AmSolv - Model 9350 - Industrial Water Treatment Compound & Recirculating Water System Cleaner Brochure

100 West Sterrett Road, Waxahachie, Texas 75165 Phone: (972) 938-1401 Fax: (972) 938-1405 © 2005 AmSolv Holding Company - AmSolv® is a registered trademark of AmSolv Holding Company www.AmSolv.com AmSolv® 9350 Industrial Water Treatment Compound Recirculating Water System Cleaner Scale & Corrosion Remover, Dispersant and Inhibitor DESCRIPTION: AmSolv® 9350 is a concentrated alkaline, triple purpose product. It gently and effectively removes, disperses and prevents accumulations of scale, corrosion, and organic matter. It does this in a wide range of open and closed recirculating cooling and heating water systems. ADVANTAGES: AmSolv® 9350 is the product of choice for “on line” and new installation clean up jobs. Properly applied and controlled, it will solubilize and disperse oil, grease, mill scale, rust, mineral scale, mud and organics that foul new and old piping systems. AmSolv® 9350 is a noncorrosive product that will passivate and protect system metals from corrosion. In old and heavily fouled systems, deposits are not removed so rapidly that plugging occurs. In these systems clean up time can range from weeks for closed loop systems to several months for heavily scaled cooling towers. AmSolv® 9350 contains no acids or heavy metals. DIRECTIONS: NOTE: When using this product, PROTECT FACE (especially the eyes) by using a full face shield or cup-type chemical goggles, AND other portions of the body by using rubber gloves, rubber boots, and a rubber apron. Use only in a well ventilated area. Avoid breathing spray mists or vapors. AmSolv® 9350 is slug dosed to the fouled old or newly constructed system at 2 gallons per 1,000 gallons of system water (2,000 ppm) for “on line” cleanup. Systems should be placed into normal operation or circulation for the cleanup period. Closed loop systems should be checked weekly. Flush system with “on line” bleed when the water becomes saturated with contaminants. Repeat this procedure until system water remains clean for one week of system operation with AmSolv® 9350 applied. Cooling towers should be drained and flushed after recirculation as visual inspection dictates. Bleed should be reopened after the first few days of system recirculation. Thereafter, continuous injection or regular slug additions must be made for as long as several months to clean scaled systems. Periodic flushing of the system to remove sludge and loosened contamination will be necessary. WARNING: Contains potassium hydroxide. Eye and skin irritant. Avoid contact with skin and eyes. If eye contact occurs, flush with water for 15 minutes. Get prompt medical attention. If skin contact occurs, remove contaminated clothing. Flush with warm water. If irritation persists, consult a physician. Do not take internally. If swallowed, drink large quantities of water. Do not induce vomiting. Contact physician immediately. KEEP OUT OF REACH OF CHILDREN. CONTAINER DISPOSAL: Triple rinse container and discard according to local regulations. CAS NUMBERS: Water 7732-18-5; Potassium hydroxide 1310-58-3; Alkyl amphopropionate 70983-43-6; Hydroxyethylidenediphosphonic acid 2809-21-4; Sodium Tolyltriazole Solution 64665-57-2. HMIS RATING: Health-2; Flammability-0; Reactivity-0; Personal Protection-B. DOT: CORROSIVE LIQUID, BASIC, INORGANIC, N.O.S., 8, UN3266, III (contains potassium hydroxide) WC9350 050705