CM 210S

Operating weight21 - 22 Tonsengine pOwer140 kW (189 CV)CM 210 SVia Padana Superiore, 1 | 25046 Cazzago San Martino (BS) | ITALIATel. +39 030 725012 r.a. | Fax +39 030 7254518info@officineminelli.it | www.officineminelli.itWWW.IDEAgency.itCM 210 SteChniCaL DataStabilised machine load capacity (kN)CM 210 SOperating areaCM 210 SOFFiCine MineLLi s.r.l.ENGINEMax power 140 Kw (189 CV) @2300rpmCylinders 6 cylinders in linePower supply Direct injection turbo diesel with intercoolerIntake Two stage air filterEmissions In line with EC 97/68 phase 3EPA NON-ROAD Tier IIINoise level (EC 2000/14 directive)LwA = 103 dBHYDRAULIC SYSTEMHydraulic pump Microprocessor controlled Linde with variable flow rate and axial pistonsMax flow rate 310 l/minDistributor Linde LS single block proportional 6 component distributorOperating pressure 330 barsOperation Linde Load Sensing operating systemSynchron control for synchronised movements without reciprocal influence Special turret rotation motor with independent torque controlElectronic control systemElectronic accelerator, movement speed regulator and auto-idleTURRET ROTATIONHydraulic motor Axial piston with LS control section and integrated valvesRotation speed 0-8 rpm, progressive start-up and controlled brakingReduction Two stage reduction gear group with tempered gearsRail bearing Rail A bearing with steel alloy internal teeth, diameter 1200 mmTRANSMISSIONHydraulic motor Axial piston with variable flow rate (max flow rate 180 l/min)Transverse movement speed0-6 km/h in 1st gear,0-18 km/h in 2nd gearGearbox Two speed, electric drive manual gearboxAssali Static 28 ton capacity axles with epicyclical reducer gears in the hubs. Oscillating front axle with electrical locking systemWheels 8 wheels with super elastic “Loader” tyres, 10.00x20 on 8.0” HD rimsARMSTotal span 8200 mmOperating range 9100 mmArm I° 4900 mm, two cylinder driveArm II° With hydraulic extension(2150 to 3150 mm)Officine Minelli reserves the right to make any changes it considers appropriate for the improved running of the machine without notice. The information is subject to modification without notice.STANDARD SERIES EqUIPMENT• Vertical lifting cabin (max height 4.50 m), roll bar grille, spotlights and parasol canopy• Air conditioning unit with intake micro-filter • Centralised manual greasing unit• Low maintenance broad mesh heat exchangers• Front-mounted hydraulic blade with two cylinders• Hydraulic rear legs• Dual tractionOPTIONAL EqUIPMENT• Pantograph cabin lift (max height 5.40 m)• Radio with MP3 player, seat with pneumatic suspension• Automatic greasing unit for turret and arms• Vortex intake pre-filter• Rubber spacer rings between the wheels• Electromagnet system and plate• Various tools available in line with requirements