GPS - FAA Type L-864 - Led Red Beacon with Monitoring Datasheet

3195 Vickery Rd. North Syracuse NY 13212 | (315) 699 4400 | Unimar.comUSL_GPS_Beacon_40X_gen5191213The Unimar GPS controlled beacon provides synchronized ? ashing of multiple units in wind farms and other applications. The Unimar GPS controlled beacon not only provides the synchronized ? ashing function but also the following alarm monitoring with LED status indicators: Beacon failure Loss of GPS pulse signal Photocell failure Loss of powerThe monitoring, ? ashing, synchronization and alarm functions are integrated into one solid state module. This module is mounted in the base of the beacon, protecting the device from heat, sun and UV rays. With a good GPS signal, beacon synchronization is maintained whenever power is applied to the controller. The output to the LED beacon is controlled by the internal Photo-Control.Additional features include GPS signal monitoring, an option switch for selectable ? ashrate and option switch for photocell monitoring. application GeneralCerti? ed to: FAA AC No. 150/5345-43FFAA Engineering Brief No. 67Intertek ETLNOte: Our L864 LED Beacon provides the most focused beam meeting FAA requirements.The LED Beacon with GPS technology, when utilized with multiple SFM’s (Synchronized Flashing Modules), provides the synchronized ? ashing function (proper sequence of ON / OFF time) for multiple LED beacons or LED obstruction lights. Power Source: 120-240 VAC, 50/60 Hz; Switch SelectableFlash rate: 30, 40 or 60 (± 1%) ? ashes per minute (switch selectable); (½ ON and ½ OFF)Power Consumption: 20 WattsOperating temp: -40° F to +131° F (-40° C to +55° C)USL 40X GPS Beacon with Synchronized Flasher Module System SpecificationsCompliant to: ICAO Annex 14, 4th Ed., July 2004ICAO Aerodromes Design Manual, Chapter 183195 Vickery Rd. North Syracuse NY 13212 | (315) 699 4400 | Unimar.comUSL_GPS_Beacon_40X_gen5191213USL 40X GPS Beacon with Synchronized Flasher Module Ordering InformationSystem Part Number Description VoltageUSL40X Beacon with Integrated GPS; Monitoring 120-240 VAC; 50/60 Hz Installation and Connection to Power Source1. Run power/alarm cable directly to beacon.2. Make power and alarm connections. (See wiring diagram.)3. Ensure beacon base is grounded to structure. BeaCON WarraNty: Limited 5 year warranty5 conductor wiring availableMiniature 3V GPS AntennaCompact GPS Antenna with magnetic mounting - Installed within the beacon.Monitoring, Alarm & GPS ModuleConsists of solid-state components conformal coated to protect against shock, vibration and humidity - Installed within the beacon. Integrated Beacon Components