications or wear-resistant elastomers for abrasive slurries. Modular components allow selection of various bodies and plungers to meet the process application.www.sentry-equip.com 19.1.6 Rev. 6 08/12 ISOLOK ® series sAA sAmplerAutomatic samplerAutomatic Sampler for Liquids and SlurriesISOLOK® series sAADescriptionFeatures? Port closures? Line adapters? Several types of containers? Sampler enclosures (with or without heater)? Sample heating or refrigeration? Optional materials of construction and seal choicesOptionsSample Volume per Cycle 3 cc or 8 cc Maximum Particle Size 3 mm (3 cc) or 7 mm (8 cc)Basic Electrical Requirements (with Sentry controller) 115 VAC, single phase, 50/60 Hz Line Mounting Options MNPS thread, tri-clamp, instrument hub, ANSI flangeCompressed Air Requirements 2 SCFM @ 90 psi (.05 m³/min @ 6.2 bar) Materials of Construction 316 stainless steel; other materials availablePlunger Seals TFE, polyurethane, EPDM rubber, Kalrez® or customCylinder Seals Halar®, TFE, or customNet Weight, not including controller or accessories 8–10 lb (3.5–4.5 kg)SPECIFICATIONSPlunger extended;process isolated Plunger retracted;sample isolated and lockedSAmPlINg PrOCESS© Sentry Equipment Corp 2006 19.1.6 Rev. 6 08/12ISOLOK® SAA TECHNICAl DATAFor further information, contact:It is solely the responsibility of the end-user, through its own analysis and testing, to select products and materials suitable for their specific application requirements, ensure they are properly installed, safely applied, properly maintained, and limit their use to their intended purpose. Improper selection, installation, or use may result in personal injury or property damage.SENTRY EQUIPMENT CORP 966 Blue Ribbon Circle NorthOconomowoc, WI 53066 USATel: 262-567-7256 • Fax: 262-567-4523E-mail:sales@sentry-equip.comWebsite:www.sentry-equip.comEuropean Authorized Rep:OBELISBd. General Wahis 53-1030Brussels Belgium II 2GD TXKalrez is a registered trademark of E. I. Du Pont de Nemours and Company.Halar is a registered trademark of Ausimont, U.S.A. Inc.