GDS - C483c - 20 Way Status Alarm 3 - Datasheet

sPeCIFICatIONPower supply 230/110V AC and/or 24V DC Power consumption max 15 Watts Indicators:alarms (20 off) Red LED's Conditions: Alarm mode - FlashingAccept mode - Constant Fault alarm Amber LEDPower Green/Red LED Conditions: Mains On – Green StateMains Fail – Red State(battery back-up mode) system test Stage 1 Alarm LED's - ON Stage 2 Alarm relays - ON Outputs Alarm Relays 4 sets S.P.C.O.(Rating 5A 230vAC) Latched until alarm reset(option - not resettable until signal has cleared – factory setting) Fault Relay - Selectable Mains Fail Relay - Set S.P.C.O Rating 5A 230v AC audible alarm Conditions: - Gas / Fault Alarm (permanent mute option)Inputs +24V DC @ 5mA Alarm - field contacts, closing for alarmFault “ “ “ Option at manufacture Alarm field contacts opening for+24V maintained alarm (loop failure monitored) connect jumper JP1-JP20 for unused inputs Miscellaneous Enclosure Wall mount - steel enclosure IP52314W 264H 55DCable entry Base or rear Field terminals 2.5mm Remote reset 2 wire - N/O Remote sounder 2 wire - 24v DC Options Channel Alarm Relays Add on board – 1 relay per channel(20) ND-D.P.C.O rating 5A 230v ACTECHNOLOGIES LTDThis document is non contractual and the equipment specification and detail may be modified at any time without prior notice.20 Waystatus alarm 3 specification sheetref C483CC939ISO 9001GDs technologies LtdFusion PointAsh Lane, GarforthLeeds UK LS25 2GATel +44 (0)113 286 0166Fax +44 (0)113 287 8178www.gds-technologies.co.ukFeaturessYsteM FuNCtION: When any alarm input circuitreceives a signal, the appropriate alarm LED will flash withthe sounder and alarm relays turning ON. Pressing thereset switch will mute the sounder, and turn the red flashingalarm LED on constant, the relays will reset (option - nonresettable relays). When the alarm signal has clearedpressing the reset switch will clear the alarm LED.sYsteM test: Pressing the reset pad for 15 seconds willturn all the alarm indicators on (stage 1), maintaining thereset pad on for a further 15 seconds will activate alarmrelays and corresponding remote indicators (stage 2). INDICatOr PCbOPtIONaL reLaY bOarD